ADTRAN Dual U-BR1TE Plug-In Option Card Quick Start Guide

For more detailed documentation, visit us online at www.adtran.com

DUAL U-BR1TE PLUG-IN OPTION CARD P/N 1200107L1HS

PECIFICATIONS

U-INTERFACE

Line 2-wire (tip and ring) Rate 160 kbps full duplex Frequency 40 kHz Line Code 2B1Q Max Line Loss 42 dB @ 40 kHz Max Distance 18000 ft with 1300 ohm resistance design

NSTALLATION INSTRUCTIONS

1. Remove the cover plate from the option slot in the TSU/TDU rear panel.

2. Slide the Dual U-BR1TE Plug-in Option Card into the option slot until the module is firmly positioned against the front of the chassis.

3. Fasten the thumbscrews at both edges of the module. Tighten with a screwdriver.

ETWORK CONNECTION

Pin Name Description

1, 2, 3 Unused N /A 4 Ring Ring lead of 2-wire interrface 5 Tip Tip lead of 2-wire interface 6,7,8 Unused

NOTE: To mate with the Dual U-BR1TE connection, the following pins are used: RJ-11 Connector: Pin 3 - Ring; Pin 4 - Tip

RJ-45 Connector: Pin 4 - Ring: Pin 5 - Tip

2-Wire Voice Pinout

ISDN Interface Connector

COMPATIBILITY

ISDN 2B1Q Interface

Performance TR-NWT-000397 and TR-TSY -0 008 29 ISDN BR over T1 TR-NWT-000397 Approvals FCC Part 15, FCC Part 68, UL

DIAGNOSTICS AND TESTS

Loopback B1, B2 loopbacks and 2B+D loopbacks initiated

Self-test RAM test

RJ-45

ANSI T1.601-1992

through EOC as specified by TR-NWT-000397 and ANSI T1.601-1992

Slot selection test EPROM checksum test

DUAL U-BR1TE PLUG-IN OPTION CARD P/N 1200107L1HS

ENU TREE

1) NI Perf Reports

2) NI Errors

3) Active Alarms Sync

4) View History 1) Loop Status CRC

1) Status 5) Port Status 1.1 UBR1TE ACT

2) T1 Status Sync CRC

3) Loop Monitor ACT

1)Network (NI)

2) Unit 2B+D

3) Map XCHNG 2B

Menu 4) Map in Use A(B) 1) Service B1+D

2) Config 5) DS0 Map A B2+D

6) DS0 Map B B1

7) Port Config 1.2 UBR1TE B2

2) ZBS Disable

1) Time/Date Enable

2) Factory Restore 3) Mode LULT

3) New Passcode LUNT

4) Unit ID 4) Wa ke - u p Tone Off

5) Software Rev On

3) Util 6) Port Util 1.1 UBR1TE SW Revision

1) Network Tests 1) B1 Remote Lp Bk

4) Test 2) Run Self-test 2) B2 Remote LpBk

3) Port T est 1.1 UBR1TE 3) Local Loopback

4) Cancel Tests 4) B1 2047 PATT

5) B2 2047 PA TT

6) Inject Error

7) P ATT Results