Page 1
This manual contains important information regarding
CTS-1800W
Fresh Shot Countertop Steamer
your Adcraft unit. Please read the manual thoroughly
prior to equipment set-up, operation and maintenance.
Failure to compl y with regular maint enance guidelines
outlined in this manual may void the warranty.
PLEASE READ!!!
Page 2
Fig. 1
WARNINGS
• Do not touch any hot surfaces
• Plug only i nt o a 3-hole grounded electrical outlet
• Do not immerse unit, cord or plug in liquid at any time
• Unplug cord from outlet when not in use and before cleaning
• Do not operate unattended
• Do not use thi s unit for anything other than intended use
• Do not use outdoors
• Always use on a firm, dry and level surface
• Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in any manner
• Keep children and animals away from unit
• Any incorrect installation, alterations, adjustments and/or impr oper maintenance can lead to property loss and injury. All
repairs should be done by authorized professionals only
• Ensure that the designated power supply is adequate for continual usage and the voltage is correct
SET UP
1. Remove all packing materials both inside and outside the unit and place on a flat surface.
2. Clean machine thoroughly before first use.
3. Position unit near a power outlet. It is not recamended to use an extension cord for this item.
4. Do not place in an area where gasoline, paint or flammable liquids are used or stored.
5. Unit must be used operated with the legs installed.
TO USE
1. Plug the unit into a grounded 3-prong 120V outlet.
2. Open the tank cover and make sure that the filter insi de the tank is properly inst alled.
3. Fill the unit up with approximately 3 quarts of cold tap water (Do not overfill the tank). This unit is designed to be used
with cold tap water. Distilled water may be used to reduce calcium/mineral deposit build-up.
4. Turn the on/off switch to the on position and allow for the unit to preheat for 30 minutes.
5. Once heated, open the top cover and place food items into the basket and then close the top cover.
6. Press the steam button for 2 seconds and release and wait 20 seconds for the steam to penetrate the items inside the unit.
Repeat if product requires more steam. Please note that pressing and holding the steam button for longer than 2
seconds at a time will often flo od out and result in poor steaming.
7. Remove the hot, steamed product from the unit.
8. Turn unit power switch to off if finished using.
Warning: The exterior of the unit ge ts hot while in use!
CLEANING – NOTE: To maintain cleanliness and increase service life, the unit should be cleaned daily. Do not immerse the unit in
water or any other liquid. If liquid enters the electrical compartment it may cause a short circuit or electrical shock.
Daily Maintenance
• Turn the unit off and disconnect the power cord from the electrical outlet
• Allow for unit to cool for 45 minutes before cleaning
• Wipe down the unit with a damp cloth or sponge and hot soapy water
• Rinse by wiping with a clean damp cloth
• Wipe dry
• Do not immerse unit in water or other liquid
Monthly Maintenance
• Turn the unit off and disconnect the power cord from the electrical outlet
• Allow for unit to cool for 45 minutes before cleaning
• Perform daily maintenance as listed above
• Remove the s pray tube b y lifting the loose end and pulling it out o f t he generator hole (Fig.1)
• Slide the metal cover off the spray tube, take a paper clip and poke out all of the tube’s holes
Page 3
• Gently wash the tube under running water to clear the deposits out of the loose end. Re-attach the cover onto the tube.
CTS-1800W
Fresh Shot Steamer
120V
1800W
15
42 lbs
16.75”W x 17.5”D x 8”H
Fig. 2
Please do not bend the spray tube. Bending it will cause permanent damage.
• Use a scraper to remove the excessive calcium/mineral buildup from the gene rator surface
• Thoroughly wipe the gene rator with a damp cloth to remove any loose buildup and reassemb l e the unit
If deposits are still excessive and/or difficult to remove, please refer to the steps below:
1. Pour delimer solution onto the generator surface. Follow the delimer manufacturer’s instruction for proper
mixture and use. If using a chemical cleaner, please check to see it is safe to use on the metal. Please follow all
precautio ns and safety warnings on the product label.
2. Using a sponge or a dry towel, remove the delimer solution from the generator surface and then rinse the surface
with clean water.
Please note: to ensure proper steaming, some calcium/mineral deposits must be present on the generator surface.
If during cleaning, the surface does become free of calcium/mineral deposits, add plain tap water to the surface
and allow it to boil off. If necessary, repeat this process to create a thin coating of calcium/mineral deposits.
Please note: In soft water areas, it may be necessary to add a small amount of lime to the generator surface to
season it. This will ensure prop e r ste aming by producing a thin coating of calcium/mineral deposits on the
generator surface.
Seasoning mixture consists of ¾ ounce baking soda, ¾ ounce lime mixed with 1 quart of water. Stir mixture and
pour ¼” deep onto the hot generator surface. After mixture is converted to steam, the remaining loose powder can
be removed.
3. Plug the power cord into the outlet
4. Turn the power on and allow the unit to warm up for approximately 30 minutes.
5. Push and release the steam button several times to purge the remaining delimer residue from the generator
surface.
6. Turn the unit’s power off; re-install all parts and accessories before using again.
Water Tank Filter Maintenance
The water tank filter is used to prevent particles or food products from entering and damaging the water pump.
