ABC Office IDEAL 1038, IDEAL 1110, IDEAL 1058, IDEAL 1080, 1071 User Manual

1

“When You Need More Than Staples.”

Toll Free: 800-658-8788

Fax: [phone]

[e-mail]

IDEAL CUTTERS
Model 1038 Model 1058
Model 1071 Model 1080

Model 1110

1. Knife guard

2. Manual clamp

3. Knife carrier

4. Front gauge with narrow -strip-cutting
device

5. Paper supports

6. Back gauge

7. Side lay with cm / inch scale

8. Rotary knob for adjustment of front
gauge

9. Locking screw for front gauge

10. Collapsible extension table

11. Foot clamp

2

Safety Regulations

IDEAL Trimmers comply with international safety regulations and are safety-tested.

All trimmers are provided with approved safety guards (#1). For a safe operation of the trimmers
it is important, that the knife guard is not taken off.

The knife carrier (#3) is fitted with a friction device. If adjusted correctly, this friction device
insures, that the knife carrier (#3) with the knife cannot move down on its own from any position.

If the blade and blade carrier fall by themselves the friction device must be adjusted as follows:

For the m odel 1038 loosen the set screw (I). Tighten the lock nut (II) and retighten the set screw
(I). For modes l1058, 1071, 1081 and 1110, tighten the lock nut (III). While holding the lock nut
(III) in place with a second crescent wrench, tighten the lock nut (IV).

Installation:

The models IDEAL 1038 and IDEAL 1058 do not need any assembly. On models IDEAL 0171,
1080 and 1110 the clamp with the attached knife guard has been taken off for shipping.

For re-assembling proceed as follows: