Alarm Lock Data Transfer Module User Manual

SE-DTM

ALARM LOCK

345 Bayview Avenue

Amityville, New York 11701

For Sales and Repairs, [phone]

For Technical Service, [phone]

© ALARM LOCK 2001

UPGRADE MICROPROCESSOR

INSTALLATION INSTRUCTIONS

WI1059 01/01

An upgrade of the DL-Windows program to version 2.7B or higher will require that the firmware in the AL-DTM
module also be upgraded to the latest revision. This is accomplished by replacing the microprocessor of the AL-DTM
with an upgrade chip, part number SE-DTM. The instructions below depict the procedure for replacing this IC. Note: if
you are unsure about the version of DL-Windows you are running, the version number can be found on the
DL-Windows Help menu in the "About" Screen.

Upgrading the AL-DTM

1 Open battery compartment and disconnect battery.
2 Remove (4) Phillips head screws from back of case.

Phillips head
screws
(4 places)

3 Lift back of case from DTM. Take care not to pull on the attached battery leads

or lose the (4) plastic spacers which are located on each corner of the circuit

board.
4 Locate Microprocessor IC5.
5 Insert a small flat-bladed screwdriver under each end of microprocessor and lift

with a gentle twisting action.

Microprocessor

Socket

End View

Insert screwdriver here

6 Observing polarity (NOTCH TO LEFT), insert new microprocessor into socket.

Take care not to bend any of the microprocessor leads. Insure that all leads are

properly inserted into socket.

Polarity
Notch IC12

7 Insure that each of the (4) plastic spacers is in its proper position.
8 Place rear cover on DTM
9 Secure cover with the (4) screws (the 2 longer screws secure the top of the unit

and the 2 shorter ones secure the bottom).
10 Re-connect battery and close battery compartment.
11 The AL-DTM is now ready to be used.

Microprocessor

Spacers
(4 places)

IC11

IC4

IC5

SE-DTM_WI1059_INST

ALARM LOCK LIMITED WARRANTY

ALARM LOCK SECURITY SYSTEMS, INC. (ALARM
LOCK) warrants its products to be free from
manufacturing defects in materials and workmanship
for 24 months following the date of manufacture.
ALARM LOCK will, within said period, at its option,
repair or replace any product failing to operate
correctly without charge to the original purchaser or
user.

This warranty shall not apply to any equipment, or
any part thereof, which has been repaired by others,
improperly installed, improperly used, abused, altered,
damaged, subjected to acts of God, or on which any
serial numbers have been altered, defaced or
removed. Seller will not be responsible for any
dismantling or reinstallation charges.

THERE ARE NO WARRANTIES, EXPRESS OR
IMPLIED, WHICH EXTEND BEYOND THE
DESCRIPTION ON THE FACE HEREOF. THERE IS
NO EXPRESS OR IMPLIED WARRANTY OF
MERCHANTABILITY OR A WARRANTY OF FITNESS
FOR A PARTICULAR PURPOSE. ADDITIONALLY,
THIS WARRANTY IS IN LIEU OF ALL OTHER
OBLIGATIONS OR LIABILITIES ON THE PART OF
ALARM LOCK.

Any action for breach of warranty, including but not
limited to any implied warranty of merchantability, must
be brought within the six months following the end of
the warranty period.

IN NO CASE SHALL ALARM LOCK BE LIABLE TO
ANYONE FOR ANY CONSEQUENTIAL OR
INCIDENTAL DAMAGES FOR BREACH OF THIS OR
ANY OTHER WARRANTY, EXPRESS OR IMPLIED,
EVEN IF THE LOSS OR DAMAGE IS CAUSED BY
THE SELLER'S OWN NEGLIGENCE OR FAULT.

In case of defect, contact the security professional
who installed and maintains your security system. In
order to exercise the warranty, the product must be
returned by the security professional, shipping costs
prepaid and insured to ALARM LOCK. After repair or
replacement, ALARM LOCK assumes the cost of
returning products under warranty. ALARM LOCK
shall have no obligation under this warranty, or
otherwise, if the product has been repaired by others,
improperly installed, improperly used, abused, altered,
damaged, subjected to accident, nuisance, flood, fire
or acts of God, or on which any serial numbers have
been altered, defaced or removed. ALARM LOCK will
not be responsible for any dismantling, reassembly or
reinstallation charges.

This warranty contains the entire warranty. It is the
sole warranty and any prior agreements or
representations, whether oral or written, are either
merged herein or are expressly canceled. ALARM

LOCK neither assumes, nor authorizes any other
person purporting to act on its behalf to modify, to
change, or to assume for it, any other warranty or
liability concerning its products.

In no event shall ALARM LOCK be liable for an
amount in excess of ALARM LOCK's original selling
price of the product, for any loss or damage, whether
direct, indirect, incidental, consequential, or otherwise
arising out of any failure of the product. Seller's
warranty, as hereinabove set forth, shall not be
enlarged, diminished or affected by and no obligation
or liability shall arise or grow out of Seller's rendering
of technical advice or service in connection with
Buyer's order of the goods furnished hereunder.

ALARM LOCK RECOMMENDS THAT THE ENTIRE
SYSTEM BE COMPLETELY TESTED WEEKLY.

Warning: Despite frequent testing, and due to, but
not limited to, any or all of the following; criminal
tampering, electrical or communications disruption, it is
possible for the system to fail to perform as expected.
ALARM LOCK does not represent that the product/
system may not be compromised or circumvented; or
that the product or system will prevent any personal
injury or property loss by burglary, robbery, fire or
otherwise; nor that the product or system will in all
cases provide adequate warning or protection. A
properly installed and maintained alarm may only
reduce risk of burglary, robbery, fire or otherwise but it
is not insurance or a guarantee that these events will
not occur. CONSEQUENTLY, SELLER SHALL HAVE
NO LIABILITY FOR ANY PERSONAL INJURY,
PROPERTY DAMAGE, OR OTHER LOSS BASED ON
A CLAIM THE PRODUCT FAILED TO GIVE WARNING.
Therefore, the installer should in turn advise the
consumer to take any and all precautions for his or her
safety including, but not limited to, fleeing the
premises and calling police or fire department, in order
to mitigate the possibilities of harm and/or damage.

ALARM LOCK is not an insurer of either the
property or safety of the user's family or employees,
and limits its liability for any loss or damage including
incidental or consequential damages to ALARM
LOCK's original selling price of the product regardless
of the cause of such loss or damage.

Some states do not allow limitations on how long an
implied warranty lasts or do not allow the exclusion or
limitation of incidental or consequential damages, or
differentiate in their treatment of limitations of liability
for ordinary or gross negligence, so the above
limitations or exclusions may not apply to you. This
Warranty gives you specific legal rights and you may
also have other rights which vary from state to state.