Adcraft OF-40 Installation Manual

INSTRUCTION MANUAL

OF-40

PORTABLE OIL FILTER

120V

This manual contains important information regarding your Adcraft unit. Please read this manual

thoroughly prior to equipment set-up, operation and maintenance. Failure to comply with regular

maintenance guidelines outlined in this manual may void the warranty.

WARNINGS

• Do not touch any hot surfaces

• Do not immerse unit, cord or plug in liquid at any time

• Unplug cord from outlet when not in use and before cleaning

• Plug only into a 3-hole grounded electrical outlet of appropriate voltage

• Do not operate unattended

• Do not use this unit for anything other than intended use

• Always use on a fi rm, dry and level surface

• Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in any
manner

• Keep children and animals away from unit

• Keep machine away from any fl ammable or explosive liquids or gases

• Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and
injury. All repairs should be done by authorized professionals only.

• Ensure that the designated power supply is adequate for continual usage

TO USE:

1. Place the unit in front of the fryer being emptied.

2. Plug the power cord of the unit into an outlet of appropriate voltage and turn on the unit.

3. Connect the oil hose to the oil drain valve on the unit

4. Make sure fi ltration system is put together correctly (See fi ltration system diagram) and is secure in place in the
fi ltering chamber.

5. With the extension drain tube tightened securely on the fryer’s oil spout empty the fryer’s oil into the fi ltering
chamber of the oil fi lter.

6. Once the fryer has been fully emptied of oil push the fi ltering button on the fi lter unit and aim the fi ltering hose into
the new or cleaned out fryer to fi ll with oil.

7. You can control the fl ow of oil back into the fryer by tightening or loosening the oil drain valve.

8. Once fryer has been fi lled up to desired/max capacity, turn off the oil fi lter to stop the pump from fl owing.

9. Put the oil hose back into it’s holder.

10. Once cooled down fully, remove the fi ltration system from the chamber.

11. Discard the used the fi ltering sheet and any debris on the fi ltering mesh and clean the inside of the chamber.

12. Unscrew the oil tube from the drain valve. The oil tube can be rolled up and stored inside the chamber.

NOTE: To ensure proper fi ltering of the oil, the oil temperature should be cycled through the fi lter at a range of
250° - 375°F. If the oil is not hot enough, it will clog up the machine and not fi lter properly.

1. Power Switch

2. Filtering Button

3. Oil Drain Valve

4. Handle

April 2015