ABUS SE1001, SE1000 Service Manual

Surface Mount Key-Switch

Art. no. SE1000

Arm and disarm by turning the key

•
For surface mounting

•
High security with pull protection and ceiling and wall tamper switches

•
Sturdy housing

•

Page 1 of 1

Use the surface mount key-switch to arm and disarm your alarm system. Simply turn the key instead of entering
a PIN code. Operating your system is faster and easier. Apart from the arm/disarm function of the alarm system
(or individual partitions), you can use the surface mount key-switch to control electronic equipment (entrance
lighting, garage door, etc.). Two switch contacts are provided. You can set these as a permanent contact or as a
pulse generator. The two colored LEDs permanently inform you about the state of connected devices. For
example, you can see if the system is currently armed or disarmed. The reinforced fascia plate, the high-quality
ABUS cylinder and a robust weatherproof housing (IP 55) protect the key-switch against external influences. The
surface mount key-switch is designed for half-cylinders (10/30). It is available for both surface and flush fitting.
The surface-fitted variant is protected from tampering by a cover contact and an anti-removal wall contact.

Technical Data:

Dimensions (WxHxD) 114x85x42 mm
Width 114 mm
Housing material ABS
Height 85 mm
Length 42 mm
Power consumption 0,02 W

Installation location Surface fitting
Tamper monitoring Yes
IP protection class 55
DC voltage supply 10-15 V
Status display Yes (2 LEDs)
Power consumption 2 mA

Powered by TCPDF (www.tcpdf.org)

Technical alterations reserved. Misprints and errors excepted. Copyright. © ABUS 02/2020