Advance Security TX553 User Manual

CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user's authority to operate the equipment

TX553

FOUR-BUTTON TRANSMITTER

The TX553 transmitter is a replacement RF transmitter. The transmitter
comes with 4 push-button switches.

1) Press Upper and LEFT push-button switch on control first receiver (alarm
the system, door lock ).

2) Press Upper and RI GHT push-button switch to control second receiver (It
can be an alarm system or electric device).

3) Press Lower RIGHT push -button switch to control third receiver (It can be
an alarm system or electric device).

4) Press Lower RIGHT push -button switch to control forth receiver (It can be
an alarm system or electric device).

TRANSMITTER BATTERY REPLACEMENT

If the range of your transmitter deteriorate, it is possible that you need to
replace the battery.

1) Release the screw from the back of transmitter and remove upper
transmitter case.

2) Remove old battery from transmitter.

3) Install a new battery (12 volt) noting the (+) and (-) marks in the battery area
of the transmitter.

4) Replace upper transmitter case with area, do not damage the inside
components.

5) Tighten the screw on the back of transmitter.

This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions.

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference

that may cause undesired operation.