Aicok CM4682-V User Manual

COFFEE MAKER

INSTRUCTION MANUAL

CM4682-V

IMPORTANT SAFEGUARDS

Before using the electrical appliance, the following basic

precautions should always be followed including the

following:

1. Read all instructions.

2. Before using check that the voltage of wall outlet

corresponds to rated voltage marked on the rating plate.

3. This appliance has been incorporated with a grounded

plug. Please ensure the wall outlet in your house is well

earthed.

4. To protect against fire, electric shock and injury to

persons do not immerse cord, plug in water or other liquid.

5. Remove plug from wall outlet before cleaning and when

not in use. Allow appliance cool down completely before

taking off, attaching components or before cleaning.

6. Do not operate any appliance with a damaged cord or

plug or after the appliance malfunctions, or is dropped or

damaged in any manner, return appliance to the nearest

authorized service facility for examination, repair or

electrical or mechanical adjustment.

7. The use of accessory attachments not recommended by

the appliance manufacturer may result in fire, electric

shock or injury to persons.

8. Place appliance on flat surface or table, do not hang

power cord over the edge of table or counter.

9. Ensure the power cord do not touch hot surface of

appliance.

10. Do not place the coffee maker on hot surface or beside

fire in order to avoid to be damaged.

11. To disconnect, remove plug from wall outlet. Always

hold the plug. But never pull the cord.

12. Do not use appliance for other than intended use and

place it in a dry environment.

13. Close supervision is necessary when your appliance is

being used near children.

1

14. Be careful not to get burned by the steam.

15. Do not touch the hot surface of appliance (such as

steam wand, and the steel mesh just boiling). Use handle or

knobs.

16. Do not let the coffee maker operate without water.

17. Do not remove the metal funnel when appliance in

brewing coffee or when steam.

18. Connect plug to wall outlet before using and turn any

switch off before plug is removed from wall outlet.

19. This appliance is not intended for use by persons

(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction

concerning use of the appliances by a person responsible

for their safety.

20. Children should be supervised to ensure that they do

not play with the appliance.

21. The environment temperature of operating or storing

shall be more than 0

℃

.

22. This appliance is intended to be used in household and

similar applications such as:

– staff kitchen areas in shops, offices and other working

environments;

– farm houses;

– by clients in hotels, motels and other residential type

environments;

– bed and breakfast type environments.

23. Do not use outdoors.

24. Save these instructions.

2

KNOW YOUR COFFEE MAKER

(Product may be subject to change without prior notice)

W

ater tank cover

Detachable water

tank

Operation knob
Froth device

S

team tube

Power switch

Coffee/steam swit

ch

Metal funnel

(with mesh in it)

(with red power indicator)

(with green ready indicator)

Removable cup shelf

Drip tray

1. Pour water into water tank, the water level should not exceed the “MAX” mark in the tank. Then close

2. Set steel mesh into metal funnel (no coffee in steel mesh), make sure the tube on the funnel aligns with

3. Place an espresso cup (your cup) on removable cup shelf. Make sure the operation knob is on the “O”

4. Connect to power source, press the power switch to the lower position which is the “ON” position. The

5. Press down the Coffee/steam button to the higher position which is the “ ” position, waiting for a

3

BEFORE THE FIRST USE

To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with water as follows:

the water tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning, you can fill the tank with water
firstly, and then put the tank into the appliance.

groove in the appliance, then insert the funnel into the appliance from the “INSERT” position, and you can
fix them into coffee maker firmly by turning it anticlockwise until it is at the “LOCK” position.

position.
Note: the appliance is not equipped with jug, please use your jug or coffee cup.

power indicator will be illuminated. The appliance will start heating

moment, until the ready indicator lights, it shows the pre-heating is finished. Turn the operation knob to the

“ ” position. The water will flow out.

6. After about one minute, turn the operation knob to the “O” position to stop brewing, you can pour the

1. Remove the detachable tank and open the tank cover to fill it with desired water, the water level should

2. Set steel mesh into metal funnel (without coffee powder), make sure the tube on the funnel aligns with

3. Place an espresso cup (your cup) on removable cup shelf.

4. Then connect the appliance to power source. Make sure the operation knob is on the “O” position.

5. Press down the ON/OFF button to the lower position which is the “ ” position. The red indicator will

be illuminated.

