Network Video Recorder
N V R - CV
NVR-CV
Network Video Recorder
Hot-Swappable Tray for
3.5” HDD x 4 or 2.5” HDD x 4
Gigabit Ethernet x 2
COM x 2, USB2.0 x 6
VGA x 1, DVI-D x 1
NVR-CV Manual 1st Ed.
Oct. 2013
Network Video Recorder NVR-CV
Copyright Notice
This document is copyrighted, 2013. All rights are reserved. The
original manufacturer reserves the right to make improvements to the
products described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated, or
transmitted in any form or by any means without the prior written
permission of the original manufacturer. Information provided in this
manual is intended to be accurate and reliable. However, the original
manufacturer assumes no responsibility for its use, or for any infringements upon the rights of third parties that may result from its
use.
The material in this document is for product information only and is
subject to change without notice. While reasonable efforts have been
made in the preparation of this document to assure its accuracy,
AAEON assumes no liabilities resulting from errors or omissions in
this document, or from the use of the information contained herein.
AAEON reserves the right to make changes in the product design
without notice to its users.
i
Network Video Recorder NVR-CV
Acknowledgments
All other products’ name or trademarks are properties of their
respective owners.
AMI is a trademark of American Megatrends Inc.
CompactFlash™ is a trademark of the Compact Flash
Association.
Intel
Microsoft Windows
ITE is a trademark of Integrated Technology Express, Inc.
IBM, PC/AT, PS/2, and VGA are trademarks of International
SoundBlaster is a trademark of Creative Labs, Inc.
All other product names or trademarks are properties of their
respective owners.
®
is a trademark of Intel® Corporation.
®
is a registered trademark of Microsoft Corp.
Business Machines Corporation.
ii
Network Video Recorder NVR-CV
Packing List
Before you begin installing your card, please make sure that the
following materials have been shipped:
1 CD-ROM for Manual (in PDF Format) and Drivers
1 NVR-CV
If any of these items should be missing or damaged, please
contact your distributor or sales representative immediately.
iii
Network Video Recorder NVR-CV
Contents
Chapter 1 General Information
1.1 Introduction................................................................ 1-2
1.2 Features....................................................................1-3
1.3 Specifications............................................................1-4
Chapter 2 Hardware Installation
2.1 Mechanical Drawing.................................................. 2-2
2.2 Installing the 3.5” Hard Disk Drive............................. 2-3
Chapter 3 Driver Installation
3.1 Installation................................................................. 3-3
Chapter 4 I/O Information
4.1 I/O Address Map .......................................................4-2
st
4.2 1
MB Memory Address Map....................................4-4
4.3 IRQ Mapping Chart ................................................... 4-5
4.4 DMA Channel Assignments...................................... 4-7
iv
Network Video Recorder
N V R - CV
Chapter
1
General
Information
Chapter 1 General Information 1- 1
Network Video Recorder
N V R - CV
1.1 Introduction
NVR-CV adopts the Intel® AtomTM D2550 Dual Core Processor and
equips with Intel® ICH10R chipset. Moreover, the system memory
features two 204-pin Single Channel DDR3 1066/800 non-ECC,
un-buffered DIMM memory up to 4GB. It deploys two LAN ports
that consist of 10/100/1000Base-TX Ethernet RJ-45 ports.
NVR-CV features desktop form factor for network video recorder
applications.
This NVR-CV supports up to four 3.5” Hard Disk Drive or four 2.5”
SATA swappable HDD. Moreover, the flexible expansion interface
features one PCI-E[x4] slot. In addition, this model supports two
COM ports, and six USB2.0 ports ( two USB2.0 ports on the ear
and four USB2.0 ports on the rear.) Furthermore, the NVR-CV can
support dual displays with one VGA and one DVI-D.
Chapter 1 General Information 1- 2
Network Video Recorder
N V R - CV
1.2 Features
Intel® Atom™D2550 Dual Core Processor
Intel® ICH10R Chipset
204-pin Single Channel DDR3 1066/800 Non-ECC,
Un-buffered DIMM Memory Up To 4GB
10/100/1000Base-TX Ethernet x 2
Hot-Swappable Tray for 3.5” HDD x 4 or 2.5” HDD x 4
COM x 2
USB2.0 x 6
VGA x 1,DVI-D x 1
Audio Line-out, Line-in, Mic-in
RAID 0/1/5/10 support
Supports Linux OS and Windows® XP embedded
Standard (optional)
Chapter 1 General Information 1- 3
Network Video Recorder
N V R - CV
CPU
Intel® Atom™ D2550 Dual Core
Processor, 1.83 GHz
Chipset
Intel® ICH10R
System Memory
204-pin Single Channel DDR3
1066/800 Non-ECC, Un-buffered
Memory, support up to 4G
LCD/CRT Controller
Intel® ICH10R
Ethernet
Realtek 8111E for
10/100/1000Base-TX, RJ-45 x 2
BIOS
AMI Plug & Play BIOS – 32MB SPI
Serial ATA
SATA x 6
Wake on LAN
No
Hardware Status
Monitoring
Supports Power Supply Voltage,
Fan Speed and Temperature
Monitoring
Expansion Interface
PCI-E[x4] x 1
Watchdog Timer
Programmable 1~255 steps
System Reset
Storage
Supports 3.5” or 2.5” removable
SATA HDD tray x 4
Front I/O Port
Power Button x 1
Reset Button x 1
Power & HDD LED
USB2.0 x 2
Rear I/O Port
VGA x 1
DVI-D x 1
RJ-45 x 2
USB2.0 x 4
Audio Jack x 3
RAID Support
0/1/5/10
1.3 Specifications
System
Chapter 1 General Information 1- 4
Network Video Recorder
N V R - CV
Dimension
7.87” x 9.84” x 11.93” (200mm x
250mm x 303mm)
Gross Weight
17.6 lb (8 Kg)
Net Weight
15.4 lb (7 Kg)
Operating Temperature
32°F ~ 104°F (0°C ~ 40°C)
Storage Temperature
-4°F ~ 140°F (-20°C ~ 60°C)
Storage Humidity
10%~80% @40°C;
non-condensing
Vibration
0.5 g rms/ 5~500Hz/ operation
(2.5” HDD)
