Aiphone JA-DGV User Manual

1206

Vandal Resistant Color Pan Tilt Video Door Station

- INSTALLATION INSTRUCTIONS -

FLUSH MOUNTING INSTRUCTIONS

1. Cut a hole in the wall that is 9-1/16" x 6-1/8". (Ensure
that mounting depth of at least 2-11/16" is available.)

2. Pass cable through knockout holes.

3. Secure back box to wall so that front of box is flush with
the outside edge of the wall.

4. Connect wires to the JA-DGV. (See wiring diagram)

5. Attach the JA-DGV to the mounting box using the
supplied screws and tamper proof tool.

JA-DGV

SURFACE MOUNTING INSTRUCTIONS (REQUIRES SBX-DGV, SOLD SEPARATELY)

1. The SBX-DGV is designed to mount to a 1 or 2 gang
box or ring or to any flat surface.

2. Pass cable through knockout holes.

3. Secure mounting box to wall.

4. Connect wires to the JA-DGV. (See wiring diagram)

5. Attach the JA-DGV to the mounting box using the
supplied screws and tamper proof tool.

JA-DGV

SBX-DGV

SAMPLE WIRING DIAGRAM

JA-2MCD

JA-2MECD

Mic

A1
A2

1A1
1A2

Speaker

JA-DGV

Call

Button

JA-DAC

A1
A2

2A1
2A2

B1
B2

+

-

PS-2420UL

+

-

Pg. 1

WIRING PRECAUTIONS

1. Keep video wires at least 12" away from AC 100~240V
power lines.

2. Use 2 conductor non-shielded wire with PE insulation.
(Aiphone 871802 wire.) Coax-cable cannot be used.

3. If there are unused wires in the cable, install a 120Ω
resistor between each pair of unused conductors.

4. Do no mix audio/video wires with those of another
video door station or device in the same cable.

JA-DGV

IMAGE VIEW AREA (approx.) when panned-and-tilted

JA-2MCD

•The image view area is a guideline and may vary according to environment.

•The peripheral part of the monitor may be slightly distorted.

•The image may have reflective light coming into the lens from the camera cover.

MOUNTING LOCATIONS & HEIGHT

Do not install the video door station in the following
locations:

- Places subject to temperature/humidity extremes.

- Places subject to dust, vapor, smoke, or chemicals.

- Places that are strongly backlit.

- Places where direct sunlight or strong light comes

into the camera lens.

OPERATION

Calling: Momentarily press CALL button on the door station.

After person at the monitor station replies, talk hands free while standing in front of the camera.

TECHNICAL PRECAUTIONS

Caulking seals: Do not apply any caulking seals around the video door station. Water drainage holes on the

bottom will help water or moisture to dissipate.

Cleaning: Clean JA-DGV with a soft cloth dampened with neutral household cleanser. Never use any

harsh cleanser or cloth. Do not spray high-pressure water on the video door station.

Pg. 2