Allen & Heath M-DL-ADAPT-A User Manual

M-DL-ADAPT fitting note

1

AP10272 Issue 1

Control Network

Secondary

ALLEN

Primary

Lnk/ActLnk/Act

GigE

Lnk/Act

HEATH

&

2

3 2 3

M-DL-ADAPT fitting note

The M-DL-ADAPT ‘letter-box’ adapter can be fitted to any dLive I/O Port to enable
the use of iLive / GLD option cards (M-Dante, M-Waves, M-ES-V2, M-ACE, M­MADI). It provides a 64x64ch 48kHz interface with built-in Sample Rate
Conversion.

Fitting the adapter

1. Switch the system off.

2. Remove the 4 screws securing the I/O Port blank panel on the dLive

MixRack or Surface. Use a star Torx T8 screwdriver.

3. Slide the adapter into the slot and press it firmly into the mating

connector.

4. Secure the adapter by tightening the 4 thumb screws.

Fitting the option card

1. Switch the system off.

2. Remove the 2 screws securing the blank panel over the adapter

‘letter-box’ slot using a star Torx T8 screwdriver.

3. Slide the option card into the slot and press it firmly into the mating

connector.

4. Secure the card using the 2 screws.

M-DL-ADAPT fitting note

2

AP10272 Issue 1

ALLEN&HEATH

Setting clock and patching signals

Use the I/O screen to patch signals from or to the I/O Ports.

Use the MixRack / Audio / Audio Sync screen to select the clock source. Set
this to Internal on the master system, or to the relevant I/O Port on all other
networked systems.

The functions of the adapter and option cards are determined by the firmware
(operating software) that the dLive system runs. Firmware is updated regularly
as new features are added and improvements made.

 Check www.allen-heath.com for the latest version of dLive

firmware.

For more information on setup and functions please refer to the dLive Firmware
Reference Guide available for download at www.allen-heath.com.

A limited one year manufacturer’s warranty applies to this product, the conditions
of which can be found at: www.allen-heath.com/legal.

This product complies with the European Electromagnetic
Compatibility directive 2004/108/EC and the European Low Voltage
directive 2006/95/EC.

Any changes or modifications to the product not approved by Allen & Heath
could void the compliance of the product and therefore the user’s authority to
operate it.

Allen & Heath Limited, Kernick Industrial Estate, Penryn, Cornwall, TR10 9LU, UK

Copyright © 2015 Allen & Heath. All rights reserved.

http://www.allen-heath.com