Aiwa LCX-K170 HRJ Service Manual

LCX-K170

HRJ(ST)

SERVICE MANUAL

COMPACT DISC

STEREO SYSTEM

This service manual contains information only on the SPEAKER of LCX-K170.
For more information, please refer to the following service manuals.
LCX-K170 HRJ(ST) (S/M Code No. 09-993-324-7R1).

BASIC TAPE MECHANISM : TN21ZSC-1653
BASIC CD MECHANISM : KSM-2131 BDM

S/M Code No. 09-993-324-7S1

SUPPLEMENT

DATA

SPEAKER DISASSEMBLY INSTRUCTIONS

Type.1

Type.4

Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel. Remove the screws of each speaker
unit andthen remove the speaker units.

Type.2

Remove the grill frame and four pieces of rubber caps by pulling
out with a flat-bladed screwdriver. Remove the screws from hold
where installed rubber caps. Insert a flat-bladed screwdriver into
the position indicated by the arrows and remove the panel. Re­move the screws of each speaker unit and then remove the speaker
units.

TOOLS

1 Plastic head hammer
2 (-) flat head screwdriver
3 Cut chisel

1 2 3

How to Remove the PANEL, FR

1. Insert the (-) flat head screwdriver tip into the gap
between the PANEL, FR and the PANEL, SPKR. Tap
the head of the (-) flat head screwdriver with the plastic
hammer head, and create the clearance as shown in Fig-1.

2. Insert the cut chisel in the clearance, and tap the head of
the cut chisel with plastic hammer as shown in Fig-2, to
remove the PANEL, FR.

3. Place the speaker horizontally. Tap head of the cut
chisel with plastic hammer as shown in Fig-3, and
remove the PANEL, FR completely.

Type.3

Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel. Turn the speaker unit to counter­clockwise direction while inserting a flat-bladed screwdriver into
one of the hollows arround speaker unit, and then remove the speaker
unit. After replacing the speaker unit, install it turnning to clock­wise direction unitil "click" sound comes out.

Fig-1 Fig-2

Fig-3

How to Attach the PANEL, FR

Attach the PANEL, FR to the PANEL, SPKR. Tap the four
corners of the PANEL, FR with the plastic hammer to fit the
PANEL, FR into the PANEL, SPKR completely.

2