Advantech IDS-3115E, IDS-3115, IDS-3115P User Manual

User Manual

IDS-3115 Series

15" Industrial Open Frame
Monitor

Copyright

Part Number: 2006S31102 Edition 3

Printed in Taiwan November 2017

The documentation and the software included with this product are copyrighted 2013
by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right
to make improvements in the products described in this manual at any time without
notice. No part of this manual may be reproduced, copied, translated or transmitted
in any form or by any means without the prior written permission of Advantech Co.,
Ltd. Information provided in this manual is intended to be accurate and reliable. How­ever, Advantech Co., Ltd. assumes no responsibility for its use, nor for any infringe­ments of the rights of third parties, which may result from its use.

Acknowledgements

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows and MS-DOS are registered trademarks of Microsoft Corp.
All other product names or trademarks are properties of their respective owners.

Product Warranty (2 years)

Advantech warrants to you, the original purchaser, that each of its products will be
free from defects in materials and workmanship for two years from the date of pur­chase.

This warranty does not apply to any products which have been repaired or altered by
persons other than repair personnel authorized by Advantech, or which have been
subject to misuse, abuse, accident or improper installation. Advantech assumes no
liability under the terms of this warranty as a consequence of such events.

Because of Advantech’s high quality-control standards and rigorous testing, most of
our customers never need to use our repair service. If an Advantech product is defec­tive, it will be repaired or replaced at no charge during the warranty period. For out­of-warranty repairs, you will be billed according to the cost of replacement materials,
service time and freight. Please consult your dealer for more details.

If you think you have a defective product, follow these steps:

1. Collect all the information about the problem encountered (For example, CPU

speed, Advantech products used, other hardware and software used, etc.). Note
anything abnormal and list any on screen messages you get when the problem
occurs.

2. Call your dealer and describe the problem. Please have your manual, product,

and any helpful information readily available.

3. If your product is diagnosed as defective, obtain an RMA (return merchandize

authorization) number from your dealer. This allows us to process your return
more quickly.

4. Carefully pack the defective product, a fully-completed Repair and Replacement

Order Card and a photocopy proof of purchase date (such as your sales receipt)
in a shippable container. A product returned without proof of the purchase date
is not eligible for warranty service.

5. Write the RMA number visibly on the outside of the package and ship it prepaid

to your dealer.

IDS-3115 User Manual ii

Declaration of Conformity

CE

This product has passed the CE test for environmental specifications. Test conditions
for passing included the equipment being operated within an industrial enclosure. In
order to protect the product from being damaged by ESD (Electrostatic Discharge)
and EMI leakage, we strongly recommend the use of CE-compliant industrial enclo­sure products.

FCC Class A

Note: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Opera­tion of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.

FM

This equipment has passed FM certification. According to the National Fire Protec­tion Association, work sites are classified into different classes, divisions and groups,
based on hazard considerations. This equipment is compliant with the specifications
of Class I, Division 2, Groups A, B, C and D indoor hazards.

Technical Support and Assistance

1. Visit the Advantech website at http://support.advantech.com where you can find

the latest information about the product.

2. Contact your distributor, sales representative, or Advantech's customer service

center for technical support if you need additional assistance. Please have the
following information ready before you call:

– Product name and serial number
– Description of your peripheral attachments
– Description of your software (operating system, version, application software,

etc.)

– A complete description of the problem
– The exact wording of any error messages

Warnings, Cautions and Notes

Warning! Warnings indicate conditions, which if not observed, can cause personal

injury!

iii IDS-3115 User Manual

Caution! Cautions are included to help you avoid damaging hardware or losing

data. e.g.

There is a danger of a new battery exploding if it is incorrectly installed.
Do not attempt to recharge, force open, or heat the battery. Replace the
battery only with the same or equivalent type recommended by the man­ufacturer. Discard used batteries according to the manufacturer's
instructions.

Note! Notes provide optional additional information.

Document Feedback

To assist us in making improvements to this manual, we would welcome comments
and constructive criticism. Please send all such - in writing to: support@advan­tech.com

IDS-3115 User Manual iv

Safety Instructions

1. Read these safety instructions carefully.

2. Keep this User Manual for later reference.

3. Disconnect this equipment from any AC outlet before cleaning. Use a damp

cloth. Do not use liquid or spray detergents for cleaning.

4. For plug-in equipment, the power outlet socket must be located near the equip-

ment and must be easily accessible.

5. Keep this equipment away from humidity.

6. Put this equipment on a reliable surface during installation. Dropping it or letting

it fall may cause damage.

7. The openings on the enclosure are for air convection. Protect the equipment

from overheating. DO NOT COVER THE OPENINGS.

8. Make sure the voltage of the power source is correct before connecting the

equipment to the power outlet.

9. Position the power cord so that people cannot step on it. Do not place anything

over the power cord.

10. All cautions and warnings on the equipment should be noted.

11. If the equipment is not used for a long time, disconnect it from the power source

to avoid damage by transient overvoltage.

12. Never pour any liquid into an opening. This may cause fire or electrical shock.

13. Never open the equipment. For safety reasons, the equipment should be

opened only by qualified service personnel.

