Page 1
ELECTRONIC GLASS KETTLE
INSTRUCTION MANUAL
KE8026-GS
Page 2
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions before using.
2. Before connecting the kettle to the power supply, check
that the voltage indicated on the appliance (underside the
kettle & base) corresponds with the voltage in your home.
If this is not the case, contact your dealer and do not use the
kettle.
3. The attached base can not be used for other than intended
use.
4. Do not operate the appliance without load to avoid
damaging the heat elements.
5. Unplug from the outlet when not in use.
6. Do not let the cord hang over edge of table counter or
touch hot surface.
7. Do not place on or near a hot gas or electric burner or in a
heated oven.
8. Should you accidentally allow the kettle to operate
without water, the boil-dry protection will automatically
switch it off. If this should occur, allow the kettle to cool
before filling with cold water and re-boiling.
9. Ensure that kettle is used on a firm and flat surface where
the children can’t touch, this can prevent from overturning
the kettle to damage the person or kettle.
10. To protect against a fire, electric shock or personal
injury, do not immerse cord, electric plugs or kettle in water
or other liquids.
11. Always take care to pour boiling water slowly and
carefully without tipping the kettle too fast.
12. Be careful when opening the lid for refilling when the
kettle is hot.
13. Close supervision is necessary when any appliance is
used by or near children.
14. Do not touch the hot surface. Use the handle or the
button.
15. Extreme caution must be used when moving an
appliance containing hot water.
1
Page 3
16. The appliance is not a toy. Do not let the children play
it.
17. The use of attachments that are not recommended by
the appliance manufacturer may result in fire, electric shock
or personal injury.
18. While boiling water, avoid to contacting steam from the
spout when water is boiling or just after it has switched off.
Do not be anxious to uncover the lid.
19. Unplug from outlet when not in use and before cleaning;
Allow it to cool before putting on or taking off parts and
before cleaning the appliance.
20. Always ensure the lid is closed and do not lift it while
the water is boiling. Scalding may occur if the lid is removed
during the brewing cycles.
21. If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
22. Do not use the appliance for other than intended use.
23. Do not move the unit while the kettle is switched on.
24. The kettle can only use with the stand provided.
25. If the kettle is overfilled, boiling water may be ejected.
26. Do not use the kettle outdoors.
27. This appliance can be used by children aged from 8
years and above if they have been given supervision or
instruction concerning use of the appliance in a safe way
and if they understand the hazards involved. Cleaning and
user maintenance shall not be made by children unless they
are older than 8 and supervised. Keep the appliance and its
cord out of reach of children aged less than 8 years.
28. Children should be supervised to ensure that they do not
play with the appliance.
29. Appliances can be used by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved.
2
Page 4
30. This appliance is intended to be used in household and
similar applications such as:
– Staff kitchen areas in shops, offices and other working
environments;
– Farm houses;
– By clients in hotels, motels and other residential type
environments;
– Bed and breakfast type environments.
31. Save these instructions.
32. This appliance has been incorporated with a grounded
plug. Please ensure the wall outlet in your house is well
earthed.
Know your kettle
3
Page 5
Before initial use
If you are using the kettle for the first time, it is recommended that you clean your kettle before
use by boiling a full kettle of water twice and then discarding the water.
Operation
1. To fill water into the kettle, remove it from the power base and open the lid by press down
the lid button, fill with the desired amount of water to the kettle. Always fill the kettle between
the minimum (0.5L) and maximum (1.7L) marks. Too little water will result in the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before connecting the power cord to
the outlet.
2. Close the lid. Position the kettle on the power base in place. Make sure the kettle contact with
the power base completely.
3. Connect the plug into a power outlet. Lift the switch upwards to “I” position and the switch
light illuminates. Then start to boil the water. The kettle will switch off automatically once the
water has boiled and the switch light extinguishes. You can shut off the power by pressing the
switch at any moment during boiling water.
NOTE：Ensure that switch is clear of obstructions and the lid is firmly closed. The kettle
will not turn off if the switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may
result in scald, besides, don’t open the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds before
reopening to boil water. The kettle may be stored on the power base when not in use.
NOTE：Ensure power supply is turned off when kettle is not in use.
Boil-dry protection
Should you accidentally allow the kettle to operate without water, the boil-dry protection will
automatically switch it off. If this should occur, allow the kettle to cool before filling with cold
water and re-boiling.
Care and cleaning
Always disconnect the appliance from the power outlet and leave it to cool down completely
before cleaning.
4
Never immerse the kettle or cord in water, or allow moisture to contact with these parts.
Page 6
Removal of mineral deposits
Mineral deposits in tap water may cause the kettle interior to discolor .To remove this build-up,
use non-toxic Liquid Descaler.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar and the remainder of water and be allowed to
stand overnight. Do not boil.
2. Empty the solution from the kettle. Any stains remaining inside the spout can be removed by
rubbing with a damp cloth, fill the kettle with clean water, bring to boil and then discard the
water. Repeat and the kettle will then be ready to use.
Cleaning external housing
Wipe the external housing with a wild and damp cloth or cleaner.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of
the kettle.
Cleaning the filter
Remember to clean the filter with a wild and damp cloth at intervals.
Storage
When not in use or storage, the power cord may be wound around the cord storage under the
base of kettle.
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local regulations:
hand in the non-working electrical equipments to
an appropriate waste disposal center.
5
Page 7
33
Aicok Home Essentials Live Comfortable
Shenzhen Impression E-commerce Co.,Ltd
Booth No.3H012,Trading Plaza,No.5,Huanan city,
Pinghu Street,Longgang District,Shenzhen,China
Facebook Page: https//www.facebook.com/aicoks/
Website:www.aicok.cc
Made In China
Loading...