Aiphone IPW-1A Specsheet
IPW-1A
Intercom-Over-IP Adaptor
DESCRIPTION:
The IPW-1A provides voice-quality intercom
communication and relay activation over standard
IP based networks. Designed specifically to
integrate seamlessly into a new or existing LAN /
WAN infrastructure, the IPW-1A system is capable
of supporting hundreds of stations. Providing
intercom/paging solutions to a large variety of
applications including commercial, industrial,
residential, general security, office, and institutional.
The IPW-1A works with Aiphone’s proprietary
CommuniCenter software to create a network
intercom system. The IPW-1A is compatible with
any of the Aiphone IE door stations. The system
allows for call-in to the PC via the CommuniCenter
software, general communication between the PC
and the intercom station, as well as the ability to
activate the electric door release.
FEATURES:
Cost-effective multi-master (PC based) design
Compatible with IE Series door stations
Scalable to hundreds of stations / locations
Works with standard wired and wireless network
infrastructure. (LAN/WAN)
Digital audio recording and playback capability
via included software
Relay output for remote release (N/O or N/C)
(the relay can also be configured to trigger when
communication is being transmitted to the
IPW-1A, communication is being
transmitted from the IPW-1A, or the call
button on the sub station is pressed)
External input
IPW-1A Spec Sheet
0710 Pg. 1
1700 130
Ph: (800) 692-0200 * Fax: (425) 455-0071
th
Ave NE * Bellevue, WA 98005
Aiphone Corporation
tech@aiphone.com
IPW-1A
Intercom-Over-IP Adaptor
FEATURE CALL-OUTS:
Front plate
[1] [2] [3] [4]
Rear plate
FEATURE CALL-OUT DEFINITIONS:
[1] Reset switch (reset unit)
[2] RS-232 Serial Port (for firmware recovery)
[3] Green and Red Status Lights
[4] Sub station connector
[5] Door release relay output & external input
Door release:
NO = Normally open contact
NC = Normally closed contact
C = Common
External input:
IN0 = call button input (simulates door call in)
Gnd = ground
[6] Mounting rail slots
[7] RJ-45 10/100 Ethernet jack & connection indicator
LED’s (network connection)
[8] Power input connector
IN0 IN1 NO C NC
[5] [6] [7] [8]
IPW-1A with Mounting Rail
SPECIFICATIONS:
Power Source: 15VAC, PT-1211C (included)
Network Interface: 10/100 Base-T Ethernet (Auto
detection) RJ-45
IP Assignment: Static or Dynamic
Hardware Protocols: TCP/IP, UDP, DHCP, SNMP,
AutoIP, SonicIP, Ipzator
Transport Bandwidth: ≈128Kbps per active session
(normal mode)
≈64Kbps per active session
(low bandwidth mode)
Audio Encoding: PCM (raw), G.7ll (µLaw)
Audio Sampling: 16bit @ 8kHz (normal mode)
8bit @ 8kHz (low bandwidth mode)
Output Level: Determined by sub station
Relay contact Rating: 30V AC/DC 1.0A (resistive)
IPW-1A Spec Sheet
0710 Pg. 2
Operating Temp: 32°F to 104°F (0°C to 40°C)
Dimensions: 1-½” H x 4-¼” W x 4-15/16" D
1700 130
Ph: (800) 692-0200 * Fax: (425) 455-0071
th
Ave NE * Bellevue, WA 98005
Aiphone Corporation
tech@aiphone.com
Loading...