Adaptec HBA 1100-16i, HBA 1100-16e, HBA 1100-8i8e, HBA 1100-8i, HBA 1100-8e USER MANUAL

Microsemi Adaptec® HBA 1100 Series: 1100-24i/16i/16e/8i8e/8i/8e/4i

12 Gbps PCIe Gen3 SAS/SATA Host Bus Adapter

Smart Storage and Connectivity

Today’s data centers and enterprises need storage solutions that can
keep pace with their rapid data expansion. The HBA 1100 is a product
in the Smart Storage solutions family, forged through the convergence of
Microsemi's SAS/SATA protocol controller expertise, more than 30years
of Microsemi board innovation, and the new Smart Storage stack. The
HBA1100Series, available in five different configurations with up to
24internal SAS/SATA ports, offers a large number of density options
in a low-profile, MD2 form factor. It delivers the smart connectivity that
businesses are looking for, with high resiliency, low power, and the
performance required to unlock the capabilities of flash media.

Resiliency and Efficiency

The HBA 1100 delivers enterprise resiliency with its broadly deployed
Smart Storage stack. Based on the PM8222 8x12G SmartIOC 2100
SAS/SATA protocol controller, the HBA1100Series provides a robust
and stable solution that can handle the toughest system workloads and
configurations. It offers over 40 percent power savings compared to
previous generations, and significant power advantages versus competing
solutions. It is fully tools-compatible with existing and future Microsemi
HBA, RAID, and expander solutions.

Optimized for New Devices and New Use Cases

The HBA 1100 supports SMR HDDs and their specific command sets
(ZAC/ZBC for SAS/SATA SMR drives), enabling cost-efficient solutions for
warm and cold storage applications. It also supports the latest SAS and
SATA SSDs. The HBA1100 is also optimized for software-defined storage
solutions, such as Microsoft Storage Spaces Direct, VMWare vSAN, and
OpenStack Swift/Ceph.

Maximum Performance

The HBA 1100 Series provides the highest levels of storage performance
and scalability for next-generation data centers. Using the new SmartPQI
host OS device drivers that are optimized for low latency solid-state drives,
HBA 1100 adapters can aggregate the performance of devices to the limits
of the PCIe Gen3 host bus at 6.6 Gbps, and achieve up to 1.7M IOPS and
60percent higher IOPS performance with SATA devices without additional
overhead or latency.1 The HBA1100-24i, with 24internal ports, delivers the
lowest latency and highest performance when connected to SSDs, with no
need for expanders in most rack server applications.

Ease of Use

The HBA 1100, with its broad operating system support and ecosystem
compatibility, is easy to implement and scale, connecting up to 24 storage
devices. The unified maxView management tools and drivers across the
Microsemi HBA, RAID, and expander solutions enable easy manageability
across the entire product line.

Benefits

• A 4- to 24-port HBA family, ideal for server
solutions supporting SAS/SATA HDDs, tape
devices, and SSDs that require maximum
connectivity, bandwidth, and I/O performance

• Performance of up to 1.7M IOPS, low latency,
and low CPU utilization fully saturating the x8
PCIe Gen3 host bus

• Inbox drivers and broad operating system
support and device and platform capability
provides a single solution for servers, and all
device connectivity needs

Highlights

• Up to 24 native SAS/SATA ports; low-profile/
MD2 form factor

• 12 Gbps SAS data rates using mini-SAS HD
connectors

• Quality and reliability through the unified,
hardened Smart Storage stack, which is
deployed in over 30M servers

• Proven compatibility and seamless integration
with existing Microsemi Adaptec solutions that
leverage the unified maxView management
tool suite for remote and local setup and
maintenance

• Uses the latest 28nm SmartIOC 2100
SAS/SATA protocol controller to drive efficiency
and performance while also having the
industry's lowest power consumption

1

16- and 24-port adapters can achieve 1.7M random read IOPS for 4 KB I/Os. Adapters with 8 ports and fewer are
capable of 1.5M IOPS

Microsemi Adaptec® HBA 1100 Series: 1100-24i/16i/16e/8i8e/8i/8e/4i

12 Gbps PCIe Gen3 SAS/SATA Host Bus Adapter

Specifications

Parameter Description

• Support for up to 256 SAS/SATA target devices
(238SSD/HDDs maximum support and remainder are
reserved for expanders and enclosure management)

Key software features

• Multi-LUN support

• SAS expander support

• TLR

• SATA NCQ

• Hot plug drive support

maxView Storage Manager

• Web-based GUI management utility

• OS support: Windows, Linux, VMware

• Remote configuration, monitoring, and notification

Management utilities

• Remote firmware updates

• SMI-S support

• SMTP

ARCCONF

• Command-line interface

Microsoft Windows Server, Windows 10, Windows 8.1, Windows 7, Red Hat Enterprise Linux, CentOS, SuSE Linux

Operating systems

Enterprise Server, Ubuntu Linux, Debian Linux, Oracle Linux, Citrix XenServer, Solaris, FreeBSD, VMware ESXi, and open­source Linux drivers. The latest drivers and OS support are at storage.microsemi.com/en-us/support/start

CPU architecture Intel, AMD, Cavium ThunderX2

Physical dimensions

2.535" H × 6.6" L (64 mm × 167 mm) for all SKUs except the HBA 1100-4i, which is 2.535" H × 5.2" L
(64 mm × 132.08 mm)

0 °C to 55 °C with 200 LFM airflow.

