Aiphone IPW-1A User Manual

0210

- INSTRUCTIONS -

The IPW-1A offers voice-quality Intercom function over standard IP based networks. Designed specifically to integrate
seamlessly into a new or existing LAN / WAN infrastructure, the IPW-1A system is capable of supporting hundreds of
stations. Providing intercom/paging solutions to a large variety of applications including commercial, industrial,
residential, general security, office, and institutional.

NAMES & FEATURES

IPW-1A

Front plate

1 2 3 4

Rear plate

IN0 IN1 NC C NO PWR

5 6

NAMES & FUNCTIONS:

1. Reset switch (reset unit)

2. RS-232 Serial Port (for firmware recovery)

3. Green and Red Status Lights

4. Sub station connector

5. Door release relay output &
external input.

Door release:
NC = Normally closed contact
NO = Normally open contact

C = Common

External input:
IN0 = call button input (simulates door call in)
Gnd = ground

6. RJ-45 10/100 ethernet jack & connection indicator LED’s (network
connection)

7. Power input connector

7

Package Contents:

(1) IPW-1A
(1) PT-1211C
(1) Mounting hardware
(1) Software CD

(1) Install manual

FEATURES:

Cost-effective multi-master (PC-based) based design
Compatible with IE Series sub stations and AX-DM
Scalable to hundreds of stations / locations
Works with standard wired and wireless network infrastructure. (LAN/WAN)
Digital audio recording and playback capability via included software.

Relay output for remote release (N/O or N/C)

Pg. 1

INSTALLATION & MOUNTING

POWER

IN0 IN1 NC C NO

LAN

Note:
Contact rated at 30V, 1A.

PWR

PT

SUB

PT-1211C

Installation Instructions:

1. If the IPW-1A adaptor is not on the same LAN or
network segment as the PC master station, ensure
that the IPW-1A has been pre-programmed with the
proper connection settings prior to physical adaptor
installation. See the CommuniCenter Operations
manual (included on CD with IPW-1A).

2. Wire the sub station to the proper connector on the
IPW-1A, and connect to the network using the
standard RJ-45 jack. Wiring from the sub station to
the IPW-1A should be a 2-conductor, shielded cable.
Connect the PT-1211C power supply included to the
power input connector.

RESET RS-232 STATUS

Wiring to sub station should be 2-conductor shielded cable.

*

Wire distance from IPW-1A to IE series sub station:
22AWG = 387 feet, 18AWG = 980 feet

SUB

1

2

Audio Only Door

IE Series sub station

Mounting Instructions:

1. Mount the IPW-1A adaptor in a controlled area or in an enclosure suitable to

the installation environment. The IPW-1A chassis is neither vandal resistant
nor weather resistant. Secure the provided mounting bracket and then slide

the IPW-1A onto the bracket as shown. If mounting the unit on a shelf, attach
the 4 rubber feet that are included.

CommuniCenter SOFTWARE INSTALLATION

1-5/8"

4-11/16"

4"

1. Load the software onto the PC to be used as a master station. Insert the CD (included with IPW-1A) or download the
latest version from the Aiphone website (www.aiphone.com).

2. Install the CommuniCenter software by following the on-screen prompts, or by executing “setup.exe” to begin the

installation process.

3. Consult the CommuniCenter Operation manual document for further software functionality and configuration
information.

NOTE – If installing system over a WAN please refer to the CommuniCenter Operation manual.

Pg. 2