AEG-Electrolux ESF2410 User Manual
Contents
For the User
Safety information 3
Description of the appliance 4
- Rinse conditioner dispenser
- Spray arm
- Coarse filter
- Fine filter
- Detergent dispenser
The control panel 5
- Audible signals
Loading the dishwasher 6
- How to load the dishes
Programme chart 7
Using the appliance 8
- Starting the programme
- Interrupting the programme temporarily
- Cancelling the programme
- Cancelling the drying phase
- Setting the delay start
- Switching the dishwasher off / Unloading
- Cleaning the dishwasher
For the Installer
Technical specifications 13
Unpacking 14
- Damages
- Use
- Protecting the machine against freezing
Installation 15
- Positioning
- Water inlet
- Water drainage
- Electrical connection
In the event of a fault 9-10
Information for test centres 11
Service 12
- Service and spare parts
Guide to use the instruction book
The following symbols will be found in the text to guide you throughout the instructions:
Safety instructions
Step by step instructions
Hints and tips
Environmental information
- 2 -
Safety information
Before installing and first using the dishwasher, read this instruction booklet carefully, including its
h
ints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all
people using the dishwasher are thoroughly familiar with its operation and safety features.
Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so
that everyone using it through its life can be properly informed on appliance use and safety.
Installation and servicing
● All installation and service work done on the product
must be carried out by a qualified technician. Work
performed by persons with inadequate knowledge may
adversely affect the satisfactory functioning of the
product and may cause personal injury or damage.
Before any work is carried out on the dishwasher, it must
be isolated from the electrical supply, by unplugging
the power cord or removing the fuse.
● Water connection shall be made via an easily accessible
stopcock.
● The power cord must be plugged into an earthed
socket, which need to be easily accessible. Permanent
installation must only be carried out by an authorised
electrician.
● If the power cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
● Make sure that the power cord is not nipped or otherwise
damaged and that the hoses do not get crushed or
kinked when moving the dishwasher in connection
with installation or cleaning etc.
● Servicing and possible repairs must be carried out by
a service company authorised by the manufacturer.
Use only spare parts supplied by these. Never try to
repair the dishwasher yourself.
Child Safety
● The dishwasher should be used by adults only. Do not
let children play with the controls or other parts of it.
● Remember that the plastic bags included in the
packaging can be fatal playthings for small children.
● Keep all detergents in safe place out of children´s
reach.
● Prevent children from sitting, swinging or standing
on the open door.
● Do not place sharp knives with their points upwards.
It is much safer to lay them horizontally in the basket.
● Ensure that the door of the dishwasher is always closed
when it is not being loaded or unloaded. In this way you
will avoid anybody injuring themselves on the open
door, if the dishwasher is placed under the worktop.
● If you take any dishes out of the machine before the
end of the dishwashing cycle, it is extremely important
to rinse them thoroughly under running water to remove
any remaining detergent.
● In the event of flooding or leakage, shut off the water
supply immediately by closing the stopcock and disconnect the power supply by unplugging the power cord
or removing the fuse. When removing the electrical
plug, grip the plug, not the lead.
● There is always a certain risk of leakages in any machine
connected to a water supply, no matter what water safety
features it may have. Therefore it is advisable always to
turn off the water supply tap when the machine is not in use.
Disposal
- packaging:
All materials used in packaging this appliance are
environmentally-friendly. The various plastics used
are identified and can be recycled:
● PE stands for polyethylene, which is used for the
bag around the appliance and the bag in which these
instructions were supplied.
● PS stands for polystyrene (moulded), which is used
for the sections of packaging needed to cushion the
appliance.
The cardboard components of the packaging are made
from recyclable paper and should be taken to a collection
point for recycling.
- old apparatus:
During Use
● This dishwasher is designed solely for washing house-
hold utensils suitable for machine washing. Using it for
other purposes could lead to physical injury or damage
to property and invalidate the guarantee.
● Avoid opening the door while the dishwasher is running,
as hot steam may escape.
● Only use detergent specifically designed for use in
dishwashers.
The symbol on the product or on its packaging indicates
that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
For more detailed information about recycling of this product, please contact your local council, your household
waste disposal service or the shop where you purchased
the product.
- 3 -
156 995 240
Description of the appliance
Rinse conditioner dispenser 1
Use of a rinse conditioner will result in cleaner and faster
drying of the load, since it helps water to run off. Too much
conditioner may result in streakiness, too little may cause
white spots. The dispenser holds about 140 ml. This is
enough for 40-70 wash cycles, depending on the dosage
setting. When the rinse conditioner level is approaching
the bottom of the scale it is time to refill the dispenser.
Adjust the dosage setting according to the hardness in the water. Begin with the lowest dosage
setting and increase if necessary by turning the
arrow clockwise.
1. Swivel out the filler trough.
Fill up with rinse conditioner until the level reaches
2.
up to the red mark on the level indicator tube; do
not overfill.
3.
Wipe off any spillage carefully to prevent excessive
foaming during the next wash programme.
4. Close the filler trough afterwards.
Do not fill the rinse aid dispenser with liquid
detergent.
Coarse filter 3
The purpose of the coarse filter is to catch large objects
such as toothpicks and pieces of eggshell. Make sure that
the filter is always clean. Lift it out and rinse it under running
water whenever necessary.
Fine filter 4
It is just as important to keep this filter clean. A dirty or
clogged filter will always impair washing efficiency. The
fine filter can easily be lifted out for cleaning when you
have removed the coarse filter.
Detergent dispenser 5
Consult the instructions on the detergent packet and fill
the compartment. Remember that the instructions usually
refer to full-size dishwashers, for example when using
detergent tablets, it is sufficient to use just half a tablet.
Only use detergents specially designed for
dishwashers.
Spray arm 2
It is important to keep all the holes in the spray arm clear.
A clogged hole can seriously affect washing efficiency. If
the spray arm needs cleaning, unscrew the nut clockwise,
remove the washer and lift off the spray arm. Clear the
holes and shake out any food remnants.
- 4 -
The control panel
Programme lamps
On/Off button
Programme selection/cancel button
is used to:
• select the programme
• deactivate/activate the audible signal
• cancel a dishwashing cycle
Delay start
button
1
Programme selection/
Cancel button
2
Control
lamps
Control lamps:
Shows that:
• Wash cycle in progress
• Drying in progress
• Programme cycle ended
The programme cycle ended lamp has also other functions
of visual signalling:
• when deactivating/activating the audible signal
• with malfunction of the machine
Audible signal
Audible signal have been introduced to help indicate
which operations the dishwasher is performing:
• end of washing programme
• malfunction of the machine
Deactivation/activation of the audible signal
The audible signal is activated when leaving the factory.
1. To deactivate the signal: With the dishwasher
switched off, press in the On/Off button. The
ended programme lamp flashes.
If one of the programme lamps is illuminated, this
wash programme is activated. The programme
must be deselected: press and hold the pro
gramme selection/cancel button for approx. 3
seconds. The programme lamp goes out and the
indicator for the ended programme cycle flashes
indicating that the programme has been cancelled.
-
- 5 -
2. Press the programme selection/cancel button
and hold it pressed until indicator lamp 1 starts
to flash and lamp 2 lights up.
3. Directly after press the programme button again,
lamp 1 will change from flashing to continual illumination and goes out after approx. 3 seconds.
Lamp 2 starts to flash and the indicator for the
ended programme cycle goes on. Press the button
once more and the lamp for the ended programme
cycle goes out. The audible signal is now off.
4. Press out the On/Off button to complete the setting.
To activate the function again, follow steps
above, until the lamp for the ended programme
cycle
goes on
again.
Loading...