FP9042
1
FOOD PROCESSOR
Model: FP9042
Read this booklet thoroughly before using and save it for future reference
2
IMPORTANT SAFEGUARDS
Before using the electrical appliance, the following basic precautions should always be
followed including the following:
1. Read all instructions, and save it for future reference.
2. Before using, check that the voltage of wall outlet corresponds to that shown on the
rating plate.
3. Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions, or is dropped or damaged in any manner. Bring it to a qualified technician
for examination, repair or electrical or mechanical adjustment.
4. Do not let cord hang over edge of table or counter.
5. To protect against risk of electrical shock, do not put the motor base into water or other
liquid. To disconnect, turn any control to “off”, then remove plug from wall outlet by
grasping the plug, not the cord.
6. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliances by a
person responsible for their safety.
7. Close supervision is necessary when any appliance is used by or near children.
8. Keep hands and utensils away from moving blades or discs while processing food to
reduce the risk of severe injury to persons or damage to the Food Processor. A scraper
or spatula may be used, but must be used only when the Food Processor is not running.
9. Avoid contacting moving parts.
10. Never feed food by hand. Always use food pusher.
11. Before removing the lid from the jar from the power unit, switch off the unit, wait until
the blades have come to a complete stop.
12. Do not use fingers to scrape food away from discharge disc while appliance is operating.
Cut type injury may result.
13. Be certain lid is securely locked into place before operating appliance.
14. Always remove the blade assembly before pouring contents from jar.
15. Be sure to switch off the appliance after each use of your food processor. Make sure the
motor stops completely before disassembling.
16. Do not put your fingers or other objects into the unit opening while it is in operation. If
food becomes lodged in opening, use food pusher or another piece of fruit or vegetable
to push it down. When this method is not possible, turn the motor off and disassemble
to remove the remaining food.
17. Do not attempt to defeat the cover interlock mechanism.
18. The metal blades and disk is extremely sharp, handle with care. Always hold the blade
assembly by the finger grip or stem, away from the cutting edge, both when handling
and cleaning.
19. To reduce the risk of injury, never place processing blade or circle blade ass’y on drive
shaft without the processing jar locked properly in place.
20. Do not leave this appliance unattended during use.
21. If this appliance falls or accidentally becomes immersed in water, unplug it immediately.
Do not reach into the water! Do not use this appliance after it has fallen into or becomes
3
immersed in water.
22. To reduce the risk of injury to persons or property, never use this appliance in an
unstable position.
23. Do not use this appliance for other than its intended use.
24. The use of attachments not recommended or sold by the manufacturer may cause fire
，
electric shock or injury.
25. Do not use outdoors.
26. Unplug from outlet when not in use, before putting on or taking off parts, and before
cleaning.
27. Caution: never immerse in water, unplug before inserting or removing parts.
28. CAUTION: DO NOT OPEN LID UNTIL BLADES STOP.
29. Note: This Food Processor is the multipurpose appliance, plastic blade for kneading can
creat maximum rating. Other recommended attachments may draw significantly less
current.
SAVE THEST INSTRUCTIONS
HOUSEHOLD USE ONLY
SPECIAL NOTES ON PLUG
This appliance incorporated a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug can
not fit fully into the socket, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way as this is a safety feature.
Loading...