Aiphone IE-SS-LD, IE-SSR-LD Instruction Manual

for LEF-LD & LAF-C-LD Systems
- INSTRUCTIONS -
The IE-SS-LD and IE-SSR-LD remote stations are vandal proof and weather resistant, designed for use with the systems listed above. They're constructed with 12 gauge stainless steel, and the IE-SSR-LD features a red mushroom call button. The units either flush mount into a 2-gang box, or surface mount with the SBX-2G. Each unit includes tamper proof screws and a tool for installation.
INSTALLATION:
1. For flush mounting, install sub station in standard 2-gang electrical box with min. 2-1/2" depth.
2. For surface mounting, install sub station in the SBX-2G surface mount enclosure.
3. IMPORTANT! These units are designed for use in normal weathe r conditions, and to allow drainage and evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If sealing the unit is required, the bottom must remain unsealed.Sealing the unit will prevent or inhibit moisture from dissipating from inside the unit, which may cause corrosion or deterioration to the internal components over time.
MOUNTING:
IE-SS-LD
(or IE-SSR-LD)
TORX
screws
WIRING DIAGRAM:
2-GANG BOX
Do not apply sealant between unit and box.
PS-1225UL
-
+
PS-1225UL
-
+
LEF-10-LD
1 2 ~
10
E
-
+
LEF-10-LD
1 2
~
10
E
-
+
E/- jumper
attached on
master
E/- jumper
attached on
master
IE-SS-LD
Red
Blk
Wht
IE-SS-LD
Red
Blk
Wht
PS-1225UL
-* +
IE-SSR-LD
Red
Blk
Wht
IE-SSR-LD
Red
Blk
Wht
12V DC
power supply
-* +
*Negatives of
remote power
supplies must be
tied together.
Pg. 1
NOTE:
For complete system information, please refer to the installation manual provided with the intercom system.
OPERATION:
1. Pressing the call button at the remote station will activate the call tone, plus light the appropriate station LED at the LEF master. The call tone will be momentary as long as the call button is held down, and the LED light will stay on for approximately 20 seconds.
2. To answer the call at the LEF master, press the station button corresponding to the lit LED, then press TALK to speak to the caller.
3. Communication at the master station is "press-to-talk, release-to-listen". Communication at the door station is hands free.
4. (If selective door release is included): With communication established to the door station, pressing the door release button will activate the door release mechanism at the corresponding door.
5. When the call is completed, press OFF on the LEF master station. This puts the system in standby mode.
SPECIFICATIONS:
Power Source: Supplied by master station Speaker: Baffle protected, water proof and puncture resistant, 2.4 oz. magnet Microphone: Baffle protected ECM Call Button: SPST call button. Call tone is activated at master when call button is pressed
IE-SS-LD: Limited stop button. IE-SSR-LD: Limited stop, red mushroom button Communication: Hands free at sub. Master station is press-to-talk, release-to-listen. Faceplate: 12 gauge stainless steel Mounting: Flush mount into a 2-gang box. Surface mount into SBX-2G, sold separately.
Tamper proof screws included (6x32 for use with flush gang box) with T-10 TORX bit.
Use hardware included with SBX-2G when installing sub into that unit. Terminations: Color-coded prewired pigtails
Operating Temperature: Flush Switch rating: 14°F to 158°F; Mushroom Switch rating: -22°F to 185°F
Speaker rating: -67°F to 187°F Wiring: 3 conductors (2 common + 1 individual) per sub station. Use Aiphone #822203 or #821803. Wiring Distance: See system that unit is being used with for distance specifications
Dimensions (H x W x D): IE-SS/IE-SSR-LD alone: 4-11/16" x 4-11/16" x 2"
With SBX-2G: 4-3/4" x 4-7/8" x 3-5/8" (Top) 2-3/8" (Bottom)
Aiphone Communication Systems 1700 130th Ave. N.E. Bellevue, WA 98005 (425) 455-0510 FAX (425) 455-0071
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200
TOLL FREE FAX LINE: (800) 832-3765
E-MAIL: tech-serv@aiphone.com
IE-SS-LD Instr.
1204PHJS
Loading...