Airlink101 ASW324 User Manual

Quick Installation Guide

24-Port 10/100Mbps

Fast Ethernet Switch

Model# ASW324

Ver. 1A

Trademarks

Copyright © 2009 Airlink101®
Airlink101® is a registered trademark. All other trademarks
belong to their respective proprietors.

Copyright Statement

No part of this publication may be reproduced in any form or
by any means or used to make any derivative such as
translation, transformation, or adaptation without permission
from Airlink101®.

Preface

FCC Warning

This device has been tested and found to comply with limits
for a Class a digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the user’s
manual, may cause interference in which case the user will
be required to correct the interference at his own expense.

CE Mark Warning

This is a Class A product. In a domestic environment, this
product may cause radio interference in which case the
user may be required to take adequate measures.

1

1 Introduction

Congratulations on your purchase of the 24-Port 10/100Mbps
Fast Ethernet Switch! It is an easy-installed network switch
which helps you to extend your network structure quickly and
reliably.

Purpose

This Quick Installation Guide tells you how to install your
Switch and how to connect it to your Ethernet network.

Terms/Usage

In this manual, the term “Switch” (first letter upper case)
refers to your 24-Port 10/100Mbps Fast Ethernet Switch,
and “switch” (first letter lower case) refers to other Ethernet
switches.

1.1 Hardware Interface

• 24-Port 10/100Mbps auto-negotiation RJ45 Ports

• All ports support auto MDI/MDIX, no need to use

cross-over cables

1.2 Panel

1.2.1 Front Panel

The front panel of the Switch consists of LED indicators, and
24 10/100Mbps ports. The figure below shows the front pa nel
of the Switch.

Figure 1-1 Front Panel view of the Switch

• 10/100Mbps Ports (Port 1~24): These ports support 10/
100Mbps, and can operate in Half/Full Duplex transfer
modes. These ports also support automatic MDI/MDI-X
crossover detection, giving true “plug and play” capability.

• LED Indicators: Comprehensive LED indicators display
the status of the switch and the network (see Section

1.2.3).

1.2.2 Rear Panel

Figure 1-2 Rear Panel view of the Switch

• AC Power Connector: Supports AC 100~240V, 50~60Hz.

2

3