Allegro ULQ2004L, ULQ2004A, ULQ2003L, ULQ2024L, ULQ2024A Datasheet

...
2003
THRU
Data Sheet
29304F
2024
HIGH-VOLTAGE, HIGH-CURRENT
DARLINGTON ARRAYS
Ideally suited for interfacing between low-level logic circuitry and
1
2
3
4
5
16
15
14
13
12
high-current Darlington arrays feature continuous load current ratings to 500 mA for each of the seven drivers. At an appropriate duty cycle depending on ambient temperature and number of drivers turned ON simultaneously, typical power loads totaling over 230 W (350 mA x 7, 95 V) can be controlled. Typical loads include relays, solenoids, stepping motors, magnetic print hammers, multiplexed LED and incandescent displays, and heaters. All devices feature open-collector outputs with integral clamp diodes.
611
710
89
Dwg. No. A-9594
Note that the ULN20xxA series (dual in-line package) and ULN20xxL series (small-outline IC package) are electrically identical and share a common terminal number assignment.
ABSOLUTE MAXIMUM RATINGS
Output Voltage, V
(ULN200xA and ULN200xL) ........ 50 V
(ULN202xA and ULN202xL) ........ 95 V
Input Voltage, VIN................................ 30 V
Continuous Output Current,
IC................................................. 500 mA
Continuous Input Current, IIN........... 25 mA
Power Dissipation, P
(one Darlington pair)..................... 1.0 W
(total package) ....................... See Graph
Operating Temperature Range,
TA.................................. -20°C to +85°C
Storage Temperature Range,
TS................................. -55°C to +150°C
CE
D
The ULN2003A/L and ULN2023A/L have series input resistors selected for operation directly with 5 V TTL or CMOS. These devices will handle numerous interface needs — particularly those beyond the capabilities of standard logic buffers.
The ULN2004A/L and ULN2024A/L have series input resistors for operation directly from 6 to 15 V CMOS or PMOS logic outputs.
The ULN2003A/L and ULN2004A/L are the standard Darlington arrays. The outputs are capable of sinking 500 mA and will withstand at least 50 V in the OFF state. Outputs may be paralleled for higher load current capability. The ULN2023A/L and ULN2024A/L will withstand 95 V in the OFF state.
These Darlington arrays are furnished in 16-pin dual in-line plastic packages (suffix “A”) and 16-lead surface-mountable SOICs (suffix “L”). All devices are pinned with outputs opposite inputs to facilitate ease of circuit board layout. All devices are rated for operation over the temperature range of -20°C to +85°C. Most (see matrix, next page) are also available for operation to -40°C; to order, change the prefix from “ULN” to “ULQ”.
FEATURES
TTL, DTL, PMOS, or CMOS-Compatible Inputs
Output Current to 500 mA
Output Voltage to 95 V
Transient-Protected Outputs
Dual In-Line Plastic Package or Small-Outline IC Package
x = digit to identify specific device. Characteristic shown applies to family of devices with remaining digits as shown. See matrix on next page.
2003 THRU 2024
HIGH-VOLTAGE, HIGH-CURRENT DARLINGTON ARRAYS
DEVICE PART NUMBER DESIGNATION
PARTIAL SCHEMATICS
ULN20x3A/L (Each Driver)
2.7K
3K
7.2K
COM
V
CE(MAX)
I
C(MAX)
50 V 95 V
500 mA 500 mA
Logic Part Number
5V ULN2003A* ULN2023A*
TTL, CMOS ULN2003L* ULN2023L
6-15 V ULN2004A* ULN2024A
CMOS, PMOS ULN2004L* ULN2024L
*Also available for operation between -40°C and +85°C. To order, change
prefix from “ULN” to “ULQ”.
2.5
2.0
ULN20x4A/L (Each Driver)
10.5K
3K
7.2K
Dwg. No. A-9651
COM
Dwg. No. A-9898A
SUFFIX 'A', R = 60°C/W
1.5
1.0
0.5
0
25
ALLOWABLE PACKAGE POWER DISSIPATION IN WATTS
SUFFIX 'L', R = 90°C/W
50 75 100 125 150
AMBIENT TEMPERATURE IN °C
θJA
θJA
Dwg. GP-006A
X = Digit to identify specific device. Specification shown applies to family of devices with remaining digits as shown. See matrix above.
115 Northeast Cutoff, Box 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000
Copyright © 1974, 1998 Allegro MicroSystems, Inc.
2003 THRU 2024
HIGH-VOLTAGE,
HIGH-CURRENT
DARLINGTON ARRAYS
Types ULN2003A, ULN2003L, ULN2004A, and ULN2004L ELECTRICAL CHARACTERISTICS at +25°C (unless otherwise noted).
Test Applicable Limits
Characteristic Symbol Fig. Devices Test Conditions Min. Typ. Max. Units
Output Leakage Current I
Collector-Emitter V Saturation Voltage
Input Current I
Input Voltage V
Input Capacitance C
Turn-On Delay t
Turn-Off Delay t
Clamp Diode I Leakage Current
Clamp Diode V Forward Voltage
CE(SAT)
IN(ON)
I
IN(OFF)
IN(ON)
CEX
IN
PLH
PHL
R
F
1A All VCE = 50 V, TA = 25°C < 1 50 µA
VCE = 50 V, TA = 70°C < 1 100 µA
1B ULN2004A/L VCE = 50 V, TA = 70°C, VIN = 1.0 V < 5 500 µA
2AllI
3 ULN2003A/L VIN = 3.85 V 0.93 1.35 mA
ULN2004A/L VIN = 5.0 V 0.35 0.5 mA
4Alll
5 ULN2003A/L VCE = 2.0 V, lC = 200 mA 2.4 V
ULN2004A/L VCE = 2.0 V, lC = 125 mA 5.0 V
—All 1525pF
8 All 0.5 EIN to 0.5 E
8 All 0.5 EIN to 0.5 E
6AllV
7AllI
= 100 mA, IB = 250 µA 0.9 1.1 V
C
l
= 200 mA, IB = 350 µA 1.1 1.3 V
C
IC = 350 mA, IB = 500 µA 1.3 1.6 V
V
= 12 V 1.0 1.45 mA
IN
= 500 µA, TA = 70°C5065µA
C
VCE = 2.0 V, IC = 250 mA 2.7 V
VCE = 2.0 V, lC = 300 mA 3.0 V
VCE = 2.0 V, lC = 200 mA 6.0 V
VCE = 2.0 V, IC = 275 mA 7.0 V
VCE = 2.0 V, l
= 50 V, TA = 25°C—50µA
R
VR = 50 V, TA = 70°C 100 µA
= 350 mA 1.7 2.0 V
F
= 350 mA 8.0 V
C
OUT
OUT
0.25 1.0 µs
0.25 1.0 µs
Complete part number includes suffix to identify package style: A = DIP, L = SOIC.
www.allegromicro.com
Loading...
+ 7 hidden pages