Airwave Technologies AWW698TX Users Manual
Photo A:
Power Switch 433MHz ID Channel Tack switch
(only AWV698C applicable)
Photo B.:
Channel Indicator: CH1 ~ CH7
Remote Control Indicator
Photo C.:
(Receiver)
Audio R Audio L Video Power Plug (9V)
(Transmitter)
plug for IR cable LED (transmitter)
Photo D.:
Transmitter
Receiver
(Shown above is the antenna direction for application.)
Specification
Transmitter:
1. Frequency: 5.725GHz – 5.875GHz
2. Channel: 7 selectable channels
3. Modulation: FM-FM
Input level: Video - 1 Vp-p (PAL)
Audio - 3 Vp-p
Impedance: Video - 75 ohms (PAL)
Audio - 10K ohms
4. Input port: SCART line cable
5. Antenna: Built in antenna
6. Power supply: DC 9V power adapter
Receiver:
1. Frequency: 5.725GHz – 5.875GHz
2. Channel: 7 selectable channels
3. Output port: SCART line cable
4. Antenna: Built in antenna
5. Power supply: DC 9V power adapter
Trouble Shooting
If a problem occurs, first refer to this information before
you take the device for repair.
If you are unable to rectify the fault using the information
given here, contact your local dealer or service specialist.
Under no circumstances should you attempt
to repair the device yourself, as this would
invalidate the warranty.
PROBLEM POSSIBLE
CAUSE
No
picture/sound
transmission
Wrong direction of
Poor
picture/sound
quality
The remote
control of the
signal source
does not
respond.
The transmiss i on
channels for the
transmitter/receiver
do not correspond.
The transmiss i on
distance is too
great.
Connecting cable. Check the
Transmitter or
receiver not
switched on.
patch antenn a
Interference.
Microwave units
and the use of the
so-called ”blue
tooth function ”
(W LAN) on mobile
phones or
notebooks.
Infrared module. Check the
A wireless
transmitter in the
433MHz range
(e.g. a
baby-phone) is
interfering with the
transmission.
REMEDY
Set the
transmission
channel on the
transmitter/receiver
Reduce the
distance.
EURO-AV plug
and the cinch plug.
Switch on the
transmitter or
receiver
Adjust the antenna
to the right
position. See photo
D.
Move the
transmitter or
receiver a few
centimeters
Change the
transmission
channel on the
transmitter/receiver
Change channel to
find better channel
to receive.
connection and
position of the
infrared module.
Switch this device
off.
DOC0000-0269
Loading...