AEG-Electrolux E24WC160ES User Manual
Wine cellar
Cave à vin de vieillissement
Cava para envejecimiento
del vino
E24 WC 160 ES
C...
Use & Care Guide ................. GB
Notice d´instructions ................. FR
Manual de instrucciones ................. ES
825 12 50-00/5995421665
Thank you for choosing an Electrolux Wine Cellar !
Operating and Installation
Instructions for your Electrolux
Wine Cellar
Introduction
Thank you for choosing the Electrolux Wine Cellar .
Please read the following instructions carefully before
installing your new wine cellar . We trust you will be
completely satisfied with your purchase.
The wine cellar must be installed and used according to
these instructions in order for it to operate correctly and
economically.
Electrical connections
Y our winecellar operates on a single phase alternating
current.(AC) Please check that the voltage shown on
the serial plate corresponds to your power supply .
All wine cellars require a connection to an electrical
power source. Improper hook-up can result in a safety
hazard and potential damage to the product of contents! Proper installation, in accordance with the
manufacturer´s specifications and all local codes, is
the sole responsibility of the consumer. The manufacturer is not responsible for any installation expenses or
damages incurred due to improper installation. If you
are insure of your ability to safely connect electric
power to the unit, consult a licensed and insured
professional to perform all electrical work.
WARNING – THE WINE CELLAR
MUST BE GROUNDED.
Data plate
Check the data plate, inside the wine cellar at the top
left, to ensure you have received the right model.
The data plate shows details that you will need to
quote if you have to contact service personnel. It is a
good idea to make a note of them here.
Model Number ……………............................
Serial number ……………….........................
Purchase date ..............................................
Shipping damage
Inspect the wine cellar for shipping damage. You must
report any damage to the company responsible for the
delivery within the legal or stated time for this type of
product. If there is no such established report time, the
damage must be reported within seven days of
delivery .
Electrical leads must be routed and secured so
that they cannot come into contact with hot or
sharp part s of the wine cellar.
Accessories
Please check that the following accessories are
attached to the wine Cellar or in the separate
cardboard box for accessories which is placed inside
the wine cellar.
At the back:
1. Distance bar (to ensure distance to wall behind)
Accessories box:
1. Instruction manual
2. Handle + Socket head screwdriver ( 2 mm )
3. Drip tray
4. Shelf support
5. Storage shelf
6. Wooden bar (Installation see page 19)
Necessary additional tools not incuded
Questions ?
For toll-free telephone support in the U.S. and Canada:
1-877-4ELECTROLUX ( 1-877-435-3287 )
For online support and internet product information:
www.electroluxusa.com
1
5
2
1
3
6
1. Screwdriver (star quad )
2. Adjustable wrench
4
3
Installation
FIG. 1
WARNING This product is intended for indoor use
only. Installation or use of this product
outdoors, or in any area exposed to the
elements , may cause serious injury ,
product damage, or property damage.
Please read all instructions completely before attempting to install or operate the unit..
For best performance, air needs to circulate freely
over the cooling unit behind the wine cellar. The freestanding design of the cellar means that it should
stand at least 1” (25 mm) from the rear and side walls.
Allow a clearance of at least 4” (100 mm) above the
wine cellar.
Adjust the feet of the wine cellar so that it is level from
back-to-front and side-to side. Use a leveling tool if
necessary . FIG .1
Distance bar
Distance bar
1 3/16”
(30 mm)
Wall
1”
(25mm)
Rear
1”
(25mm)
1. Remove the shipping pallet on which your wine
cellar rests.
2. IMPORTANT ! Adjust the feet to allow a 1 3/16”
(30mm) clearance under the wine cellar
3. Attach the distance bar using the two screws at the
top back on each side of the cellar. The rod ensures
the correct distance to the wall behind. FIG 2.
Wall
4. For optimum performance, please place your wine
cellar far away from any source of heat
(radiator,range or intence sunlight) .
Please note that it must be possible to open the
wine cellar door at least 90° to allow the sliding
shelves to be pulled out.
5. Attach the driptray on the back as shown in
FIG 3a , 3b , 3c. . The screws are already attached
at the back.
FIG 3a FIG 3b
FIG 2
4
FIG 3c
Loading...