Allegri 021020018FR001, 021020010FR001 User Manual
021020-010-FR001
Customer Service: (702)361-4345, (800)525-2655, customer.service@kalco.com
WARNING - TO REDUCE THE RISK OF FIRE OR INJURY:
1. lf you are unfamiliar with electrical wiring, call a qualified electrician to install this unit .More than
one person may be necessary to install fixture, make sure you have enough qualified help.
2. Turn off the power to the fixture's circuit at the service panel. Use a voltage detector to verify that
the power is off.
3. DO NOT install bulb which exceeds the maximum wattage specified on the socket label.
FRAME INSTALLATION:
2-Fixture frame
NOTE: Carefully unpack frame and crystals
and lay them down on a clean softh cloth for
identification.
Step 1. Fix fixture crossbar 3 to outlet box 1
with original outlet box screws. Mark top and
bottom cross bar slots in the wall, remove
crossbar then install anchor screws in the
wall.
3-Cross Bar with studs
4-Decorative Nuts
5-Anchor Screws
Step 2. Screw Crossbar 3 to outlet box 1 with
original outlet box screws. Make sure
crossbar studs are pointing away from wall.
Reinforce cross bar with top and bottom
anchor screws 5.
Step 3. Get fixture frame a few inches
close to wall and connect wires: Connect
fixture ribbed wire (L) to power supply
black wire. Connect fixture smooth wire
(N) to power supply white wire. Connect
fixture silver or copper bare wire (G) to
power supply green wire.
Step 4. Align fixture back plate holes to
crossbar studs 3 and fix it flat to wall,
secure fixture with decorative nuts 4, then
Install light bulbs.
(Krypton 40w bulbs are recommended)
Proceed to install crystal set; follow
directions on pages 2 and 3 .
bulbs 40w max
L
N
G
6-Bottom center Finial
1-Outlet Box
P1
021020-010-FR001
Customer Service: (702) 361-4345, (800) 525-2655, customer.service@kalco.com
CRYSTAL SET INSTRUCTIONS:
Step 1. Carefully unwrap all crystal components and lay them down
on a clean softh cloth for identification.
Use inspection gloves (provided) to handle all crystal parts to avoid
finger prints marks.
Step 2. Install 9 crystal strands (C) with smaller crystals to the top
ring.
Step 3. Use Top View crystal diagram (below) to install 6 crystals
(A) and 7 crystals (B) to top of fixture.
Step 4. Install 16 crystals (G) start from bottom center finial 6. Then
3 rings going up.
Code
A
Quantity
A 6
B 7
C 9
D 3
E 4
F1 8
F2 9
G 16
Step5. Install 8 (F1) and 9 (F2) on fourth ring alternated (see Bottom
crystal pattern diagram below)
6-Install Crystals (D) and (E) alternated as shown in diagram below,
secure them with decorative nuts attached in frame.
B
A
B
A
B
A
B
B
A
B
A
B
A
Top View, Top Crystal Pattern
(All holes are for
Crystal strand
(C)
(All holes are for
Crystal strand
(G)
B
C
E
D
D,E
F1
F2
G
E
F2
F1
F2
D
F1
F2
F1
E
F2
F1
D
F2
F1
F2
E
F1
F2
F1
Top View of bottom Crystal Pattern
E
F2
F1
F2
D
P2
Loading...