Addonics Technologies RTM2233EU3 User Manual

T E C H N O L O G I E S

User Guide

RAID Tower Mini

(RTM2233EU3)

www.addonics.com

v8.1.11

Technical Support

If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:

Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/

Unpacking and Overview

RAID Tower Mini (shown with drives installed)

Power Switch

Array Host

RAID Error

Power LED

RAID Tower Mini Rear View

Power Cord (US Version shown)

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/

RAID Rack with Port Multiplier Compatibility

Note: When configured as a set of individual drives, the Port Multiplier will only work with a Port
Multiplier aware host. Identify your host controller and check with its hardware manufacturer if
you are unsure. Addonics offers several Port Multiplier capable host adapters.

Removing Cover

Loosen the 3 screws at the back of
the towerusing a Philips screwdriver
by turning counter-clockwise. Separate
the metal casing of the tower from
the housing by liftingup the casing
as shown in the drawing.

2.5" Drive Installation
Step 1

Open the door on the front of the RAID Tower Mini
to reveal the Snap-In Double Drive.

Step 2

Gently push the silver button on the Snap-In
Double drive's door to open it.

Step 3

Push a 2.5" SATA drive into the bay, label side up,
with the SATA connectors toward the rear. It should
give little resistance, DO NOT force the drive.

Step 4

Once the drive has been pushed into the bay
as far as it will go, close the door over it until the
door snaps in place.

3.5" Drive Installation
Step 1

Slide the storage device into the
embedded mounting bracket.

Step 2

Using 3.5” SATA Hard Disk Drives Connect the
internal SATA data cable to the data port of the

Hard Disk

hard drive then connect the 15-pin SATA power
connector to the powerport on the hard drive.
The Snap-In Double Drive is connected to Ports 0
and 1 on the HPM-XU Port Multiplier. Connect the
top 3.5" drive to Port 2, the middle drive to port 3,
and the bottom drive to Port 4.

Step 3

Secure the hard disk by using screws
provided. Repeat the above procedure for
additional hard drives.

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/