Advent FDS3NAV2 User Manual
FDS3NAV2
For Ford Vehicles Equipped With
SYNC3
Installation Instructions
Calibration and Setup Guide
Page 1 of 14
Please read this manual
thoroughly before installation.
This manual illustrates a typical installation. Actual installation may vary by vehicle model.
Use caution and if unsure seek professional assistance.
Warning!
It is recommended to disconnect the NEGATIVE battery terminal for at least 90
seconds before beginning the installation of this product.
Cover all surfaces with tape or plastic protective lm to protect against scratching
and damage. Advent / Voxx is in no way liable for any damage incurred during
installation. This product has been validated on the vehicles listed on the application guide only. Consult Technical Support at 800-323-4815 if you have any
questions.
Page 2 of 14
SYNC3
Page 3 of 14
A. Installation
1. Locate the vehicle's Touch Panel and the Radio Tuner Module, usually located behind the radio's mounting location. Both the Radio Tuner Module and Touch Panel need to be removed for the installation of this
accessory.
Page 4 of 14
2. Locate the Radio Tuner Module. This is the module that
will contain the CD player. Disconnect the both large connectors. Connect the factory connectors to the T-Harness
and plug the other side of the T-Harness into the Radio
Tuner Module.
3. Locate the Touch Panel / Display Screen. Disconnect the
Video cable on the back of the Touch Panel and save for
the customer. You will not be re-using this cable.
4. Connect the provided YELLOW and BLUE video cables
to the Touch Panel's YELLOW and BLUE connectors.
5. Route the main wiring harness to the Navigation Module's
mounting location and connect the wiring harness to the
Navigation Interface Module as shown.
6. Route the YELLOW and BLUE video cables to the Navigation Interface's mounting location and connect to the
Navigation Interface as shown.
Page 5 of 14
Loading...