AEA TRP2 Datasheet

AEA TRP2

SPECIFICATIONS

THE ORIGINAL 2-CHANNEL RIBBON PREAMP

SPECIFICATIONS

Gain at 1kHz:

Noise gure, rms A-weighted:
Noise gure, rms unweighted:

EIN:

Frequency Response:

THD:

Input Impedance:
Input Impedance (P48 En-

gaged):

Mic Gain Control:

Output Level Potentiometer:
Low-Cut Filter:

XLR output maximum level

into 600Ω load:
XLR connectors polarity:
LED signal level indicators:

85dB of gain at 1kHz, balanced-in to
balanced-out in Microphone Input mode
<2dB
<3dB, 20 kHz LPF bandwidth
<-130 dBu A-weighted, 150 Ohm resistive

source

-3dB <1Hz and >100 kHz

<0.02% at 1 kHz

63K Ohms
10K Ohms

Twelve-position switch provides from +7dB

to +63dB of gain for the preamplifier
circuit, as measured between the input
and the before the output line driver.

25dB
12dB per octave from 100 Hz

+28 dBu, balanced; 0 dBu = 0.7746 V rms

Pin-1 is ground, pin-2 is high, pin-3 is low
The green LED snaps on at -20 dBu to

indicate the presence of signal; the
yellow LED snaps on at 0 dBu; the red
LED snaps on at +24 dBu to warn of
approaching signal overload.

Dimensions:

Weight:
Power Supply Weight:
Power Supply Length:

Half-rack wide, rack unit high (measured

without knobs and switches):

8.5” w, 8.5 d, 1.5” h (36.7 cm x 36.7 cm x

4.3 cm)

2lbs oz (0.9 kg)

1.5 lbs (0.7 kg)
12 feet (3.6 m)