Addonics Technologies RTM25N335H User Manual
I. Removing Cover of RAID Tower Mini
hard disk drive
SATA power connector
SATA data cable
II. Installing drive into the RAID Tower Mini
Using 2.5” SATA hard disk drive, slide the drive into the drive
bay. Close the front panel to secure the drive.
III. Connecting the power cable and RAID Tower Mini to the
computer
a. Connect the power cord provided from the wall outlet to the
back of the RAID Tower Mini.
b. Make sure the power is off (power LED light should be off)
c. Connect the provided eSATA cable from the back of the
RAID Tower to the eSATA controller card on the computer.
We recommend connecting the eSATA port for best
performance if this port is available on your computer.
d. If eSATA connection is not available, connect the USB2.0 to
eSATA adapter to the other end of the eSATA cable then
connect the adapter to the USB port on your computer.
IV. Power on/off control
Turn on the power to the RAID Tower Mini by pressing the
power button on the front. The power LED light should lit
indicating the power is on.
V. Sil4726 Manager Utility Installation
Note: You need to install the SiI4726 Manager on your system to
configure RAID sets.
RAID configuration is programmed by connecting the hardware
port multiplier:
via USB 2.0 connection (Addonics USB2.0 to eSATA
adapter is provided)
or to one of Addonics’ SATA controllers that has SIL3124 or
SIL3132 chip set.
ADDONICS TECHNOLOGIES
Model: RTM25N335H
Loosen the 3 screws at the back of the tower
using a Philips screwdriver by turning
counter-clockwise. Separate the metal casing
of the storage tower from the housing by
lifting up the casing as shown on the photo.
Using 3.5” SATA hard disk drives, slide the
drive into the embedded drive bay and
secure the drive to the bay with screws
provided.
Connect the internal SATA data cable to the
data port of the hard drive then connect the
15-pin SATA power connector to the power
port on the hard drive.
After RAID configuration, it is compatible with any SATA
controller (RAID or non RAID). If you have configured individual
drives, you need to connect the RAID tower to a port multiplier
compatible eSATA host controller, if you plan to use eSATA
connection.
Software Installation for SiI4726 Manager
A. From the CD start-up menu select SATA RAID Utilities >
Other SATARAID Utilities > Windows 2000/XP/2003/Vista.
B. Unzip the file SiI_4726_Manager_V4.0.0.9.zip on your drive.
The folder name would be SiI4726.
C. To install SiI4726 Manager, double click setup.exe
In SiI4726 Manager, all the drives connected to the RAID Tower
IV will show up.
VI. Setting RAID on the HPM
For a complete User’s Guide of SiI4726 Manager refer to our
website.
Support > User Guides > SiI4726 Manager User Manual V.26
TECHNICAL SUPPORT
Phone: 408-453-6212
Hours: 8:30 am - 6:00 pm PST
Email: http://www.addonics.com/support/query/
Loading...