6. The appliance will start heating.

7. Press down the Coffee/steam button to the higher position which is the “ ” position, waiting for a

1. Remove the metal funnel by turning it in clockwise, set steel mesh into metal funnel. Add coffee

2. Then insert the funnel into the appliance from the “INSERT” position and release the press bar, and

3. Pour out the hot water in the cup. Then place the hot cup (your cup) on removable cup shelf.

4

water in container out then clean them thoroughly, now you can start brewing.
Note: There may be noise when pumping the water on the first time, it is normal, the appliance is releasing
the air in the appliance. After about 20s, the noise will disappear.

PREHEATING

To make a cup of good hot Espresso coffee, we recommend you shall preheat the appliance before making
coffee, including the funnel, steel mesh and cup, so that the coffee flavour can not be influenced by the cold
parts.

not exceed the “MAX” mark in the tank. Then place t he tank into the appliance properly.

groove in the appliance, then insert the funnel into the appliance from the “INSERT” position, and you
can fix them into coffee maker firmly by turning it anticlockwise until it is at the “LOCK” position.

moment, until the ready indicator lights, it shows the pre-heating is finished.

MAKING ESPRESSO

powder to steel mesh with measuring spoon, a spoon of coffee powder can make about a cup of
top-grade coffee, then press the ground coffee powder tightly with the tamper.

you can fix them into coffee maker firmly by turning it anticlockwise until it is at the “LOCK”
position.

4. At the time, the ready indicator is illuminated, turn the operation knob to the “ ” position. The

coffee will flow out.

Note: During brewing coffee or making steam, it is normal that the green indicator is likely to
extinguish, it only means that the heater is heating up to keep the temperature at the standard range.

5.You should turn the operation knob to the “O” position when desired coffee is obtained or the colour of
coffee changes weak obviously, then press the power switch to the higher switch, the power indicator
and ready indicator go out and the coffee maker stops working, your coffee is ready now.

WARNING: Do not leave the coffee maker unattended during making the coffee, as you need operate
manually sometimes!

6. A

fterfinishingmakingthecoffee,youcantakethemetalfunnel

thec

offeeresidue

out w

iththesteelmeshpressed

by pr

essbar.

out by t

urningitclockwise,then

pour

7. Let them cool down completely, then rinse under running water.

1、Prepare espresso first with container big enough according to the part “MAKE ESPRESSO COFFEE”,

2、Press the coffee/steam switch to lower position which is the position, waiting for until the ready

3、Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are recommended to

4、Insert the froth device into the milk about two centimetre, then turn the operation knob to the “ ”

4. Dip the steam wand without froth device sleeve into the liquid to be heated or the intended froth milk.

T

urnthe

ope

ration

knob tothe“ ” pos

ition

.

5

MAKING CAPPUCCINO

You get a cup of cappuccino when you top up a cup of espresso with frothing milk.

Note: during making steam, the metal funnel must be assembled in position.

Method:

make sure that the operation knob is at the “O”.

indicator is illuminated.

use whole milk at refrigerator temperature (not hot!).

Note: In choosing the size of jug, it is recommended the diameter is not less than 70±5mm, and bear
in mind that the milk increases in volume by 2 times, make sure the height of jug is enough.

position, steam will come out from the steam outlet. Froth milk in the way moving vessel round from
up to down.

5. When the required purpose is reached, you can turn the operation knob to the “O” position.

Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not to
hurt!

6. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.

7. Press the power switch to the higher position to cut off the power source.

Note: after making steam, we recommended you allow the maker to cool down at least for 5 min before
making coffee again. Otherwise burnt odor may occur in your Espresso coffee.

PRODUCING STEAM TO HEAT LIQUIDS OR BEVERAGE

The steam wand can be used to make hot beverages like drinking chocolate, water or tea.

Method:

1. Remove the detachable tank and fill it with desired water, the water level should not exceed the “MAX”

mark in the tank. Then place the tank into the appliance properly.

