Advantech Co FWA 1010 Users Manual

FWA-1010VC Network system with Intel®

Packing List

Specifications

Before you begin installing your card, please make sure that the following items have been shipped:

• One FWA-1010VC System

• One space of accessories

• One warranty certificate

If any of these items are missing or damaged, please contact your distributor or sales representative immediately. Note 1: Acrobat Reader is required to view any PDF file.Acrobat Reader can be downloaded at: www.adobe.com/Products/acrobat/readstep2.

html (Acrobat is a trademark of Adobe)

Main Board Functions

• CPU:

Dual Intel® C2000, L2 Catch: 2MB/4MB (by CPU SKU)

• Memory:

Supports two DDR3/DDR3L Memory DIMMs up to 1600 MHz, depending on CPU SKU

• Storage:

Up to 1 x 2.5" SSD bracket(by product sku), 1x M.2 2280 SSD slot

• Dimensions:

250 x 44 x 190.4mm (W x H x D)

• Power Supply:

60W, 100 V ~ 240 V @ 50 ~ 60 Hz, full range

For more information on this and other Advantech products, please visit our website at:

http://www.advantech.com.tw/support http://www.advantech.com

For technical support and service, please visit our support website at:

http://www.advantech.com/support

This manual is for the CGS6000 series Rev. A Part No. TBA Print in China Draft Edition,

Atom® C2000 Processor Platform

1. FEDERAL COMMUNICATIONS COMMISSION (FCC)

STATEMENT:

15.21

You are cautioned that changes or modifications not expressly approved by the part

responsible for compliance could void the user’s authority to operate the equipment.

15.105(b)

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1) this device may not cause harmful interference and

2) this device must accept any interference received, including interference that may

cause undesired operation of the device.

FCC RF Radiation Exposure Statement:

1. This Transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

2. This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with a

minimum distance of 20 centimeters between the radiator and your body

2. HARDWARE INSTALLATION INTRODUCTION

2.1 MEMORY INSTALLATION

2.1.1 Open the top cover and insert DDR3 UDIMM module into the socket, insert RAM module into black socket first then insert RAM module in orange socket