Inspect and clean this filter monthly by following these steps:
1. Turn the power off, unplug the cord and allow unit to cool down before proceeding.
2. Open the slide door.
3. Remove the water tank filter locate d inside the tank by pulling it upwards and out of the bottom hole. (Fig.2)
4. Clean the filter by running it under ta p water. Replace the water tank filter if the screen is torn or damaged.
5. Re-install the filter stem into the bottom hole of the tank.
6. Fill the water tank and test the unit
SPECIFICATIONS
Item Number Description Voltage Wattage Amps Net Weight Dimensions
Thank you for your purcha s e!
Admiral Craft Equipment Corp.
940 South Oyster Bay Rd.
Hicksville, NY 11801
P: 1-800-223-7750
F: 1-800-447-7751
www.admiralcraft.com
Page 4
CTS-1800W
Page 5
CTS-1800W
VER0114
Page 6
CTS-1800W - Fresh Shot Countertop Steamer
Parts List
Ref. No. Description QTY
1
BODY SHELL
1
2 CONNECT PLATE FOR BODY SHELL 1
3 ELECTRIC BOX 1
4 PLATE TO FIX WATER PAN COVER 1
5 BOTTOM PLATE 1
6 PLATE TO FIX PAN 2
7 ATOMIZING SPREAD PLATE 1
8 SPRAY PIPE CLIP 1
9 SPRAY PIPE END CAP 1
10 FOOD PAN 1
11 PLATE TO FIX RELAY 1
12 PLATE TO FIX ELECTRIC PARTS 1
13 PLATE TO FIX PUMP 1
14 PLATE TO PRESS PUMP 2
15 PLATE TO FIX PAN COVER 2
16 PIPE TO PROTECT SENSOR 2
17 WATER TANK ASSY 1
18 WATER TANK BOARDING PLATE 1
19 PLATE TO FIX WATER TANK 1
20 WATER TANK COVER 1
21 WATER PAN COVER ASSY 1
22 WATER PAN COVER OUTER PLATE 1
23 WATER PAN COVER INNER PLATE 1
24 PLATE TO CONNECT WATER PAN COVER 1
25 WATER TANK 120V/1800W 1
26 SHAFT OF WATER PAN COVER 1
27 SHAFT OF WATER TANK COVER 1
28 CONNECTER FOR WATER TANK 1
29 COONECTER OF SPARY PIPE 1
30 SPRING FOR TANK LOCK 1
31 CLIP FOR CONNECTER 4
32 HANDLE OF PAN COVER 1
33 WATER TANK COVER LOCK 1
34 WASHER 2
35 WASHER 2
36 SPRAY PIPE 1
37 SEAL RUBBER 1
38 FILTER BASE 1
39 FILTER PRESS RING 1
40 FILTER NET 1
41 CONTROL PANEL 1
42 TRANSFORMER 1
43 PCB 1
44 PUMP 1
45 POWER CORD SHEALTH 1
46 RUBBER FOOT 4
47 PAN 1
48 FUSE 1
49 FUSE BASE 1
50 PUMP SWITCH 1
51 POWER SWITCH 1
52 RELAY 1
53 TEMPERATURE LIMITER 1
VER0114
Page 7
(Page left blank on purpose)
Page 8
ACE
Equipment
One Year Limited
Warranty
Admiral Craft Equipment Corp. (ACE) warrants its equipment against defects in materials and workmanship, subject
to the following conditions:
ACE Equipment is warranted for one year, effective from the date of purchase by the original owner. A copy of the
original receipt or other proof of purchase is required to obtain warranty coverage. This warranty applies to the original
owner only, and is not assignable.
Should any product fail to function in its intended manner under normal use within the limits defined in this
warranty, at ACE’s discretion, such product will be repaired, replaced with a refu rbished unit , or replaced with a new
unit by ACE, after defective unit has been inspected and defect has been confirmed. ACE does not assume any liability
for extended delays in replacing any item beyond its control. This warranty does not apply to rubber and non-metallic
synthetic parts that may need to be replaced due to normal usage, wear or lack of preventative maintenance.
This warranty covers products shipped into the 48 contiguous United States, Hawaii, and metropolitan areas of Alaska
and Canada. Warranty coverage on products used outside the 48 contiguous United States, Hawaii and metropolitan
areas
of Alaska and Canada may vary. Contact ACE for details at 1-800-223-7750
The following conditions are not covered by warranty:
•
Equipment failure relating to improper installation, improper utility connection or supply and problems due to
improper ventilation.
•
Equipment that has not properly been maintained, damage from improper cleaning, and water damage
to controls.
•
Equipment that has not been used in an appropriate manner, or has been subject to misuse, neglect, abuse,
accident, alteration, negligence, damage during transit, delivery or installation, fire, flood, riot, or act of God.
•
Equipment that has the model number or serial number removed or altered.
•
Equipment on which the security seal has been broken.
If the equipment has been changed, altered, modified, or repaired without express written permission from ACE, then the
manufacturer shall not be liable for any damages to any person or to any property, which may result from t he use of this
equipment thereafter.
This equipment is intended for commercial use only and this warranty is void if equipment is used in other than a
commercial application.
For warranty and non-warranty related issues, technical support, purchase replacement parts and warranty registration
visit
www.admiralcraft.com. Please have your model number, serial number and proof of purchase ready. It is not
necessary to contact the place where you originally purchased your product from.
“THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES EXPRESSED OR IMPLIED
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILTY OR FITNESS FOR PARTICULAR
PURPOSES AND CONSTITUES THE ENTIRE LIABILITY OF ACE. IN NO EVENT DOES THE LIMITED
WARRANTY EXTEND BEYOND THE TERMS STATED HEREIN.”
VER1212
Loading...