AcuRite 00603 User guide
Instruction Manual
Digital Window Thermometer
model 00603
Congratulations on your new AcuRite product. To ensure the best possible product
performance, please read this manual in its entirety and retain it for future reference.
Unpacking Instructions
Remove the protective lm that is applied to the screen prior to using this product. Peel
off to remove.
1
1
2
3
Power On / Replace Battery
A CR2032 "coin-style" lithium battery is included and pre-installed. A protective strip
that prevents the battery from draining during shipping must be removed from the
battery compartment before you can begin using your digital window thermometer.
1. Remove the two small Phillips type screws with a small Phillips screwdriver.
2. Remove the battery compartment cover carefully as to not lose the screws.
3. Remove the small plastic tab from the battery compartment (initial setup only). To
replace battery, remove and safely discard the old battery (see disposal safety
info below). Insert a new CR2032 battery, paying close attention to the polarity
markings.
4. Replace the battery compartment cover and screws, making sure the battery is still
installed correctly.
Features & Benets
1. Suction Cup Mount
Easily mounted on a window.
2. MIN/MAX
Minimum/maximum temperature
recorded over the past 24 hours.
3. Current Temperature
Displayed in degrees Fahrenheit.
WARNING: THIS PRODUCT CONTAINS A BUTTON-CELL BATTERY. IF SWALLOWED, IT~
COULD CAUSE SEVERE INJURY OR DEATH IN JUST 2 HOURS.
SEEK MEDICAL ATTENTION IMMEDIATELY IF INGESTED.
]r.
~
POISON
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY
SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device.
used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/
standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals. Battery contains
mercury. Do not put in trash. Recycle or manage as hazardous waste.
Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Placement
ROTATE SUCTION CUPS
OUTDOOR
TEMPERATURE READING
TEMPERATURE READING
AcuRite products are sensitive to surrounding environmental conditions. Placement
in a proper location is critical to the accuracy of this product. To ensure accurate
temperature measurement, place out of direct sunlight and away from heat sources.
Window Mount
Clean the area where the suction cups will be adhered to with a household window
cleaner. Be sure window is free of oil, grease, dust or other matter. Moisten the suction
cups. To mount, push rmly on the thermometer, pressing it against the window to form
a strong suction. For best suction, select surface that is hard, smooth and non-porous.
Do not use suction cups on wood or plaster.
FOR OUTDOOR TEMPERATURE
READING PLACEMENT
PLACE INSIDE PLACE OUTSIDE
WINDOW FOR INDOOR
WINDOW FOR
MIN/MAX Reset
The MIN/MAX temperature readings will reset every 24 hours. The reset time is
based on when the thermometer was powered on. For example, if you power on the
thermometer at 4:30 PM on Monday, the MIN/MAX readings will be reset at 4:30 PM
Tuesday (24 hours later).
Troubleshooting
Problem Possible Solution
Unable to read
thermometer at night
We recommend placing a piece of white paper on the back
of the thermometer. It will not affect the accuracy of ther unit.
Specications
TEMPERATURE RANGE
POWER
-4°F to 158°F
1 x CR2032 (included)
Loading...