How it Works
AEG-Electrolux
Loading...
ESL63010
User Manual
44 pgs1.75 Mb0

AEG-Electrolux ESL63010 User Manual

user manual
ESL 63010
Dishwasher
156997950en prov.qxp 1/22/2007 12:31 PM Page 1
We were thinking of you
when we made this product
156997950en prov.qxp 1/22/2007 12:31 PM Page 2
welcome to the world of Electrolux electrolux 3
Welcome to the world of Electrolux
156997950en prov.qxp 1/22/2007 12:31 PM Page 3
Safety information 5
Product description 7
Control panel 8
First use 11
Daily use 15
Washing programmes 24
Care and cleaning 25
Something not working 27
Technical data 30
Hints for test institutes 32
Installation 33
Environment concerns 36
Guarantee/Customer Service 37
Contents
The following symbols are used in this manual:
Important information concerning your personal safety and information on how to avoid damaging the appliance.
General information and tips
Environmental information
4 electrolux contents
156997950en prov.qxp 1/22/2007 12:31 PM Page 4
safety information electrolux 5
In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety.
Correct use
● This dishwasher is only intended
for washing household utensils suitable for machine washing.
● Do not put any solvents in the
dishwasher. This could cause an explosion.
● Knives and other items with sharp
points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket.
● Only use products (detergent, salt
and rinse aid) suitable for dishwashers.
● Avoid opening the door whilst the
appliance is in operation, hot steam may escape.
● Do not take any dishes out of the
dishwasher before the end of the dishwashing cycle.
Safety information
● After use, isolate the appliance
from the power supply and turn off the water supply.
● This product should be serviced
only by an authorised service engineer, and only genuine spare parts should be used.
General safety
● Dishwasher detergents can cause
chemical burns to eyes, mouth and throat. Could endanger life! Comply with the safety instructions of the dishwasher detergent manufacturer.
● The water in your dishwasher is
not for drinking. Detergent residues may still be present in your machine.
● Ensure that the door of the
dishwasher is always closed when it is not being loaded or unloaded. In this way you will avoid anybody tripping over the open door and hurting themselves.
● Do not sit or stand on the open
door.
Child safety
● This appliance is designed to be
operated by adults. Don’t allow children to use the dishwasher unsupervised.
● Keep all packaging well away from
children. There is risk of suffocation.
● Keep all detergents in a safe place
out of children’s reach.
● Keep children well away from the
dishwasher when the door is open.
156997950en prov.qxp 1/22/2007 12:31 PM Page 5
6 electrolux safety information
Installation
● Check your dishwasher for any
transport damage. Never connect a damaged machine. If your dishwasher is damaged contact your supplier.
● All packaging must be removed
before use.
● Any electrical and plumbing work
required to install this appliance must be carried out by a qualified and competent person.
● For safety reasons it is dangerous
to alter the specifications or attempt to modify this product in any way.
● Never use the dishwasher if the
electrical supply cable and water hoses are damaged; or if the control panel, work top or plinth area are damaged such that the inside of the appliance is freely accessible. Contact your local Service Force centre, in order to avoid hazard.
● All sides of the dishwasher must
never be drilled to prevent damage to hydraulic and electric components.
For electrical and water connection carefully follow the instructions given in specific paragraphs.
156997950en prov.qxp 1/22/2007 12:31 PM Page 6
product description electrolux 7
Product description
Upper basket
Water hardness dial
Salt container
Detergent dispenser
Rinse aid dispenser
Rating plate
Filters
Lower spray arm
Upper spray arm
1
2
3
4
5
6
7
8
9
156997950en prov.qxp 1/22/2007 12:31 PM Page 7
8 electrolux control panel
Control panel
On/Off button
Delay start button
Programme selection / cancel button
Indicator lights
1
2
3
4
Indicator lights
End of programme
Illuminates when a washing programme has ended. It also has added functions of visual signalling as:
- the setting of the water softener,
- activation/deactivation of the audible signals,
- intervention of an alarm due to the malfunction of the machine.
Salt
Illuminates when the special salt has run out.
Rinse aid
Illuminates when the rinse aid has run out.
156997950en prov.qxp 1/22/2007 12:31 PM Page 8
control panel electrolux 9
The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer.The function of the machine is not affected.
Setting mode
The appliance is in setting mode when all programme indicator light are off and end of programme indicator light is flashing.
Always remember that when:
- setting the water softener,
- activating/deactivating the audible signals,
the appliance MUST be in setting mode. If a programme indicator light is illuminated and end of programme indicator light is illuminated with fixed light, the last performed or selected programme still set. In this case, to return to setting mode, the programme has to be cancelled.
1. Press and hold the programme selection/cancel button until the light of the set programme turns off and the end of programme indicator light is flashing.
2. Release the programme
selection/cancel button.
Factory setting: audible signals
activated. It is possible to deactivate the audible signals, using the programme
selection/cancel button.
