Allegri 021021018FR001, 021021010FR001 User Manual

021021-010-FR001

Customer Service: [phone], [phone], [e-mail]
WARNING - TO REDUCE THE RISK OF FIRE OR INJURY:

1.lf you are unfamiliar with electrical wiring, call a qualified electrician to install this unit. More than
one person may be necessary to install fixture, make sure you have enough qualified help.

2.Turn off the power to the fixture's circuit at the service panel. Use a voltage detector to verify
the power is off.

3.DO NOT install bulb which exceeds the maximum wattage specified on the socket label.

FRAME INS TALLATIO N :

wall

1-Outlet Box

NOTE: Carefully unpack frame and crystals
and lay them down on a clean softh cloth for
identification.

Step 1. Screw Crossbar 2 to outlet box 1 with
original outlet box screws 4. Make sure
crossbar studs 3 are pointing away from wall.

Step 2. Get frame a few inches close to

wall and connect wires: Connect fixture
ribbed wire (L) to power supply black wire.
Connect fixture smooth wire (N) to power
supply white wire. Connect fixture silver or
copper bare wire (G) to power supply
green wire.

Step 3. Align fixture back plate holes to
crossbar studs 3 and fix it flat to wall,
secure fixture with decorative nuts 5, then

Install light bulbs.

2-Cross Bar
3-Cross bar stud s x 2

4-Scre ws for out let box

Light Bulbs (not provided)

Frame chrome

L
N

G

5-Decorative Nuts

(Krypton 40w max bulbs are recommended)

Proceed to install crystal set; follow
directions on pages 2 and 3 .

P1

021021-010-FR001

Customer Service: [phone], [phone], [e-mail]

CRYSTAL SET INSTRUCTIONS:

Step 1. Carefully unwrap all crystal
components and lay them down on a clean
softh cloth for identification.

Step 2. Use inspection gloves (provided) to
handle all crystal parts to avoid finger
prints marks.

Step 3. Install 3 crystals (A) and 4 crystals
(B) Use Top View crystal diagram (below)
as a reference for correct pattern.
Secure crystals with decorative nuts 6
attached on ring.

B

A

6

C

D

Step 4. Install 16 crystals (D) start from
bottom center ball head screw with hole

7. Then 3 rings going up.

Step5. Install 8 crystals (C1) and 9 (C2)
to Top Ring; alternate them as shown in
Top View Crystal pattern below.

Turn Lights ON.

B

C2

7

C1

C2

B

C1

C2

C1

B

(All holes are for

Crystal strand D)

C2

C1

D

B

C1

C2

C1

B

Top View Crystal Pattern

B

C2

C1

C2

B

C1

C2

P2