Operating temperature

Note: This adapter contains a powerful I/O processor that requires adequate airflow to operate reliably. Please install this
card only into a server or PC chassis with at least 200 LFM airflow. Temperature measured 1 inch from adapter.

Regulatory certification CE, FCC, UL, C-tick, VCCI, KCC, and CNS

Environmental compliance RoHS

Warranty 3 years

Accessories Serial Attached SCSI (SAS) cables (www.microsemi.com/product-directory/storage-boards/3686-cables-accessories)

• S.M.A.R.T.

• MPIO support

• Multi-initiator (host)/clustering for SAS

• Enclosure management

• SES-2, SES-3

• SFF-8485, SGPIO

• SFF-8489, IBPI

• BMC support

BIOS Configuration Utility (CTRL+A)

• Legacy configuration utility

• Flashable BIOS support

ROM-based uEFI BIOS Configuration Utilities

• HII-based pre-boot GUI configuration utility

• Arcconf CLI for uEFI shell

• Flashable BIOS support

Ordering Information

Microsemi HBA 1100 Series Part Number Host Interface Form Factor Ports Connectors MTBF at 40 °C

HBA 1100-24i 2293800-R

HBA 1100-16i 2293500-R 16 internal 4 (×4) SFF-8643 2.73M hours

HBA 1100-16e 2293600-R 16 external 4 (×4) SFF-8644 2.0M hours

HBA 1100-8i8e 2293700-R

8-Lane PCIe Gen 3 Low-profile, MD2

HBA 1100-8i 2293200-R 8 internal 2 (×4) SFF-8643 1.36M hours

HBA 1100-8e 2293300-R 8 external 2 (×4) SFF-8644 1.38M hours

HBA 1100-4i 2293400-R 4 internal 1 (×4) SFF-8643 >1.4M hours

Microsemi, a wholly owned subsidiary of Microchip Technology Inc. (Nasdaq: MCHP), offers a comprehensive portfolio of semiconductor
and system solutions for aerospace & defense, communications, data center and industrial markets. Products include high-performance
and radiation-hardened analog mixed-signal integrated circuits, FPGAs, SoCs and ASICs; power management products; timing and
synchronization devices and precise time solutions, setting the world's standard for time; voice processing devices; RF solutions; discrete
components; enterprise storage and communication solutions, security technologies and scalable anti-tamper products; Ethernet solutions;
Power-over-Ethernet ICs and midspans; as well as custom design capabilities and services. Learn more at www.microsemi.com.

Microsemi Headquarters

One Enterprise, Aliso Viejo, CA 92656 USA

Within the USA: [phone]

Outside the USA: [phone]

Sales: [phone]

Fax: [phone]

email: [e-mail]

www.microsemi.com

Microsemi makes no warranty, representation, or guarantee regarding the information contained herein or the suitability of its products and services for any particular purpose,
nor does Microsemi assume any liability whatsoever arising out of the application or use of any product or circuit. The products sold hereunder and any other products sold
by Microsemi have been subject to limited testing and should not be used in conjunction with mission-critical equipment or applications. Any performance specifications are
believed to be reliable but are not verified, and Buyer must conduct and complete all performance and other testing of the products, alone and together with, or installed in, any
end-products. Buyer shall not rely on any data and performance specifications or parameters provided by Microsemi. It is the Buyer’s responsibility to independently determine
suitability of any products and to test and verify the same. The information provided by Microsemi hereunder is provided “as is, where is” and with all faults, and the entire
risk associated with such information is entirely with the Buyer. Microsemi does not grant, explicitly or implicitly, to any party any patent rights, licenses, or any other IP rights,
whether with regard to such information itself or anything described by such information. Information provided in this document is proprietary to Microsemi, and Microsemi
reserves the right to make any changes to the information in this document or to any products and services at any time without notice.

©2018 Microsemi, a wholly owned subsidiary of Microchip Technology Inc. All rights reserved. Microsemi and the Microsemi logo are registered trademarks of Microsemi
Corporation. All other trademarks and service marks are the property of their respective owners. 

24 internal 6 (×4) SFF-8643 2.73M hours

8 internal
8 externa

2 (×4) SFF-8643
2 (×4) SFF-8644

2.0M hours

ESC-2161189. 4.01. 6/18

Mouser Electronics

Authorized Distributor

Click to View Pricing, Inventory, Delivery & Lifecycle Information:

Microsemi:
2293300-R 2293400-R 2293800-R 2293500-R 2293200-R 2293700-R 2293600-R