Agio International Round Inlaid Glass Table User Manual

IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!

Step 1: Unpack and identify parts.

Carefully remove glass and set aside until Step 5. Lay glass
flat--do not stand glass on edge. Remove protective materials
and set parts on a flat, non-abrasive surface. Identify all parts
packed in carton against the parts list. If you are missing any
parts, or are unsure how to proceed with assembly, call our
Customer Service Center at 1-800-416-3511. Do not attempt

to assemble the table if any parts are missing or damaged.

Step 2:Attach legs to the rim.

Place the table rim (without the glass) upside down on a
non-abrasive surface to avoid scratching the top of the rim.
Align the holes at the top of each table leg to the holes in
table rim. Attach each leg to the table rim using a washer
and a bolt as shown in illustration below. Hand tighten
only enough to hold legs in place. Do not tighten

completely at this time. Some adjustments may be
necessary to ensure the table legs aligned properly.

Step 3:Build the leg assembly.

Attach the leg connector bracket to the legs guiding the bolts
(already in place in the center portion of the table leg)
through the holes in the leg connector bracket. Attach using
the washers and nuts. Hand tighten, turning 3-4 revolutions
only. Do not tighten completely at this time as some

adjustments may be necessary to ensure table legs are
properly aligned.

PARTS LIST DESCRIPTION

GLASS TOP

TABLE RIM

LEG CONNECTOR
BRACKET

TABLE LEG

BOLT

NUT

WASHER

QTY./PCS

1

1

1

4

4

8

12

Step 4:Tighten all nuts and bolts.
Important Note: Each nut and bolt must be tightened a few

revolutions at a time. In order to apply even pressure to all
nuts and bolt joints, it is recommended that you work cross
corner (in "x" fashion). Use the Hex Bolt Driver and Hex
Wrench provided. Cover all nuts and bolts with PVC covers.

Step 5: Preparing table for use.

With the help of another person, carefully turn the table in
the upright position. Note the clear bumpers spaced evenly
throughout the inside the table rim. Carefully place glass inside
the table rim, resting the glass on the clear bumpers. Your
table is now ready for use. If you have any questions, please
call our Customer Service Center at 1-800-416-3511.

HEX WRENCH

HEX BOLT DRIVER

PVC BOLT COVER

PVC NUT COVER

MODEL # 55-48-22-43

1

1

4

8