Agilent U1171A User guide

Agilent U1171A Magnetic Hanging Kit Operating Instructions
This magnetic hanging kit is designed to be used with the Agilent U1240 Series, U12 50 Series, U1230 Series, and U1270 Series handheld digital multimeters.
The included bracket is only for use with the Agilent U1241/U1242B handheld digital multimeter.
Assistance
For technical assistance, please contact the nearest Agilent Sales Office or visit the Agilent website at www.agilent.com/find/assist for further information.
Operation
Follow the steps below for the Agilent U1240 Series assembly.
1) Tie the strap to the adapter.
3) Snap the adapter tightly to secure the connection.
2) Insert the adapter to the instrument.
4) To disassemble, pull out the adapter.
Follow the steps below for the Agilent U1250 Series assembly.
1) Flip the stand upwards and over its maximum reach until it is detached from its hinge.
2) Flip the stand over so that the stand’s inner surface is facing the meter’s rear.
3) Press the stand down into its hinge.
4) Tie the strap to the hinge.
Follow the steps below for the Agilent U1230 Series assembly.
1) Flip the stand upwards and over its maximum reach until it is detached from its hinge.
2) Flip the stand over so that the stand’s inner surface is facing the meter’s rear.
3) Tie the strap to the hinge.
Follow the steps below for the Agilent U1270 Series assembly.
1) Insert the strap through the opening in the meter’s rear.
2) Tie the strap to the meter’s rear.
Print Date: 26 April, 2013
U1171-90100
Loading...