Allegri 020220010FR001 User Manual

020220-010-FR001 2-Light wall lam

p

Customer Service :[phone],[phone],[e-mail]
WARMING - TO REDUCE THE RISK OF FIRE OR INJURY:

1.lf you are unfamiliar with electricalwiring, call a qualified electrician to install this unit .More than
one person may be necessary to install fixture ,make sure you have enough qualified help.

2.Turn off the power to the fixture's circuit at the service panel. Use a coltage detector to verify that
the power is off.

3.DO NOT install bulb which exxeeds the maximum wattge specified on the socket label.

Step 1. Place mount mounting and wiring steps before
crystal installation step

Step 2.

Step 3.

Install E12 bulbs bulb,do not use
bulbs that exceeds 40W.

Finally,check the installation,thecrystal hanging
on the iamp body.

40W BULBS

Main body

Thread rod

Crystal tray

Rolling plate

Cone nut

C20-16-06-01

Crystal

M

ain body

020220-010-FR001 2-Light wall lamp

Customer Service :[phone],[phone],[e-mail]

Step 4. Fasten 2 (state specification of screw )
into mounting plate so that they extend
away from wall when mounting plate is
installed

ELECTRICAL BOX

MOUNTING BLO CK

Step 5. Attach the mounting plate to outlet box
with sorews

Step 6. Refer to wiring diagram.
Splice the ribbed side of fixture cord
to the white supply wire from outlet box
with wire connector. Splice the smooth
side of the fixture cord to black supply
wire from outlet box with wire connector

Step 7. Carefully tuck in all wires Attach the
backplate with the mounting screw on
the crossbar.Secure fixture with shell
hnobs.

Fixture black and white wires

Change to blac k and white

UND

GRO

ERWI

S

L

DECORATIVE NUTS

N

LAMP BODY

G

T)SCENANDENC (IKETSOC

Black & white supply wires

RESSE WIHOU