Alarm Controls RT-1, RT-1T, RT-1TW User Manual

MODEL RT-1

RECEIVER/TRANSMITTER

USER GUIDE

LED Indicator	LED Indicator
Green = Power On	Red = Relay Activated
(Unit shown with cover removed)	(Unit shown with cover removed)

The RT-1 Receiver is packaged with a set of paired Transmitters.
To pair additional Transmitters with the Receiver -	Learning
	Button

1.Press the Learning Button on the Receiver. The LED on the Receiver will turn from green to red.

2.Press the button on the Transmitter two times. The LED on the Receiver will flash four times indicating that the Transmitter has been paired to the Receiver. If the LED on the Receiver flashes once and changes to green, pairing has failed. The Transmitter button must be pressed within 8 seconds or the Receiver will exit the learning mode.

To remove all learned Transmitters from the Receiver -

1.Press and hold the Learning Button on the Receiver. The LED on the Receiver will turn from green to red and then back to green.

2.Release the Learning Button and the LED will turn red.

3.Wait approximately 10 seconds and the LED will turn green again.

TYPICAL WIRING FOR	TYPICAL WIRING FOR
RELEASING A MAGNETIC LOCK	RELEASING AN ELECTRIC STRIKE

-

-

POWER + SUPPLY

MAGNETIC + LOCK

-

-

POWER + SUPPLY

ELECTRIC + STRIKE

Alarm Controls

Phoenix, AZ 85044 [phone] www.alarmcontrols.com