AcuRite 00782 Instruction Manual
Instruction Manual
Wireless Weather Thermometer
model 00782
Congratulations on your new AcuRite product. To ensure the best possible product
performance, please read this manual in its entirety and retain it for future reference.
Features & Benets
1 2 3
DISPLAY UNIT
I
•
ACU>l:!ITE.
1. Current Indoor Temperature
2. Current Outdoor Temperature
OUTDOOR SENSOR
.AC",U>RITE.
3. Wireless Signal Indicator
Flashes when data is being sent to the
display unit.
Install or Replace Batteries
AcuRite recommends high quality alkaline batteries
for the best product performance. Heavy duty or
rechargeable batteries are not recommended.
The outdoor sensor requires lithium batteries in low
temperature conditions. Cold temperatures can
cause alkaline batteries to function improperly.
Use lithium batteries in the outdoor sensor for
temperatures below -4˚F.
Slide off the battery compartment cover on the
back of each unit. Insert 2 x AAA batteries into
the display rst, then the outdoor sensor next. Follow the polarity (+/−) diagram in the
battery compartment. Replace battery cover.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS. BATTERY SAFETY:
Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly.
Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals. Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste.
u
•
•
..
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Placement
The display unit can be wall-mounted using the integrated hang-hole, or it can be
placed on a desk or table using the fold-out stand. The outdoor sensor can also be wallmounted.
The outdoor sensor is weather resistant. Keep out of direct sunlight and direct weather
elements to extend the life of the unit. Also, when selecting a location for the display
unit, make sure it is within 100 feet (33 meters) of the outdoor sensor. The range may
be affected by electronic interference from devices such as televisions and computers.
For the best results, keep both units at least 3 feet (0.9 meters) away from any electrical
equipment or devices that may cause electronic interference.
....
'o''
....
- -
/ I \ '
TV
-
AT
LEAST
: I I
3
(0.9 m)
feet
[l
IN OUT
lll6ri
-
]
APART
I
(100 feet maximum)
(33 meters)
Specications
TEMPERATURE RANGE
WIRELESS RANGE
OPERATING FREQUENCY
POWER
DATA REPORTING
Outdoor: -40°F to 158°F
Indoor: 32˚F to 122˚F
100ft / 33 m depending on home construction
materials
433 MHz
Display: 2 x AAA alkaline batteries
Sensor: 2 x AAA alkaline or lithium batteries
60 second updates
FCC Information
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip
ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modications to this equipment.
Such modications could void the user authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.
-
Loading...