user manual
CompactMobile2
The Look2012:
has changed!
Register |
your |
||||
|
2: |
||||
|
|
|
|
||
Compact |
Mobile |
||||
|
|
.com |
|||
|
|
|
|
||
|
-amps |
||||
.aer |
|
|
|
||
www |
|
|
|
Service |
|
> Customer |
|||||
|
|||||
1
Compact Mobile2 |
|
|
user manual |
Contents |
Page |
|
|
1. Introduction |
3 |
|
|
2. Safety Instructions |
4 |
|
|
3. Controls and connections |
5 |
3.1 Front side |
5 |
3.2 Rear side |
6 |
|
|
4. Starting up |
7 |
4.1 Cabling and switching-on |
7 |
4.2 Level adjustment |
7 |
|
|
5. Functional characteristics |
7 |
5.1 Equalization |
7 |
5.2 Effects |
8 |
5.3 Footswitch |
8 |
5.4 Phantom powering |
8 |
5.5 Battery operation and care |
9 |
|
|
6. Technical specificatios |
10 |
|
|
7. Circuit diagram |
12 |
|
|
2
1. Einleitung
Welcome to B!
Thank you for purchasing the Compact Mobile2.
The Compact Mobile2 is a professional, compact and powerful amplifier, specially designed for the amplification of acoustic instruments, but equally suitable for electric instruments and voice, furthermore you can add a playback-signal to your performance. The internal battery allows you to operate your Compact Mobile2 up to 4 hours without connecting the amp to the mains.
All AER-systems are subtly dynamically controlled which ensures absolute reliability in full load operation despite strikingly small sizes and little weight.
Read on and have fun using your Compact Mobile2!
3
2. Safety instructions
The following guidelines shall help minimize the risk of injury through fire or electric shock.
1.Carefully read these safety notes before you use the device!
2.Keep these safety notes in a safe place.
3.Pay attention to all warnings, instructions and additional texts on the unit.
4.Do not install or use your device in close proximity to water or if you are wet yourself.
5.Use your device in a safe place where nobody can step on cables or trip over and damage them.
6.Always pull the mains plug before cleaning your device. Use only a dry cloth for cleaning. Avoid the use of detergents and do not let any liquids seep into the unit.
7.Never install your device close to units with strong electromagnetic fields such as large mains transformers, revolving machines, neon illumination etc. Do not lay signal cables parallel to power current cables.
8.There are no user-serviceable components inside the unit. To avoid the risk of an electric shock, the unit must not be opened. All maintenance, adjustment and repair works should be carried out by qualified staff only. Any unauthorized tampering will void the 2-year warranty.
9.In keeping with the EMV regulations screened cables with correctly fitted connectors must be used for all signal connections.
10.Always use an earthed power supply with the correct mains voltage. If you are in doubt about the power outlets ground, have it checked by a qualified technician.
11.Cable up your device only when it is powered off.
4
Loading...