14. If one of the following situations arises, get the equipment checked by service

personnel:

The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work according to

the user's manual.

The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.

15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE

STORAGE TEMPERATURE MAY GO BELOW -20° C (-4° F) OR ABOVE 60° C
(140° F). THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT
SHOULD BE IN A CONTROLLED ENVIRONMENT.

16. CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY

REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE
RECOMMENDED BY THE MANUFACTURER, DISCARD USED BATTERIES
ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS.

The sound pressure level at the operator's position according to IEC 704-1:1982 is
no more than 70 dB (A).

DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech
disclaims all responsibility for the accuracy of any statements contained herein.

Caution! For power adapter selection: the information about the adapter output

rating (12 Vdc, 5 A min, or 60 W min) is provided in the user manual for
user's selection if the power adapter is not shipped with the unit

v IDS-3115 User Manual

IDS-3115 User Manual vi

Contents

Chapter 1 Overview...............................................1

1.1 Introduction ............................................................................................... 2

1.2 Features .................................................................................................... 2

1.3 Applications............................................................................................... 2

1.4 Product Photos.......................................................................................... 2

1.5 Naming Convention................................................................................... 3

Chapter 2 System Setup.......................................5

2.1 Specifications ............................................................................................ 6

2.2 Dimensions ............................................................................................... 7

Figure 2.1 IDS-3115 High Brightness Series Dimensions........... 7

Figure 2.2 IDS-3115 Series Dimensions ..................................... 7

Figure 2.3 IDS-3115E Series Dimensions ................................... 7

Figure 2.4 IDS-3115P Dimension ............................................... 8

2.3 Rear Mount Assembly SOP ...................................................................... 8

2.4 Cable Clamp ............................................................................................. 8

2.5 Packing List............................................................................................... 9

Chapter 3 Touchscreen ......................................11

3.1 OSD Functions (IDS-3115 Series) .......................................................... 12

3.1.1 OSD Main Menu: Push the MENU Key ...................................... 12

3.1.2 Brightness Selection - Submenu................................................. 13

3.1.3 Contrast Control.......................................................................... 13

3.1.4 Screen Settings - Submenu ........................................................ 13

3.1.5 Color Temperature - Submenu ................................................... 14

3.1.6 Language - Submenu ................................................................. 14

3.1.7 OSD Setting - Submenu ............................................................. 14

3.1.8 VGA/DVI Selection...................................................................... 15

3.2 OSD Functions for IDS-3115E Series ..................................................... 15

3.2.1 OSD Main Menu: Push the MENU Key ...................................... 15

3.2.2 OSD Lock.................................................................................... 15

3.2.3 OSD Unlock ................................................................................ 16

3.2.4 Color Adjustment - Submenu (Brightness /Contrast/ Color Adjust/

Color temp/Auto Color) ............................................................... 16

3.2.5 Image Setting Adjustment........................................................... 17

3.2.6 Image Adjustment -Submenu (Clock/Phase/H. Position/V.

Position) ...................................................................................... 17

3.2.7 OSD Menu Adjustment ............................................................... 18

3.2.8 OSD Adjustment - Submenu (OSD H.Pos./ OSD V.Pos./OSD

Timer).......................................................................................... 18

3.2.9 OSD Adjustment - Language Submenu...................................... 19

3.2.10 Reset Adjustment........................................................................ 19

3.3 Touch Drivers.......................................................................................... 19

3.4 Mounting Notes (for Projected Capacitive Touchscreen)........................ 20

3.4.1 Mounting Touchscreen on Back Side of the Bezel ..................... 20

3.4.2 Tail .............................................................................................. 20

Appendix A Troubleshooting ................................21

A.1 Introduction ............................................................................................. 22

vii IDS-3115 User Manual

A.2 Troubleshooting ...................................................................................... 22

IDS-3115 User Manual viii

Chapter 1

1 Overview

Sections include:

 Introduction
 Features
 Applications
 Product Photos
 Naming Convention

1.1 Introduction

The Advantech IDS-3115 series is a brand new Industrial Open Frame Monitor,
designed to meet the needs of customers who want a quick and easy integration with
Advantech Embedded Box Computers, such as ARK and DSA. Advantech offers
three different versions of IDS-3115 to meet different demands: IDS-3115 HB series
(High brightness version), IDS-3115 series (Standard version) and IDS-3115E series
(Economical version)

1.2 Features

 15" XGA LED backlight panel which provides 20~30% power saving
 -20°C ~ +60°C wide operating temperature range support
 Special design of 5-wire resistive and optional P-cap (dual-touch is supported)

touchscreen

 All new mechanical design with integrated bracket for easy installation
 Versatile mounting method for rear mount and VESA mount (75 x 75 mm, 100 x

100 mm)

1.3 Applications

Application scenarios - self-service applications:

 KIOSK / POI machine
 Transportation machine
 Ticketing machine
 Financial ATM
 Entertainment / Gaming / Slot machine
 HMI (Human-Machine Interface) equipment controller monitor
 Public communication machine
 Public advertisement machine

1.4 Product Photos

Front view

IDS-3115 User Manual 2