1.5 g rms/ 5~500Hz/ non-operation
Shock
10 G peak acceleration (11 m sec.
duration) operation
20 G peak acceleration (11 m sec.
duration) non-operation
DC Output
200W
AC Input Voltage Range
100~240VAC, 47~63HZ, 3.5A
Mechanical
Environmental
Power Supply
Chapter 1 General Information 1- 5
Network Video Recorder NVR-CV
Chapter
2
Hardware
Inst
Chapter 2 Hardware Installation 2-1
allation
Network Video Recorder NVR-CV
2.1 Mechanical Drawing
Chapter 2 Hardware Installation 2-2
Network Video Recorder NVR-CV
2.2 Installing the 3.5” Hard Disk Drive
Step 1: Press HDD to the right to remove the HDD tray
Chapter 2 Hardware Installation 2-3
Network Video Recorder NVR-CV
Step 2: Put the HDD to the HDD bracket (tray)
Chapter 2 Hardware Installation 2-4
Network Video Recorder NVR-CV
Step 3: Fasten the HDD on the bottom bracket with three screws
Step 4: Insert the HDD tray back to the chassis
Chapter 2 Hardware Installation 2-5
Network Video Recorder NVR-CV
Step 5: Push the HDD tray to the cha
ssis until it has been firmly
locked
Chapter 2 Hardware Installation 2-6
Network Video Recorder
N V R - CV
Chapter
3
Driver
Installation
Chapter 3 Driver Installation 3-1
Network Video Recorder
N V R - CV
The NVR-CV comes with an AutoRun CD-ROM that contains all
drivers and utilities that can help you to install the driver
automatically.
Insert the driver CD, the driver CD-title will auto start and show the
installation guide. If not, please follow the sequence below to install
the drivers.
Follow the sequence below to install the drivers:
Step 1 – Install Chipset Driver
Step 2 – Install VGA Driver
Step 3 – Install LAN Driver
Step 4 – Install Audio Driver
Step 5 – Install AHCI Driver
Step 6 – Install Serial Port Driver (Optional)
Please read instructions below for further detailed installations.
Chapter 3 Driver Installation 3-2
Network Video Recorder
N V R - CV
3.1 Installation
Insert the NVR-CV CD-ROM into the CD -ROM drive and install the
drivers from Step 1 to Step 6 in order.
Step 1 – Install Chipset Driver
1. Click on the Step 1 - INF folder and double click on the
infinst_autol file
2. Follow the instructions that the window shows
3. The system will help you install the driver automatically
Step 2 – Install VGA Driver
1. Click on the Step 2 - VGA folder and select the OS folder
your system is
2. Double click on the .exe file located in each OS folder
3. Follow the instructions that the window shows
4. The system will help you install the driver automatically
Note: User has to install dotetfx35.exe before installing Windows
®
XP graphic driver
Step 3 – Install LAN Driver
1. Click on the Step 3 - LAN folder and select the OS folder
your system is
2. Double click on the setup.exe file located in each OS
folder
3. Follow the instructions that the window shows
4. The system will help you install the driver automatically
Step 4 – Install Audio Driver
Chapter 3 Driver Installation 3-3
Network Video Recorder
N V R - CV
1. Click on the Step 4 - AUDIO folder and double click on
the SETUP.exe file
2. Follow the instructions that the window shows
3. The system will help you install the driver automatically
Step 5 – Install AHCI Driver
1. Click on the Step 5 - AHCI folder and select the folder of
AP
2. Double click on the iata_cd.exe file
3. Follow the instructions that the window shows
4. The system will help you install the driver automatically
Step 6 – Install Serial Port Driver (Optional)
1. Click on the Step 6 - Serial Port Driver (Optional) and
double click on the patch.bat file
2. Follow the instructions that the window shows
3. The system will help you install the driver automatically
Chapter 3 Driver Installation 3-4
Network Video Recorder NVR-CV
Chapter
4
I/O Information
Chapter 4 I/O Information 4-1
Network Video Recorder NVR-CV
4.1 I/O Address Map
Chapter 4 I/O Information 4-2
Network Video Recorder NVR-CV
Chapter 4 I/O Information 4-3
Network Video Recorder NVR-CV
st
4.2 1
MB Memory Address Map
Chapter 4 I/O Information 4-4
Network Video Recorder NVR-CV
4.3 IRQ Mapping Chart
Chapter 4 I/O Information 4-5
Network Video Recorder NVR-CV
Chapter 4 I/O Information 4-6
Network Video Recorder NVR-CV
4.4 DMA Channel Assignments
Chapter 4 I/O Information 4-7
Loading...