AEG-Electrolux EWB75100W, EWB65110W, EWB75110W User Manual

user manual
Washing Machine
EWB 75110 W - EWB 65110 W
2 electrolux
Control panel
1. The control panel
2. Lid handle
3. Filter access cover
4. Adjustable levelling feet
1. Programme selector
2. Pushbuttons and their functions
3. Lights of cycle progress
4. “Start/Pause” pushbutton
5. “Delay start” pushbutton
Dispenser box
Prewash Wash
Softener (do not fill above the MAX symbol M )
Safety Information
Please read these points carefully before installing and using your appliance. Keep this user manual with your appliance.
General safety
• Do not modify or attempt to modify this appli­ance. This would put yourself in danger.
• Ensure that all coins, safety pins, brooches, screws etc have been removed before starting a washing programme. If left in washing, they can seriously damage the appliance.
• Use the recommended quantity of detergent.
• Put small items together (socks, belts etc.) in a small linen bag or pillow case.
• Unplug and close inlet hose tap after using ap­pliance.
• Always disconnect the power supply from the appliance before cleaning or maintenance.
• Do not machine wash clothes with ribbing, un­finished or torn material.
Installation
• Unpack or ask for the appliance to be unpacked immediately upon delivery. Check the outside of the appliance is not damaged in any way. Report all transit damage to your retailer.
• Remove all transit bolts and packaging before installing the appliance.
• Connection to the water supply must be carried out by a qualified plumber.
• If your domestic electrical circuit needs adapting to allow the appliance to be plugged in, use a qualified electrician.
• Ensure that, after installation, the power cable is not trapped under the appliance.
• If the appliance is installed on carpeted floor, ensure that the carpet does not obstruct any ventilation ducts located at the base of the ap­pliance.
• The appliance must be equipped with an earth­ed power plug which conforms to regulations.
• Before connecting your appliance to the power supply, carefully read the instructions in the chapter entitled “Electrical connection”.
• Replacing the power cable should only be car­ried out by an authorised service engineer.
electrolux 3
• The manufacturer cannot be held responsible for any damage resulting from incorrect installa­tion.
Precautions to be taken against frost
If your appliance is exposed to temperatures below 0°C, the following precautions must be taken:
• Close the tap and disconnect the inlet hose.
• Place the end of this hose and the drain hose in a basin on the floor.
• Select the Drain programme let it run until the end of the cycle.
• Disconnect the appliance from the power supply by turning the programme selector to “Stop”
.
• Unplug the appliance.
• Replace the inlet hose and drain hose.
This way, the water remaining in the hoses will be drained away, avoiding any ice formation which would damage your appliance. Before turning your appliance on again, ensure that it is installed in an area where the temperature will not fall below freezing.
Use
• Your appliance is intended for normal domestic use. Do not use the appliance for commercial or industrial purposes or for any other purpose.
• Refer to the instructions on the label of each item before washing.
• Do not put items into the washing machine which have had stains removed with petrol, al­cohol, trichlorethylen etc. If such stain removers have been used, wait until the product has evaporated before putting these items into the drum.
• Empty pockets and unfold items.
• This appliance is not intended for use by per­sons (including children) with reduced physical, sensory or mental capabilities, or lack of expe­rience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
How to run a wash cycle?
Using for the first time
• Ensure the electrical and water connec­tions comply with the installation instruc­tions.
• Remove the polystyrene insert and all other items inside the drum.
• Run an initial wash cycle at 90°C, without any washing but with detergent to clean the water tank.
4 electrolux
Daily use
Loading washing
• Open the lid of the appliance.
• Open the drum by depressing the locking button A: The two shutters unlock automati­cally.
• Load the washing, close the drum and the lid of your washing machine.
Warning! Before closing the lid of your appliance, ensure that the drum is properly
closed :
• When the two shutters are closed,
• locking button A released.
Proportioning of detergents
Pour the amount of washing powder into the washing have selected the “prewash” option. Pour fabric softener into the compartment
Selection of desired programme
Turn the programme selector to the required pro­gramme. The “Start/Pause” pushbutton flashes green. If you turn the programme selector to another pro­gramme while a cycle is in progress, the appliance will ignore the new selected programme. The “Start/Pause” pushbutton flashes red for a few seconds.
Selecting the spin speed
Press the “Spin” speed. The maximum spin speed is 700 rpm (EWB75100W) or 600 rpm (EWB65100W). At the end of the programme, if you have selected
“Rinse hold”
or “Drain” programme to finish the cycle and
empty the water.
Selecting options
You must select the different options after select­ing the programme and before pressing the “Start/ Pause” pushbutton (see “Programmes table”). Press the desired button(s) : the corresponding lights come on. If pressed again, the lights go out. If one of the options is not compatible with the se­lected programme, the “Start/Pause” pushbutton flashes red.
“Prewash” option
The appliance runs a prewash at 30°C max.
and prewash compartments if you
, you then need to select a “Spin”
A
if necessary.
pushbutton to change the spin
“Daily” option
This option allows to run a wash cycle of lightly soiled laundry at reduced time.
“Super quick” option
The washing time will be reduced depending on the programme selected.
“Rinse plus” option
The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas.
Temporary : Press the “Rinse plus” ton. The option is only active for the selected pro­gramme.
Permanent : Hold down the “Spin” tion” pushbuttons for a few seconds. The option is permanently activated, even if the appliance is switched off. To deactivate it, repeat the process.
“Delay start”
This option allows you to delay the start of a wash programme by 3, 6 or 9 hours by pressing the
“Delay start” pushbutton You can change or cancel the delayed start time at any time before you press the “Start/Pause” pushbutton by pressing the “Delay start” pushbut-
ton
again (when all indicators are off, the wash programme will start immediately). If you have already pressed the “Start/Pause” pushbutton and you want to change or cancel the delayed start, proceed as follows :
• To cancel the delay start and start the cycle im-
mediately, press “Start/Pause” and then “Delay start”
• To change the timer delay period, you must go
The lid will be locked during the delayed start time. If you need to open it, you must first pause the ap­pliance by pressing the “Start/Pause” pushbutton. After closing the lid again, press the “Start/Pause” pushbutton.
Start of the programme
Press the “Start/Pause” pushbutton to start the cycle. The corresponding light will come on green. It is normal for the programme selector to remain stationary during the cycle. The light correspond­ing to the current cycle is illuminated.
Interrupting a programme Adding washing during the first 10 minutes
Press the “Start/Pause” pushbutton : the corre­sponding light will flash green while the appliance
. Press “Start/Pause” to start the cycle.
through the “Stop” position ramme your cycle.
+ : Prewash + Wash
+ : Rinses + Spin
: End of cycle
.
pushbut-
and “Op-
and reprog-
Loading...
+ 8 hidden pages