Adtran ESU LT Quick Start Guide

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

Network

ESU LT P/N 1200410L2

E1/FE1

NETWORK CONNECTION PINOUT

Pin Name Description

1 TX DATA Transmit data towards the Network

2, 4, 5, 7 GROUND Frame Ground

3 RX DATA Receive data from the Network

6, 8, 10, 12-15 UNUSED

—

VT 100 Terminal or device running SLIP or async PPP protocol.

INSTALLATION INFORMATION

•A 120Ω DB-15 interface (labeled NETWORK) is provided to connect to the network E1 or FE1 circuit. The pinout is provided on this Quick Start Guide. See Chapter 2, Installation, of the ESU LT User Manual for more information.

• The rear panel contains a single DB-25 Nx 56/64 interface for connecting to DTE equipment. The pinouts for this interface are located in Appendix C of the ESU LT User Manual.

9 TX DATA Transmit data towards the Network

11 RX DATA Receive data from the Network

REAR PANEL DESCRIPTIONS

Network Connector Connection to E1 or FE1 circuit (DB-15)

MON Interface Bantam jack provided for monitoring and testing

Control In/Out Connection to a VT100 terminal

Nx 56/64 Connector High-speed DTE interface

Power Switch Turns power to the ESU LT on or off

Power Connection

Power cord IEC connection for a reliably grounded 90-240 VAC, 50-60 Hz (24A) power source

• When shipped from the factory, the ESU LT is uninitialized and set to factory default conditions. At the first application of power, the unit will automatically execute self-tests followed by an initialization sequence.

• The ESU LT can be configured and controlled using the local front panel of the unit or from ADTRAN’s PC Control Program, T-Watch PRO™. A limited menu tree is provided on the back of this sheet. For more detailed menu information, refer to the ESU LT User Manual.

• Additional information can be found on the product CD which contains the ESU LT User Manual and Data Sheets.

Quick Start Guide

ESU LT P/N 1200410L2

MENU TREE - OVERVIEW

1) NI PERF REPORTS

1) STATUS 2) CURR ERR/ALM

3) ERR/ALM HISTORY

1) NETWORK (NI)

2) CONFIG 2) UNIT

MAIN MENU 3) PORT

1) TIME/DATE

2) SOFTWARE REV Displays the current software revision

3) UTIL 3) REINIT UNIT

4) ADDRESS

5) SET PASSCODE

6) FACTORY RESTORE Returns all configurations to factory settings

1) NETWORK TESTS

4) TEST 2) RUN SELF TEST

3) PORT TESTS

4) CANCEL TESTS