AJA RH10DA User Manual [en, de, es, fr, it]
www.aja.com
Installation and Operation
Guide
Because it matters.
RH10DA
1x8 SD/HD-SDI Re-clocking
Distribution Amplifier (dual-rate)
R-series Card Module
Published: 6/30/10
2
Trademarks
Notice
Contacting Support
®
AJA
are trademarks of AJA Video, Inc. HDMI, the HDMI logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC. DVI is a registered trademark of DDWG.
All other trademarks are the property of their respective holders.
Copyright © 2010 AJA Video, Inc. All rights reserved. All information in this manual is subject to
change without notice. No part of the document may be reproduced or transmitted in any form, or by
any means, electronic or mechanical, including photocopying or recording, without the express
written permission of AJA Inc.
To contact AJA Video for sales or support, use any of the following methods:
180 Litton Drive, Grass Valley, CA. 95945 USA
Telephone: 800.251.4224 or 530.274.2048
Fax: 530.274.9442
Web: http://www.aja.com
Support Email: support@aja.com
Sales Email: sales@aja.com
When calling for support, have all information at hand prior to calling.
®
, KONA
, Ki Pro®, and XENA
®
are registered trademarks of AJA Video, Inc. FiDO™, Io HD
™
and Io
™
Limited Warranty
AJA Video warrants that this product will be free from defects in materials and workmanship for a
period of five years from the date of purchase. If a product proves to be defective during this warranty
period, AJA Video, at its option, will either repair the defective product without charge for parts and
labor, or will provide a replacement in exchange for the defective product.
In order to obtain service under this warranty, you the Customer, must notify AJA Video of the defect
before the expiration of the warranty period and make suitable arrangements for the performance of
service. The Customer shall be responsible for packaging and shipping the defective product to a
designated service center nominated by AJA Video, with shipping charges prepaid. AJA Video shall
pay for the return of the product to the Customer if the shipment is to a location within the country in
which the AJA Video service center is located. Customer shall be responsible for paying all shipping
charges, insurance, duties, taxes, and any other charges for products returned to any other locations.
This warranty shall not apply to any defect, failure or damage caused by improper use or improper or
inadequate maintenance and care. AJA Video shall not be obligated to furnish service under this
warranty a) to repair damage resulting from attempts by personnel other than AJA Video
representatives to install, repair or service the product, b) to repair damage resulting from improper
use or connection to incompatible equipment, c) to repair any damage or malfunction caused by the
use of non-AJA Video parts or supplies, or d) to service a product that has been modified or integrated
with other products when the effect of such a modification or integration increases the time or
difficulty of servicing the product.
THIS WARRANTY IS GIVEN BY AJA VIDEO IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED.
AJA VIDEO AND ITS VENDORS DISCLAIM ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. AJA VIDEO’S RESPONSIBILITY TO REPAIR OR REPLACE
DEFECTIVE PRODUCTS IS THE WHOLE AND EXCLUSIVE REMEDY PROVIDED TO THE CUSTOMER FOR
ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES IRRESPECTIVE OF WHETHER AJA
VIDEO OR THE VENDOR HAS ADVANCE NOTICE OF THE POSSIBILITY OF SUCH DAMAGES.
•
•
•
Introduction
Features
AJA RH10DA 1x8 SD/HD-SDI Reclocking DA User Manual
The RH10DA is a multi-standard Dual Rate 1x8 SDI/HD-SDI Distribution
Amplifer. The input is re-clocked and equalized to 100/300 meters (HD/SD) of
coax cable. The RH10DA automatically configures to 143, 177, 270, 360mb, or
1.485gb SDI inputs. The RH10DA is compatible with AJA’s FR1 or FR2 frames.
1
3
Block Diagram
RH10DA Card Module, Side View
Dual Rate HD-SDI/SDI
Equalizing and Re-clocking, 8 outputs
Automatic Input configuration
Rackframe
Backplane
HD/SD SDI Video
1X8 Reclocking
Distribution
Amplifier
+6.5V Power
From Rackframe
Redundant Supplies
Power Regulation
1.
2.
3.
4
I/O Connections
4.
5.
User Controls
HD/SD-SDI
HD/SD-SDI
Out 7
J8
J9
HD/SD-SDI
Out 8
FR1 Frame Layout
RH10DA Rear Panel
Out 5
J6
J7
HD/SD-SDI
Out 6
HD/SD-SDI
Out 3
J4
J5
HD/SD-SDI
Out 4
J2
J3
HD/SD-SDI
Out 1
HD/SD
SDI In
J1
HD/SD-SDI
Out 2
HD/SD-SDI In
HD/SD-SDI
Out 1
HD/SD-SDI
Out 3
HD/SD-SDI
Out 5
HD/SD-SDI
Out 7
J1
J2
J4
J6
J8
HD/SD-SDI
Out 2
J3
HD/SD-SDI
Out 4
J5
HD/SD-SDI
Out 6
J7
HD/SD-SDI
Out 8
J9
FR2 Frame Layout
RH10DA Rear Panel
FR1 and FR2 BNC Connector Assignments, RH10DA Card Module
When the RH10DA module is installed in an AJA FR1 or FR2 frame, a
corresponding group of 9 BNCs on the rear panel then provide I/O for the
module. The illustration above shows the connector assignments for both the
FR1 and FR2 when used with the RH10DA.
Output configuration is discussed next in User Controls .
There are no user controls on the RH10DA. An earlier version of the RH10DA (pre6/2010) had a jumper for configuring reclocking (J1); it is not present in the
current version.
Installation
Typically, RH10DA installation consists of the following:
disconnect power from the frame (remove line cord)
remove the FR1/FR2 front panel
install RH10DA card module
replace the FR1/FR2 front panel
apply power to the frame by connecting a north american-style power
cord from the frame to mains power (90 to 260 VAC)
!
Warning!
Ensure Mains Power is disconnected before installing the FR1 or FR2 frame Rseries modules into the frame, or installing and removing options. If a Mains
switch is not provided, the power cord(s) of this equipment provide the
means of disconnection. The socket outlet must be installed near the
equipment and must be easily accessible.
Warning!
FR2 Dual Power Cord Notice—please read this. To reduce the risk of electrical
shock, disconnect both power cords before servicing equipment.
Caution!
The FR1/FR2 front fan door is heavy and is not hinged. Remove with Caution.
Loading...