Alco Electronics RCT6603W User Manual

Equipment tested for
CT9603W47
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digi tal device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harm ful interference to radio or television reception, which can be determined b y turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance (MLB International Inc., PO Box 1214, Lockport, NY, 14095, Tel: 716-240-0902) could void the user’s authority to operate the equipment.
compliance as a complete unit
CAN ICES-3(B) / NMB-3(B)
This devic e c omplies with Industry Canada License-exem pt R SS-210. Op eration is sub ject to the followi ng t wo conditions: (1) This device may not c ause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Warning: th e AC adapter is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the mains plug from mains completely, the AC adapter should be disconnected from the mains socket outlet completely.
IMPORTANT SAFETY INSTRUCTIONS
Some of the following information may not apply to your particular product; however, as with any electronic product, precautions should be observed during handling and use.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Do not install near any
produce heat.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
Only use attachments / accessories specifi ed by the manufacturer.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
ADDITIONAL SAFETY INFORMATION
The AC adapter and apparatus shall not be exposed to dripping or splashing and no objects fi lled with liquids, such as vases, shall be placed on the apparatus.
Always leave suffi cient space around the product for ventilation. Do not place product in or on a bed, rug, in a bookcase or cabinet that may prevent air fl ow through vent openings.
Do not place lighted candles, cigarettes, cigars, etc. on the product.
Care should be taken so that objects do not fall into the product.
Do not attempt to disassemble the cabinet. This product does not contain customer serviceable components.
To prevent the risk of fi re or electric shock, do not expose this apparatus to rain or moisture.
Do not play your headset at high volume. Hearing experts warn against extended high-volume play.
Copyright and Trademark Notices
Android, Google, Google Play and other marks are trademarks of Google Inc. The Wi-Fi CERTIFIED Logo is a certification mark of the Wi-Fi Alliance. The Wi-Fi Protected Setup Mark is a mark of the Wi-Fi Alliance. The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG Inc. Other trademarks and trade names
are those of their respective owners.
About HDMI
High-Definition Multimedia Interface (HDMI) is a high-speed digital interface that can transmit uncompressed high definition digital multichannel audio. It delivers high quality picture and sound quality. HDMI is fully backward compatible with DVI. As required by the HDMI standard, connecting to HDMI or DVI products without HDCP (High bandwidth Digital Content Protection) will result in no Video or Audio output.
All other trademark appearing herein are the property of their respective owners. Specifications subject to change without notice.
heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifi ers) th at
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.
video and
Quick Start Guide
Getting to know your tablet
Camera
Headphone jack
Turning on your tablet for the frist time
IMPORTANT! Please Read.
We recommend fully charging your tablet before using it for the fi rst time. For optimal operation, please connect the provided AC adapter to your tablet once the battery reaches 20% charge.
Please plug into the supplied AC power supply (wall outlet) to activate the battery before you turn it on for the fi rst time.
Be sure your home Wi-Fi network is turned on and connected to the internet.
To wall outlet
Turn on the tablet in standby mode
Press the Power button to turn on the tablet screen.
Sleep / Standby mode
Press the Power button to turn off the tablet screen.
Power off the tablet
Press and hold the Power Power off appears and tap it.
Power
USB port
Connect to optional keyboard (not included)
Press and hold the Power butto n 4~5 seconds.
Select the language, then tap
and follow the
onscreen instructions to setup the tablet.
Touch and drag to unlock.
button until the
Volume +/-Pogo Pin
Printed in China
The tablet will be completely powered off.
Loading...