Alliance Laundry Systems LTU87AH, LTZ89AH, LTS87AH, LTZ87AH, LTS89AH User Manual

...

Frontload

Washers

Models LTS87A*H, LTS89A*H,

LTU87A*H, LTU89A*H, LTZ87A*H and

LTZ89A*H

Operating Instructions

www.comlaundry.com

Part No. 800939

March 2001

Operating Instructions

To reduce the risk of fire, electric shock, serious injury or death to persons, read the IMPORTANT SAFETY INSTRUCTIONS in the Use and Care Guide before operating your washer.

W018E

WARNING

NOTE: Always follow manufacturer’s care labels.

Determine Proper Cycle

REGULAR Cycle

Use for sturdy items, like play or work clothes, towels, T-shirts, etc. The wash selection will depend on the type of fabric and the amount of soil. There are three settings in the REGULAR cycle – HEAVY, NORMAL and LIGHT.

PERMANENT PRESS Cycle

SWD460N

To Wash Clo the s

IMPORTANT: Before using your new washer, make sure the washer cord is plugged into a 120 Volt electrical outlet that has the proper grounding and polarity. Make sure the washer hoses are connected to the hot and cold water faucets, and that the faucets are turned on. Be sure the drain hose is not kinked and is inserted into a drain. Refer to the INSTALLATION INSTRUCTIONS for details of proper washer installation.

IMPORTANT: Prior to first wash, use an allpurpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside of washtub.

1. Get the clothes ready for washing. Empty pockets and cuffs. Sort items into separate loads. Pretreat stains and heavily soiled areas.

Use for permanent press items and synthetics. The wash selection will depend upon the type of fabric and amount of soil. There are two settings in the PERMANENT PRESS cycle – NORMAL and LIGHT.

DELICATE Cycle

Wash delicate items usually washed before by hand on this cycle. There are two settings in the DELICATE cycle – NORMAL and LIGHT.

800939

D305I

2. Measure and add low sudsing detergent, fabric

softener, and bleach to the dispenser drawer. Refer to section on Using Your Dispenser Drawer.

SWD461N

IMPORTANT: If using detergents made for topload washers, avoid oversudsing by using only 1/4 cup regular detergent (1/2 of the recommended amount).

3. Load clothes into wash drum. Refer to section on

Load Sizes in your Use and Care Guide.

WARNING

To reduce the risk of serious injury, do not by-pass the loading door switch by permitting the washer to tumble or spin with the loading door open.

W095

5. Set WASH/RINSE temperatures.

SWD464N

There are four WASH/RINSE temperatures available – Hot Wash/Cold Rinse, Warm Wash/Cold Rinse, Warm Wash/Warm Rinse, and Cold Wash/Cold Rinse.

Refer to the Available Water Temperatures section for the temperature that works best for your garments.

SWD462N

4. Close the loading door tightly. The washer will not operate with the loading door open.

SWD463N

WARNING

Window may be hot in the Hot Wash Cycle.

W326E

6. Select the cycle according to the type of fabric being washed. Push the timer knob in and turn clockwise to the desired cycle and wash time. Use the indicator dot on the knob as a guide.

SWD465N

800939

7. Pull the timer knob out to start the washer. The DOOR LOCKED light will come on after a short delay, water fill will begin, and wash drum will begin tumbling.

NOTE: Washer door MUST be closed tightly to start washer.

If items need to be added or removed after a cycle has started, push the timer knob in, wait approximately 45 seconds for DOOR LOCKED light to go out, open door, add or remove items, adjust the timer knob (if desired) and pull timer knob out.

There is no agitator on this washer. Instead, the clothing gently tumbles through the water. The wash action consists of a period of tumbling in one direction, a brief pause, and then a reverse tumble in the opposite direction. The pauses are part of the tumble action and add to the uniqueness of the washer. Do not attempt to turn the timer through these pauses. They are part of the cycle.

Timer

Although the washer cycles are automatic, the timer may be reset to lengthen, shorten or repeat a portion of a cycle.

DOOR LOCKED Light

When the washer is started, the DOOR LOCKED light will come on after a short delay. The light will turn off 10 to 30 seconds after the cycle is complete.

Out of Balance Load

If at the end of the cycle, the load is dripping wet, the washer has limited the spin speed. This is to prevent damage to the unit if there is a severely unbalanced load.

If this condition occurs, redistribute the load manually and repeat the cycle beginning at the last rinse.

If the condition persists, consider steps discussed in the Before Washing section of the Use and Care Guide.

To set or reset the timer, push timer knob in to stop the washer. Hold timer knob in firmly while slowly turning it clockwise to the setting desired. Pull timer knob out to start the washer.

800939

+ 11 hidden pages