Allegri 020520010FR001 User Manual
020520-010-FR001 2-Light wall lamp
Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com
WARNING - TO REDUCE THE RISK OF FIRE OR INJURY:
1.lf you are unfamiliar with electrical wiring, call a qualified electrician to install this unit .More than
one person may be necessary to install fixture ,make sure you have enough qualified help.
2.Turn off the power to the fixture's circuit at the service panel. Use a voltage detector to verify that
the power is off.
3.DO NOT install bulb which exceeds the maximum wattage specified on the socket label.
1-Outlet box with
2 screws (not
supplied)
Step 1. Screw Crossbar 2 to outlet box 1 with
original outlet box screws. Make sure
crossbar studs are pointing away from wall.
Step 2. Get fixture frame a few inches
close to wall and connect wires: Connect
fixture ribbed wire to power supply black
wire. Connect fixture smooth wire to power
supply white wire. Connect fixture silver or
copper bare wire to power supply green
wire.
Step 3. Align fixture back plate holes to
crossbar studs 2 and fix it flat to wall,
secure fixture with decorative nuts 4, then
Install light bulbs.
Step 4. Install threaded rod 5 to bottom
of fixture, then install parts 6, 7, 8 and 9.
G
N
2-Cross bar with
2 studs
3-Frame
10-Slotted metal
band
L
4-Decorative nuts
x 2.
5-Threaded Rod
6-Slotted half disc
Proceed to install crystal set; follow
directions on pages 2 and 3 .
7-Connector
8-Crystal tray
9-Crystal ball
P1
020520-010-FR001 2-Light wall lamp
Customer Service :(702)361-4345,(800)525-2655,customer.service@kalco.com
Crystal tr im m ing Instruct i on s:
FIG.1
Follow these steps to inst all
crystal B1 and B2
1-Place crystal upside
Step1. Carefully unpack all parts from carton,
unwrap the crystals, lay them down on a clean
down as shown
2-Insert crystal pi n on first hole
soft cloth. Identify and organize crystals
according to instructions.
Step2. Install crystal strands (F) fir st, hung bigger
3-Turn crystal down and insert
pin to second hole
4-release.
side to top ring then to bottom acrylic part.
Step3. Install crystals to slotted metal band 10
starting from left to right in the order shown in
bottom FIG.3 (A, B1, A, B1, A, B2, AB2, repeat
pattern until finish).
Step4. Refer to FIG.1 diagram on right top to see
how crystals B1 and B2 are installed.
Step4. Install all crystal (C) from inside and
underneath of slotted metal band see FIG4.
Turn switch on.
FIG.3
Follow this pattern
A
B1
A
B1
A
B2
A
B2
A
B1
A
B1
A
C C
B2
A
B2
A
B1
A
B1
Quantity
FIG.2
B1
A
B1
A
B2
A
B2
A
A
B1,B2
C
F
D
E
10-Slotted metal band
A
B1
A
B1
A
B2
A
B2
A
Code
A19
B1 10
B2 8
C19
D6
E1
F19
P2
Loading...