ASSEMBLY INSTRUCTIONS
Description
Dimension
: TABLE
:
W.42”xD.(42”/60”)xH.30”
Cube Size : 44.4”x44.4” x8” NW: 74.8 LBS
(Top) GW: 83.6 LBS
Cube Size : 24.4”x10.5” x9” NW: 17.6 LBS
(Pedestal) GW: 19.8 LBS
TABLE
- 1 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability.
Please take the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment.
Please separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call for us.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being
scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1
Pedestal
B
column
1
C Leg 4
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you
have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
Flat washer
1
( Φ8.5xΦ19mm)
Hexagon nut
3
(M8x13mm)
12
12
Lock washer
2
( Φ8.5xΦ13mm)
4
Wrench
(M13mm)
12
1
Allen key
5
(4mm)
1
TABLE
- 2 -
STEP 1
Attach Legs (C) to column (B) by using Nuts (3), and Washers (2) and (1). Tighten with Wrench (4) as
shown below.
STEP 2
Use the Allen key (5) to loosen the bolts, and take off the plate underneath of the table top.
REMOVED
UNSCREW
5
X6
A
TABLE
- 3 -
STEP 3
Place the plate on top of the column (B), attach with washers (1), (2) and nuts (3). Tighten with the
Wrench (4) as shown below.
STEP 4
Carefully put the pedestal block on the bottom side of the table top, attach the top to plate
with bolts (from step 2) and tighten with the Allen key (5)
TABLE
- 4 -
STEP 5
Stand the table upright. Unlock the table top from both sides underneath of the top as shown below.
Pull the 2 parts of the table top apart.
STEP 6
Lift the butterfly leaf on, and spread it at center of open table top. Lock the table top parts at
underneath as shown below.
TABLE
- 5 -
Loading...