Before placing your new refrigerator into operation please read these
operating instructions carefully. They contain important information
for safe use, for installation and for care of the appliance.
Please keep these operating instructions for future reference. Pass them
on to possible new owners of the appliance.
These operating instructions are for use with several technically
comparable models with varying accessories. Please observe the notes
which apply to your model.
Notes which are important for your safety or for the correct
1
functioning of the appliance are indicated with a warning triangle and/
or the words (Warning!, Caution!, Important!). Please observe the
information carefully.
This symbol guides you step by step in the operation of the appliance.
0
Additional information regarding operation and practical use of the
3
appliance appear after this symbol.
Tips and information concerning economical and environmentally
2
sound use of the appliance are marked with the cloverleaf.
Explanations of the technical terminology used in the operating
instructions can be found at the end in the section "Technical
Terminology".
The operating instructions contain instructions for the correction of
possible malfunctions by the user in the section "Something not
working". If you are unable to rectify the fault after reading this
chapter, please contact your local AEG Service Force Centre..
2
If you require assistance or advice on your appliance, please contact
our Customer Care Department by letter or telephone:
Customer Care Department
AEG Domestic Appliances Limited
55-77 High Street
Slough
Berkshire SL 1 1DZ
Tel:08705 350350
nted on paper manufactured with environmentally sound processes.
These warnings are provided in the interests of your safety. Ensure
that you understand them all before installing or using this
appliance. Your safety is of paramount importance. If you are unsure
about any of the meanings or these warnings contact the Customer
Care Department.
Prior to Installation
• Check the refrigerator for transport damage. Under no circumstances
should a damaged appliance be installed! In the event of damage, please
contact your retailer.
Installation
• This appliance is heavy. Care should be taken when moving it.
• It is dangerous to alter the specifications or attempt to modify this product in any way.
• Ensure that the appliance does not stand on the electrical supply cable. If
the supply cable is damaged, it must be replaced by a cable available
from your local Service Force Centre.
• Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
• Parts which heat up should not be exposed. Whenever possible, the back
of the appliance should be close to a wall, but leaving the required
distance for ventilation, as stated in the installation instructions.
• The appliance should be left for 2 hours after installation before it is turned on, in order to allow the refrigerant to settle.
Refrigerant
The refrigerant isobutane (R600a) is contained within the refrigerant
circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable.
• During transportation and installation of the appliance, be certain that
none of the components of the refrigerant circuit become damaged.
• If the refrigerant circuit should become damaged:
– avoid open flames and sources of ignition;
– thoroughly ventilate the room in which the appliance is situated.
5
Important Safety Instructions
Child Safety
• Do not allow children to tamper with the controls or play with the product.
• There is a risk of suffocation! Keep packaging material away from children!
During Use
• This appliance is designed for domestic use only, specifically for the
storage of edible foodstuffs only. It is not intended for commercial or
industrial use
• Containers with flammable gases or liquids can leak at low temperatures.
Do not store any containers with flammable materials such as, spray cans,
fire extinguisher refill cartridges etc in the refrigerator.
• Frozen food should not be refrozen once it has thawed out.
• Do not place carbonated or fizzy drinks in the freezer compartment.
• Ice lollies can cause ’frost/freezer burns’ if consumed straight from the
freezer compartment.
• Do not remove items from the freezer compartment if your hands are
damp/wet, as this could cause skin abrasions or frost/freezer burns.
• Bottles and cans must not be placed in the freezer compartment. They
can burst when the contents freeze.
• Manufacturers´ recommended storage times should be adhered to. Refer
to relevant instructions.
Maintenance and Cleaning
• Before cleaning, always switch off the appliance and disconnect from the
electrical supply.
• When unplugging always pull the plug from the mains socket, do not pull
on the cable.
Servicing
• This product should be serviced by an authorised engineer and only
genuine spare parts should be used.
• Under no circumstances should you attempt to repair the appliance
yourself. Repairs carried out by inexperienced persons may cause injury or
serious malfunctioning.
Contact your local Service Force Centre.
6
Environmental Information
Packaging
All transit packaging materials are environmentally compatible and can
be reused. Wood is un-treated. The plastics can be recycled and are
identified as follows:
>PE< for polyethylene, e.g. the outer covering and the bags in the
interior.
>PS< for polystyrene foam, e.g. the pads, which are pure hydrocarbon
compounds and can be recycled.
The carton parts are made from recycled paper. Please dispose of the
packaging with due care for the environment.