Audible signals
Audible signals have been introduced to help indicate which operations the dishwasher is performing:
- end of programme
- intervention of an alarm due to
malfunction
Deactivation/activation of the audible signals
1. Press the On/Off button. The dishwasher must be in setting mode.
2. Press and hold the programme selection/cancel button until programme light 1 flashes and programme light 2 illuminates with a fixed light.
3. Press programme selection/cancel button again, programme light 1 illuminates with a fixed light and programme light 2 starts flashing.
156997950en prov.qxp 1/22/2007 12:31 PM Page 9
10 electrolux control pane
4. Wait until:
- programme light 1 turns off,
- programme light 2 goes on flashing
- the end of programme indicator
light illuminates with a fixed light, indicating that the audible signals
are activated.
5. To deactivate the audible signals, press the programme
selection/cancel button again: the end of programme indicator light
turns off indicating that the audible signals are deactivated.
6. To memorise the operation, switch off the dishwasher.
To activate again the audible signals simply follow the above operations until the end of programme indicator light illuminates.
156997950en prov.qxp 1/22/2007 12:31 PM Page 10
Before using your dishwasher for the first time:
● Ensure that the electrical and
water connections comply with the installation instructions
● Remove all packaging from inside
the appliance
● Set the water softener
● Pour 1 litre of water inside the salt
container and then fill with dishwasher salt
● Fill the rinse aid dispenser
When using combi detergents tablets («3 in 1», «4 in 1», «5 in 1», etc...) follow the instructions given in "Use of detergent".
First use
Set the water softener
The dishwasher is equipped with a water softener designed to remove minerals and salts from the water supply, which would have a detrimental or adverse effect on the operation of the appliance.
The higher the content of these minerals and salts, the harder your water is.
Water hardness is measured in equivalent scales, Clarke degrees (°dH), French degrees (°TH) and mmol/l (millimol per litre - international unit for the hardness of water).
The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.
*
no salt is necessary
Water hardness
Clarke °TH mmol/l manually electronically
Adjusting the water
hardness setting
Use of
salt
64 - 88 91 - 125 9,0 - 12,5 2 level 10 yes
53 - 63 76 - 90 7,6 - 8,9 2 level 9 yes
46 - 52 65 - 75 6,5 - 7,5 2 level 8 yes
36 - 45 51 - 64 5,1 - 6,4 2 level 7 yes
28 - 35 40 - 50 4,0 - 5,0 2 level 6 yes
23 - 27 33 - 39 3,3 - 3,9 2 level 5 yes
18 - 22 26 - 32 2,6 - 3,2 1 level 4 yes
13 - 17 19 - 25 1,9 - 2,5 1 level 3 yes
5 - 12 7 - 18 0,7 - 1,8 1 level 2 yes
< 5 < 7 < 0,7 1 level 1 no
*
first use electrolux 11
156997950en prov.qxp 1/22/2007 12:31 PM Page 11
12 electrolux first use
The water softener must be set in both ways: manually, using the water hardness dial and electronically.
Setting manually
The dishwasher is factory set at position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the dishwasher.
3. Turn the water hardness dial to position 1 or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher must be in setting mode.
2. Press and hold the programme selection/cancel button until programme light 1 flashes and programme light 2 illuminates with a fixed light.
3. Wait until:
- programme light 2 turns off,
- programme light 1 goes on flashing
- the end of programme indicator light starts flashing: the nimber of flashes corresponds to the current level set. The flashing is repeated with a pause of a few seconds. Examples: 5 flashes, pause, 5 flashes, pause, etc... =
level 5.
4. To change the level, press the
programme selection/cancel
button. Each time the button is pressed the level increase. (level 1 follows level10). The end of programme light indicates the new setting.
5. To memorise the operation, switch off the dishwasher by pressing the On/Off button.
156997950en prov.qxp 1/22/2007 12:31 PM Page 12
first use electrolux 13
Filling with dishwasher salt
Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion.
To fill:
1. Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise.
2. Pour 1 litre of water inside the container (this is necessary only
before filling with salt for the first time).
3. Using the funnel provided, pour in the salt until the container is full.
4. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket.
5. Replace the cap tightly turning it clockwise until it stops with a click.
Do not worry if water overflows from the unit when filling with salt, this is quite normal.
156997950en prov.qxp 1/22/2007 12:31 PM Page 13
14 electrolux first use
Filling with rinse aid
Rinse aid ensures thorough rinsing, and spot and streak free drying.
Rinse aid is automatically added during the last rinse.
1. Open the container by pressing the release button (A).
2. Add the rinse aid in the container. The maximum level for filling is indicated by "max".
The dispenser holds about 110 ml of rinse aid, which is sufficient for between 16 and 40 dishwashing cycles, depending upon the dosage setting.
According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage).
The dose is factory set in position 4.
Increase the dose if there are drops of water or lime spots on the dishes after washing.
Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades.
3. Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.
Only use branded rinse aid for dishwashers.
Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.
156997950en prov.qxp 1/22/2007 12:31 PM Page 14
Loading...
+ 30 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use