2. Then connect the appliance to power source. Press the power switch to the lower position, the power

indicator will illuminated.

3. Press the coffee/steam switch to higher position which is the position, waiting for until the ready

indicator is illuminated.

5. When the required temperature is reached, you can turn the operation knob to the “O” position.

7. Press the power switch to the “O” position to cut off the power source.

CLEANING AND MAINTENANCE

1、Cut off power source and let the coffee maker cool down completely before cleaning.

2、Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip tray and

removable shelf regularly then dry them.

3、Detach the metal funnel by turning it clockwise, get rid of coffee residue inside, then you can clean it

4、Clean all the attachments in the water and dry thoroughly.

1. To make sure your coffee maker operating efficiently, internal piping is cleanly and the peak flavor of

coffee, you should clean away the mineral deposits left every 2-3 months.

2. Fill the tank with water and descaler to the MAX level ( the scale of water and descaler is 4:1, the detail

refers to the instruction of descaler. Please use “household descaler”, you can use the citric acid (obtainable

from chemist’s or drug stores) instead of the descaler (the one hundred parts of water and three parts of citric

acid).

3. According to the program of pre-heating, put the metal funnel (no coffee powder in it) and carafe (jug) in

place. Brewing water per “ PRE-HEATING”.

8. Restart the unit and repeat the steps of 4-7 at least 3 times.

9. Then brewing coffee (no coffee powder) with tap water in the MAX level, repeat the steps of 4-7 for 3

times (it is not necessary to wait for 15 minutes in step of 7), then brewing until no water is left in the tank.

S

ymptom

C

ause

C

orrections

6

Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning.

with cleanser, but at last you must rinse with clear water.

CLEANING MINERAL DEPOSITS

4. Press the power switch to the lower position which is the “ON” position. The power indicator will be
illuminated. The appliance will start heating.

5. Press down the Coffee/steam button to the higher position which is the “ ” position, waiting for a

moment, until the ready indicator lights, it shows the pre-heating is finished.

6. Turn the operation knob to the “ ” position and make two cups coffee (about 2Oz). Then turn it to the

“O” position.

7. Press the coffee/steam switch to lower position which is the position, waiting for until the ready

indicator is illuminated. Turn the operation knob to the “ ”position and make steam for 2min, then turn

the operation knob to the “O” position to stop making steam. Press the power switch to the higher position to
stop the unit immediately, make the descaler deposit in the unit at least 15 minutes.

TROUBLE SHOOTING

Water leaks from the bottom of
coffee maker.

There is much water in the drip
tray.

Please clean the drip tray.

The coffee maker is malfunction.

Please contact with the
authorized service facility for
repairing.

Acid (vinegar) taste exists in

Espresso coffee.

No clean correctly after
cleaning mineral deposits.

Clean coffee maker per the
content in “before the first use”
for several times.

The coffee powder is stored in a
hot, wet place for a long time.
The coffee powder turns bad.

Please use fresh coffee powder,
or store unused coffee powder in
a cool, dry place. After opening a
package of coffee powder, reseal
it tightly and store it in a
refrigerator to maintain its
freshness.

The coffee maker cannot work
any more.

The power outlet is not plugged
well.

Plug the power cord into a wall
outlet correctly, if the appliance
still does not work, please
contact with the authorized
service facility for repairing.

The steam cannot froth.

The ready indicator is not
illuminated.

Only after the ready indicator is
illuminated, the steam can be
used to froth.

The container is too big or the
shape is not fit.

Use high and narrow cup.

You have used skimmed milk

Use whole milk or half-skimmed
milk

Do not take apart the appliance by yourself if the cause of failure is not found, you had better contact

Environment friendly disposal

You can help protect the environment!
Please remember to respect the local
regulations: hand in the non-working
electrical equipments to an appropriate
waste disposal center.

7

certified serving center.

Aicok Home Essentials Live Comfortable

Shenzhen Impression E-commerce Co.,Ltd
Booth No.3H012,Trading Plaza,No.5,Huanan city,
Pinghu Street,Longgang District,Shenzhen,China
Facebook Page: https//www.facebook.com/aicoks/

Website:www.aicok.cc

Made In China