Addonics Technologies RR2035ASDML User Manual

T E C H N O L O G I E S

User Guide

RAID Rack

(RR2035ASDML)

www.addonics.com

v8.1.11

Technical Support

If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:

Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/

Array 1

Front

Array 2

Array 3

Power Switch

System Reset

Buzzer Reset

LED Display

Back

Power Supply

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/

Array 4

Fans

Multilane Connector

Power Switch: This is the switch to power devices connected to the power
supply. The power LED will light up to indicate power is supplied.
Note: The main power switch located at the back of enclosure must be
turned on first.

Reset Button: Not operational.

Buzzer Reset: Pressing the button stops the overheat buzzer from making

a sound. The buzzer will make a sound when temperature inside the
storage rack exceeds the temperature setting on the Thermal Managment
card.
Note: Buzzer reset switch does not silence the port multiplier buzzer.

Power LED: Lights up when the power switch is turned on.

Temp LED: Lights up when the temperature setting inside the storagerack

exceeds the setting on the thermal card.

Fan LED: Normally on when fan is operational. If an abnormal condition is
detected, the LED flashes.

HDD LED: Not operational.

RAID Rack with Port Multiplier Compatibility

Note: When configured as a set of individual drives, the Port Multiplier will
only work with a Port Multiplier aware host. Identify your host controller and
check with its hardware manufacturer if you are unsure. Addonics offers
several Port Multiplier capable host adapters.

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/

Installing drives into the RAID Rack

1. Be sure the lock on each drive door is in an unlock position. If not, use the key
that comes with the Disk Array to unlock the drive door. Pull on the door lever to
swing open the drive door all the way.

2. Slide a 3.5” SATA hard drive into the drive slot with the drive connector side
facing in. Be sure to orient the hard drive correctly as shown in the yellow label
on the inside of the drive door – with drive door swing open at the bottom, the
top of the hard drive should face to the right. The drive should slide all the way
into the slot with very little resistance. Forcing the drive into the slot will cause
drive damage or permanent damage to the Disk Array.

3. Once the drive is all the way into the drive slot, close the door all the way till the
drive door latch securely. This will engage power and data connection with the
hard drive. The LED lit for the drive slot should lit if the Disk Array already
powered on. You may lock the drive door with the key.

4. To remove the hard drive from the Disk Array, simply follow the step 2 – 3 in
reverse.

Insert hard drives
with top facing right

Door lock

Individual drive
bay door

Power & Activity LED for
each drive bay

Main Power LED
for each array

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/