Old Appliances
When disposing of your old appliance:
Make the appliance unusable by cutting off the cable and remove any
door catches to ensure small children cannot be trapped inside.
Help to keep your country tidy - use an authorised disposal site.
Before Use
Packaging
0
Pull off the adhesive tape on the left and right side of the door.
Any remnants of adhesive can be removed with white spirit.
3
0
Remove all adhesive tape and packaging from the interior of the
appliance.
0
Remove the protection from the seal on the inside of the door.
0
Wash the inside of the appliance with lukewarm water with a little
bicarbonate of soda added (5 ml to 0.5 litre of water). Do not use soap
or detergent as the smell may linger. Dry the appliance thoroughly.
7
Installation
Installation Location
The appliance should be installed in a well ventilated, dry room.
Energy use is affected by the ambient temperature.
The appliance should therefore
– not be exposed to direct sunlight;
– not be installed next to radiators, cookers or other sources of heat;
– only be installed at a location whose ambient temperature corre-
sponds to the climate classification, for which the appliance is desi-
gned.
The climate classification can be found on the rating plate, which is
located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for
each climate classification:
Climate classificationfor an ambient temperature of
SN+10 to +32 °C
N+16 to +32 °C
ST+18 to +38 °C
T+18 to +43 °C
8
The appliance needs ventilation
The integrated door of the furniture
cabinet largely seals the installation
recess. Integrated-appliances must therefore be provided with ventilation by
having an opening in the furniture
plinth. The warmed air must be able to
be exhausted upwards through the air
shaft on the furniture back. The ventilation cross-sections should be at least
200 cm
2
Installation
Important!
function of the appliance, never cover
or obstruct the ventilation openings.
In order not to impair the
Installation
See installation instructions supplied.
After installing the appliance, ensure the door seals correctly when closed. If the door does not seal tightly, this may lead to heavy frosting
and a higher energy consumption.
9
Installation
Electrical Connection
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
1
The manufacturer declines any liability should these safety measures
not be observed.
Before switching on, make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate. The rating plate is
inside, on the left.
The appliance is supplied with a 13 amp plug fitted. In the event of
having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
Important
The wires in the mains lead are coloured in accordance with the following code:
Green
Green and Yellow Earth
BlueNeutral
BrownLive
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings indentifying the termi-
Blue
nals in your plug, proceed as follows:
1. The wire coloured green and
yellow must be connected to
the terminal marked with the
letter „E“ or by the earth symbol or coloured green and yellow.
2. The wire coloured blue must be connected to the terminal „N“ or
coloured black.
3. The wire coloured brown must be connected to the terminal marked
„L“ or coloured red.
4. Upon completion there must be not cut, or stray strands of wire pre-
sent and the cord clamp must be secure over the outer sheath.
& Yellow
Brown
Cord Clamp
10
Warning!
1
safety (shock) hazard. Ensure that the cut-off plug is disposed of safely.
A cut-off plug inserted into a 13 amp socket is a serious
Description of the appliance
View of the appliance
(various models)
Temperature regulator and light switch
➀
Butter/cheese compartment with flap
➁
Variable storage compartment (not included with all models,
➂
design differs depending on the model)
Door storage compartment
➃
Bottle shelf
➄
Fruit and Vegetable drawers
➅
Storage shelves
➆
Freezer compartment with ice cube tray
➇
General purpose box (not included with all models)
➈
Rating plate
➉
11
Prior to Initial Start–Up
0
Please clean the appliance interior and all accessories prior to initial
start-up (see section: “Maintenance and Cleaning”).
Initial use
0
Insert plug into mains socket.
The temperature regulator is on
the right side in the refrigerator
compartment. It is also the ON/
OFF-switch.
Position "0" means:
Off
Position "1"means:
Highest interior temperature (warmest setting)
Position "6" means:
Lowest interior temperature (coldest setting)
Recommended settings:
For normal use: position "2" - "3";
0
Turn the temperature regulator to the desired setting. The inside light
illuminates. The compressor starts and then runs automatically.
12
Goods to be refrigerated can be loaded immediately after switching on,
3
because the storage temperature in the refrigerator is quickly reached.
Important! Wait until the freezer compartment has reached a tempera-
ture of –18 °C, before storing frozen food.
From a food science point of view, +5 °C for the refrigerator
Note:
compartment and -18 °C for the freezer compartment should be considered cold enough as a storage temperature.
The following effects are of significance in respect of the interior temperature:
– Ambient temperature;
– Quantity and temperature of the food stored;
– Frequency with which the door is opened and how long it is left open.
Loading...
+ 27 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.