Please read these user instructions carefully and
keep them to refer to later.
Please pass the user instructions on to any future
owner of the appliance.
The following symbols are used in the
text:
1 Safety instructions
Warning! Information that affects your personal safety.
Important! Information that prevents damage
to the appliance.
Please comply with these instructions. If you
do not, any damage resulting is not covered
by the warranty.
5 This appliance conforms with the following EU
Directives:
– 73/23/EEC dated 19.02.1973 Low Voltage Direc-
tive
– 89/336/EEC dated 03.05.1989 EMC Directive in-
clusive of Amending Directive 92/31/EEC
– 93/68/EEC dated 22.07.1993 CE Marking Directive
Correct use
• This appliance should be used only for normal domestic cooking and frying of food.
• The appliance must not be used as a work surface
or as a storage surface.
• Additions or modifications to the appliance are not
permitted.
• Do not place or store flammable liquids, highly inflammable materials or fusible objects (e.g. plastic
film, plastic, aluminium) on or near the appliance.
Child Safety
The cooking zones will become hot when you cook.
Therefore, always keep small children away from the
appliance.
For Australia:
The appliance is not intended for use by young children or infirm persons without supervision.
Young children should be supervised to ensure that
they do not play with the appliance.
Safety during use
• Remove stickers and film from the glass ceramic.
• There is the risk of burns from the appliance if used
carelessly.
• Cables from electrical appliances must not touch
the hot surface of the appliance or hot cookware.
• Overheated fats and oils can ignite quickly. When
cooking with fat or oil (e.g. chips) do not leave the
appliance unattended.
• Switch the cooking zones off after each use.
Safety when cleaning
• For cleaning, the appliance must be switched off
and cooled down.
• For safety reasons, the cleaning of the appliance
with steam jet or high-pressure cleaning equipment is not permitted.
How to avoid damage to the appliance
• The glass ceramic can be damaged by objects falling onto it.
• The edge of the glass ceramic can be damaged by
being knocked by the cookware.
• Cookware made of cast iron, cast aluminium or
with damaged bottoms can scratch the glass ceramic if pushed across the surface.
• Objects that melt and things that boil over can
burn onto the glass ceramic and should be removed straightaway.
• Do not use the cooking zones with empty cookware or without cookware.
General safety
• The appliance may only be installed and connected by trained, registered service engineers.
• Built-in appliances may only be used after they
have built in to suitable built-in units and work surfaces that meet standards.
• In the event of faults with the appliance or damage
to the glass ceramic (cracks, scratches or splits),
the appliance must be switched off and disconnected from the electrical supply, to prevent the
possibility of an electric shock.
• Repairs to the appliance must only be carried out
by trained registered service engineers.
4
Description of the Appliance
Cooking surface layout
Single cooking zone
1200W
Triple cooking zone
800/1600/2300W
Multi-purpose zone
1500/2400W
Control panelSingle cooking zone
1200W
Control panel layout
Lock
with pilot light
Outside/middle ring
On/Off
On/Off
with power indicator
Cooking zone indicators
Timer function
Display
Triple ring pilot light
Timer display
Timer
Heat setting selection
Double ring pilot
light
Outside ring
On/Off
5
Touch Control sensor fields
The appliance is operated using Touch Control sensor fields. Functions are controlled by touching sensor fields and confirmed by displays and acoustic
signals.
Touch the sensor fields from above, without covering
other sensor fields.
Sensor fieldFunction
On / OffTo switch the appliance on and off
Increase settingsIncreasing heat setting/ time
Decrease settingsDecreasing heat setting/ time
TimerTimer selection
LockLocking/unlocking the control panel
Triple ring switchTo switch outer rings
on and off
Multi-purpose zone switchTo switch the outside ring on and off
Displays
Display Description
Cooking zone is switched off
u Keep warm settingKeep warm setting is set
- Heat settingsHeat setting is set
Automatic warm up functionAutomatic warm-up function is activated
e FaultMalfunction has occurred
Residual heatCooking zone is still hot
Child safety deviceLock/child safety device is engaged
Safety cut-outSafety cut-out has been activated
Residual heat indicator
1 Warning! Risk of burns from residual heat. Af-
ter being switched off, the cooking zones need
some time to cool down. Look at the residual
heat indicator
.
3 Residual heat can be used for melting and
keeping food warm.
6
Operating the appliance
Switching the appliance on and off
Control panelDisplayPilot light
Switch onTouch for 2 seconds /
Switch offTouch for 1 second / none goes out
lights up
3 After switching on, within approx. 10 seconds
a heat setting or a function must be set, otherwise the appliance automatically switches itself off.
Setting the heat setting
Control panel Indicator
To increaseTouch
To decreaseTouch to
To switch offTouch and at the same time
u to
3 The keep warm setting u lies between
and . The keep warm setting can be set using or . It is used to keep food warm.
Switching the outside ring
on and off
By switching the outside rings on or off, the effective
heating surface can be matched to the size of the
cookware.
3 Before an outside ring can be switched on, the
inside ring must be switched on.
Triple cooking zoneSensor panelPower indicator
To switch on middle ringTouch
To switch on outside ringTouch
To switch off outside ringTouch
To switch off middle ringTouch
Roasting zoneSensor panelPower indicator
To switch on outside ringTouch
To switch off outside ringTouch for 1-2 secondsgoes out
for 1-2 seconds.One power indicator is lit.for 1-2 seconds.Two power indicators are lit.for 1-2 seconds.Second power indicator goes out.for 1-2 seconds.First power indicator goes out.
for 1-2 secondsis lit
7
Locking/unlocking the control panel
The control panel, with the exception of the “On/Off”
sensor field, can be locked at any time in order to
prevent the settings being changed e.g. by wiping
over the panel with a cloth.
Control panelDisplay
Switch onTouch (for 5 seconds)
Switch offTouch previously set heat setting
3 When you switch the appliance off, the locking
function is automatically switched off.
Using the automatic warm-up function
All cooking zones are equpped with an automatic
warm up function When setting a heat setting using
, when starting from, the cooking zone switches to full power for a certain amount of time and then
automatically switches back to the heat setting set.
Control panel possible heat set-
tings
Switch on
(only when starting at )
Switch offTouch to / u to
Not usedTouch to u to u
Touch to
Display
(after 5 seconds)
3 If during the automatic warm up a higher
heat setting is selected, e.g. from to , the
automatic warm up is adjusted.
3 If there is still residual heat on the cooking
zone (display ), the automatic warm up is
not performed.
The length of time that the automatic warm up function operates depends on the heat setting selected.
Heat settingLength of the automatic warm up [min:sec]
v0:30
11:00
21:40
u
34:50
46:30
510:10
62:00
73:30
84:30
9---
8
Using the child safety device
The child safety device prevents unintentional use of
the appliance.
Setting the child safety device
Step Control panel Display/Signal
1. Switch on the appliance
(Do not set a heat setting)
2.Touch until the signal soundsAcoustic signal
3.Touch
Appliance switches off. The child safety device is engaged.
Overriding the child safety device
The child safety device can be released in this way
for a single cooking session; it remains activated afterwards.
StepControl panelDisplay/Signal
1. Switch on the appliance
2.Touch and at the same time / acoustic signal
Until the appliance is next switched off, it can used as normal.
3 After overriding the child safety device, a heat
setting or a function must be set within
approx. 10 seconds, otherwise the appliance
automatically switches itself off.
Releasing the child safety device
Step Control panel Display/Signal
1.
2.Touch until the signal soundsAcoustic signal
3.Touch
Appliance switches off. The child safety device is released.
Switch on the appliance
9
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.