Addonics Technologies HD9SITDRHS User Manual

T E C H N O L O G I E S

User Guide

1:9 HS HDD Duplicator Pro

(HD9SITDRHS)

www.addonics.com

v3.1.11

Technical Support

If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:

Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/

Drive InstallationGuide

Step 1

Use a Philips screwdriver to
turn the cover securing screw
clockwise into the "OPEN"
position.

Step 2

Slide the aluminum cover towards
the back end of the Diamond
enclosure and remove it.

Step 3

For SATA Drive:
Carefully place the SATA hard
drive with the label facing up into
the Diamond Enclosure. Push
the hard drive towards the back
end to secure the drive connec­tors onto the Diamond
enclosure’s SATA connector.

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/

For IDE Drive
Note: Configure your IDE hard
drive as Master device

Connect the 4-Pin Molex cable to
the power connector on the IDE
hard drive. Carefully place the IDE
hard drive with the label facing up
into the Diamond enclosure. Push
the hard drive toward the back
end to secure the drive connectors
onto the Diamond enclosure’s IDE
connector.

Step 4

Turn the Diamond enclosure over
with the hard drive mounting holes
facing up. Use the included flat
head screws to secure the hard
drive onto the bottom of the enclo­sure and turn in the screw to the
“LOCK” position.

Step 5

Insert the enclosure into a cradle in
the duplicator and secure it in place
with the handle and turn the cradle's
lock to the LOCK position. Note: the
drive will not power up until the
cradle's lock is in the LOCK posi­tion.

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/